Instruments and Controls -> Vehicle Messages for Your Chevrolet Silverado 1500 Light Truck 2023

134  
Instruments and Controls  
.
.
.
.
.
.
.
.
.
.
.
.
Steering  
Audio overlays display when the audio app  
is selected on the instrument cluster. All  
HUD views may briefly display audio  
information when the driver uses the  
steering wheel controls to adjust the audio  
settings appearing in the instrument cluster.  
The windshield is part of the HUD system.  
See Windshield Replacement 0 356.  
Ride Control Systems  
Driver Assistance Systems  
Cruise Control  
Lighting and Bulb Replacement  
Wiper/Washer Systems  
Doors and Windows  
Seat Belts  
Airbag Systems  
Engine and Transmission  
Tire Pressure  
Vehicle Messages  
Messages displayed on the Driver  
Information Center (DIC) indicate the status  
of the vehicle or some action that may be  
needed to correct a condition. Multiple  
messages may appear one after another.  
Incoming phone calls appearing in the  
instrument cluster, may also display in any  
HUD view.  
Care of the HUD  
The messages that do not require  
immediate action can be acknowledged and  
cleared by pressing the thumbwheel. The  
messages that require immediate action  
cannot be cleared until that action is  
performed.  
Clean the inside of the windshield to remove  
any dirt or film that could reduce the  
sharpness or clarity of the HUD image.  
Battery  
Engine Power Messages  
Clean the HUD lens with a soft cloth  
sprayed with glass cleaner. Wipe the lens  
gently, then dry it.  
REDUCED ACCELERATION DRIVE  
WITH CARE  
All messages should be taken seriously;  
clearing the message does not correct the  
problem.  
HUD Troubleshooting  
This message displays when the vehicle's  
propulsion power is reduced. A reduction in  
propulsion power can affect the vehicle's  
ability to accelerate. If this message is on,  
but there is no observed reduction in  
performance, proceed to your destination.  
Under certain conditions the performance  
may be reduced the next time the vehicle is  
driven. The vehicle may be driven while this  
message is on, but maximum acceleration  
and speed may be reduced. Anytime this  
Check that:  
If a SERVICE message appears, see your  
dealer.  
.
Nothing is covering the HUD lens.  
.
The HUD brightness setting is not too  
dim or too bright.  
Follow the instructions given in the  
messages. The system displays messages  
regarding the following topics:  
.
.
.
The HUD is adjusted to the proper height.  
Polarized sunglasses are not worn.  
The windshield and HUD lens are clean.  
.
Service Messages  
.
Fluid Levels  
.
.
Vehicle Security  
Brakes  
If the HUD image is not correct, contact  
your dealer.  
Instruments and Controls  
135  
message stays on, or displays repeatedly,  
the vehicle should be taken to your dealer  
for service as soon as possible.  
Keep the original hand-held transmitter for  
use in other vehicles as well as for future  
programming. Erase the programming when  
vehicle ownership is terminated. See  
Erasing Universal Remote System Buttons”  
later in this section.  
Universal Remote System  
Programming  
Under certain operating conditions,  
propulsion will be disabled. Try restarting  
after the ignition has been off for  
two minutes.  
To program a garage door opener, park  
outside directly in line with and facing the  
garage door opener receiver. Clear all people  
and objects near the garage door.  
Vehicle Speed Messages  
SPEED LIMITED TO XXX KM/H (MPH)  
Make sure the hand-held transmitter has a  
new battery for quick and accurate  
transmission of the radio-frequency signal.  
This message shows that the vehicle speed  
has been limited to the speed displayed. The  
limited speed is a protection for various  
propulsion and vehicle systems, such as  
lubrication, thermal, brakes, suspension,  
Teen Driver if equipped, or tires.  
Programming the Universal Remote  
System  
If equipped, these buttons are in the  
overhead console.  
Programming involves time-sensitive actions  
and may time out, requiring the procedure  
to be repeated. Read these instructions  
completely before programming the  
Universal Remote system. It may help to  
have another person assist with the  
programming process.  
(If equipped with a diesel engine, see the  
Duramax Diesel supplement.) For Diesel  
This system can replace up to three remote  
control transmitters used to activate devices  
such as garage door openers, security  
systems, and home automation devices.  
These instructions refer to a garage door  
opener, but can be used for other devices.  
Universal Remote System  
See Radio Frequency Statement 0 438.  
1. Hold the end of the hand-held  
Do not use the Universal Remote system  
with any garage door opener that does not  
have the stop and reverse feature. This  
includes any garage door opener model  
manufactured before April 1, 1982.  
transmitter about 3 to 8 cm (1 to 3 in)  
away from the Universal Remote system  
buttons with the indicator light in view.