Maintenance and Technical Data -> Vehicle Care for Your Aston Martin Dbx SUV 2020

Vehicle Care  
Lamps  
Washing  
External Lamps  
Warning: Washing and polishing agents containing  
All external lamps use LEDs and are contained in a sealed lamp silicone should not be applied to glass. This will reduce the  
units.  
efficiency of the windscreen wipers, causing smears which  
will reduce visibility, particularly during darkness and in the  
rain.  
The lamp units are not repairable. If a lamp or lamp unit fails  
contact your Aston Martin Dealer.  
Internal Lamps  
Caution: Commercially operated automatic vehicle  
washes, jet washes and power operated mops are not  
recommended. The detergents used can contain certain  
chemicals which may, over time, be detrimental to some  
exterior parts of the vehicle. Prolonged usage of automatic  
vehicle washes and power operated mops will also cause fine  
scratches in the paint surface.  
All internal lamps are LEDs and are not repairable.  
If an LED lamp fails contact your Aston Martin Dealer.  
Aston Martin are able to supply a range of products to clean and  
protect your vehicle. Contact you Aston Martin Dealer for further  
information.  
During the winter months, it is advisable to wash the vehicle  
more frequently, paying particular attention to the underside to  
combat the detrimental effects of any salt and sand  
contamination picked up from treated roads.  
To delay the onset of corrosion developing on the brake  
components, Aston Martin recommend that after washing this  
vehicle, the vehicle should be driven a short distance to make  
sure that all water and cleaning products have dried off.  
11.40 Maintenance and Technical Data  
For best results:  
Paint Work  
• Do not wash the vehicle in strong sunlight. Let the vehicle  
cool before washing.  
• Do not use household soaps or detergents.  
• Do not direct water hoses at full force around the door and  
trunk lid seals.  
Modern water based paints are much safer and more  
environmentally friendly than solvent based paints. Water based  
paints are however more susceptible to contamination and  
marking by corrosive substances. The following list is not  
exhaustive but does show the most common contaminants which  
may adversely affect your paint work:  
• Do not use a brush on the car body as this will leave little  
scratches.  
• Bird droppings,  
• Antifreeze,  
Suggested washing method:  
• Tree sap,  
• Oils and greases,  
• Insect remains.  
1. Fill two buckets with water. Add a mild neutral detergent, as  
directed by the detergent manufacturer to one of the  
buckets.  
Wash such substances from the vehicle using clean warm water  
with vehicle shampoo at the earliest opportunity, especially in  
sunny weather which can accelerate contamination.  
2. Use a hose to remove all dust and mud residue from the  
vehicle. Don't use a strong jet, as this can rub grit over the  
paint and scratch it.  
3. Soak a large clean wash mitt or a soft clean sponge in the  
soapy water, and begin applying it to the vehicle. Wash the  
vehicle section by section, starting at the top. Circle around  
the car several times, washing lower areas with each round.  
Rinse the dirt out of the wash mitt or soft sponge in the  
bucket with plain water frequently.  
4. After one section is washed, rinse it with the hose before  
moving on, don't let the soap dry on the paint as this can  
stain it. Always keep the vehicle wet, this will prevent  
droplets from drying on the paint and leaving water-spots.  
5. Dry the car with a chamois leather before it air-dries.  
Other groups of contaminants may be added to this list as  
experience of water based paints and finishes increases.  
Satin Paint  
(Optional)  
The Aston Martin new car warranty covers defects in  
materials or workmanship of the paint work. The warranty  
does NOT cover repairs to your satin or matt paint work  
caused by negligence, lack of or improper maintenance such  
as waxing or polishing the finish, environmental influences,  
or improper repairs or damage that causes the satin finish to  
become glossy.  
Maintenance and Technical Data 11.41  
In comparison to conventional paints with a gloss or metallic  
surface, satin paint work must be cared for slightly differently. In  
order to avoid damage to the satin paint work, make sure that the  
cleaning and care points below are followed:  
Off-Road Use  
If this vehicle has been used to drive in off road environments  
additional cleaning may be required, such as under the body to  
make sure all mud, salt and other contaminants are removed.  
1. Only use cleaning products recommended by Aston Martin. This will help protect the vehicle paintwork, under-body and  
Abrasive cleaning products will change the satin appearance external components such as the parking sensors and trailer  
of the paint and must not be used.  
electrical connection points.  
2. Do not polish or wax the paintwork. This can lead to  
glossing of the paintwork.  
3. Do not wash the car in an automatic car wash. This will  
avoid particles such as sand and dust, from damaging the  
painted surface.  
4. Only use a soft sponge to clean the vehicle. Do not use  
abrasive cleaning tools.  
