Lighting and visibility
This indicator lamp goes off in the
instrument panel, accompanied by
a message.
F Clean the windscreen using screenwash
Automatic windscreen
wipers
fluid.
Do not apply "Rain X" type water-repellent
products.
The windscreen wipers operate automatically,
adapting their speed to the intensity of the
rainfall without any action on the part of the
driver.
Detection of rainfall is by means of a sensor at
the top centre of the windscreen, behind the
rear view mirror.
The automatic windscreen wipers must be
reactivated by pushing the control stalk
downwards, if the ignition has been off for
more than one minute.
F Unclip the worn wiper blade closest to you
and remove it.
F Install the new wiper blade and clip it to the
arm.
F Repeat the procedure for the other wiper
blade.
F Starting with the wiper blade closest to
you, once again hold each arm by the rigid
section, then fold it carefully, guiding it to
the windscreen.
Switching on
Malfunction
If a fault occurs with automatic wiping, the
wipers will operate in intermittent mode.
Have them checked by a CITROËN dealer or
a qualified workshop.
Removing/refitting at the rear
F Give the control stalk a brief push
downwards.
A wiping cycle confirms that the instruction has
been accepted.
F Hold the arm by the rigid section and raise it
as far as possible.
F Clean the rear window using screenwash
fluid.
Do not cover the rain sensor linked to the
sunshine sensor and located at the top
centre of the windscreen.
Switch off the automatic wipers when using
an automatic car wash.
In winter, it is advisable to wait until the
windscreen is completely clear of ice before
activating the automatic windscreen wipers.
This indicator lamp comes on in the
instrument panel, accompanied by
the display of a message.
F Unclip the worn wiper blade and remove it.
F Install the new wiper blade and clip it to the
arm.
F Once again hold the arm by the rigid section
then fold it carefully, guiding it to the rear
window.
Switching off
F Give the control stalk a further brief push
downwards or place the control stalk in
another position (Int, 1 or 2).
88