5. Remove insect remains, bird droppings, resins, tar spots,  
fuels and oil immediately. Avoid strong rubbing while  
cleaning the vehicle.  
Alternator  
Caution: Do not use a high pressure stream such as a  
pressure washer to rinse the alternator. This can cause  
internal damage to the alternator.  
If the alternator is submerged in muddy water, it should be rinsed  
with a hose or similar to remove any mud. Mud and salt residue  
can corrode and damage the internal windings. The vehicle  
should then be driven to dry the alternator.  
Underbody Protection  
The underbody of this vehicle is protected with sacrificial  
protective panels. Consult your dealer for inspection and repair  
as necessary, especially after sustained off-road use or if the  
underside of the vehicle been damaged.  
6. Any stickers applied to the paint work will leave a mark  
when removed.  
7. Repairs to the paint work must be completed by an Aston  
Martin category A or B body shop.  
11.42 Maintenance and Technical Data  
Road Wheels  
Headlamp Lenses  
To avoid possible damage to the alloy road wheels, wheel nuts Only use a mild soapy water solution when washing the  
and wheel centre trims, from a build up of brake dust wash and headlamp lenses. Do not use cleaning materials which contain  
clean the alloy road wheels frequently, using a mild soapy water solvents.  
solution only. Do not use chemical alloy road wheel cleaners, as  
they can often have a high acid or alkaline content and could  
cause discolouration. Always clean one wheel at a time and do  
not allow the cleaning solution to dry on the wheel. Fully flush off  
with clean water.  
Cleaning materials which contain solvents, i.e. tar remover,  
petrol, waxes or polishes, may damage the headlamp lens.  
Under Hood Cleaning  
Under hood cleaning using high pressure hoses or steam cleaners  
should not be carried out. The electronic control module  
connections and fuse boxes can be damaged by indiscriminate  
use of high pressure cleaning equipment.  
Polishing  
Approximately twice a year, a good quality polish should be  
applied to the body work and then buffed, using a soft lint free  
cloth.  
The alloy wheel rims should be treated with a cleaner which is  
specifically manufactured for this purpose.  
Bodywork Maintenance  
Check the drain holes in the bottom face of each door  
periodically and clear if necessary.  
Maintenance and Technical Data 11.43  
Upholstery, Trim, Carpets and Seats  
Alcantara®1 roof linings and other soft trimmed areas may be  
brushed with a soft brush. Stains from water based substances  
such as coffee, tea or soft drinks should be cleaned as soon as  
possible with mild soap and water.  
Warning: Fumes from cleaning solvents may be  
dangerous in confined spaces. Make sure that the vehicle is  
well ventilated and follow the manufacturer’s printed  
instructions when using these products.  
Consult your Aston Martin Dealer for instructions on the removal  
of more difficult stains such as oil, grease or ballpoint ink.  
Caution: Certain types of clothing, such as denim and  
vegetable tanned leather, are prone to ‘dye transfer’. This can  
cause discolouration in the leather. Make sure that the  
affected areas are cleaned and re-protected as soon as  
possible.  
Carpets should be cleaned regularly with a vacuum cleaner. Any  
stains or grease marks should be removed with a good quality  
solvent suitable for use on carpets.  
Care and Maintenance of Seat Belts  
Caution: Do not allow seat belts to be retracted until they  
are completely dry.  
The seats and soft trimmed components of this vehicle are  
covered in natural leather hide. In general, this natural leather  
upholstery requires little attention. The seats should be brushed  
with a soft brush from time to time and may be cleaned  
occasionally with a cloth damped in soap and water.  
To make sure that the restraint webbings are in correct working  
order, regularly check the seat belts. Look for fraying, cuts, burns  
and similar problems. Make sure that the latches and buckles  
operate correctly. If a seat belt is not in good condition or is not  
working correctly, consult your Aston Martin Dealer.  
Do not use detergents, quick cleansers or furniture polishes.  
These products may initially give an impressive result, but their  
use will lead to rapid deterioration of the leather and will  
invalidate the warranty.  
Any seat belt that has been worn during a serious collision should  
be replaced by an Aston Martin Dealer.  
Several times a year, a leather conditioner or preservative should  
be used. Appropriate care materials are obtainable from your  
Aston Martin Dealer.  
To clean the seat belts, use mild soap and water; do not use  
bleach, solvents or dyes, as they can weaken the material. Allow  
the seat belts to dry thoroughly before use.  
Use a soft microfibre cloth to remove dust and loose dirt from  
open pore wood trim panels.  
Alcantara is the registered trademark of Alcantara SPA, Italy and used  
1.  
with permission  
11.44 Maintenance and Technical Data