In the event of a breakdown
F Remove the kit.
F Check that the compressor switch is in
position "O".
F Switch on the ignition.
F Remove and then store the bottle of sealant.
F Fully uncoil the electric cable, stowed under
the compressor.
F Connect the compressor's electric plug to
one of the vehicle's 12 V sockets.
Take care, the sealant product is harmful
if swallowed and causes irritation to the
eyes.
Keep this product out of the reach of
children.
F
Affix the speed limit sticker.
The use-by date of the fluid is marked on
the bottle.
After use, do not discard the bottle in
standard waste, take it to a CITROËN
dealer or an authorised waste disposal
site.
Do not forget to obtain a new bottle of
sealant, available from a CITROËN dealer
or a qualified workshop.
The speed limit sticker must be secured to
the interior of the vehicle in the area close
to the driver, to remind the driver that
a wheel is in temporary use.
F Start the compressor by turning the switch
to position "I" until the pressure of the tyre
reaches 2 bars. The sealant product is
injected under pressure into the tyre; do not
disconnect the pipe from the valve during
this operation (risk of blowback).
If a pressure of 2 bars is not reached after
about 7 minutes, this indicates that the
tyre is not repairable; contact a CITROËN
dealer or a qualified workshop for
assistance.
The tyre inflation pressures are given on
this label.
8
F Turn the switch to position "O".
F Disconnect the compressor's electric plug
from the vehicle's 12 V socket.
F Drive immediately for approximately 3 miles
(5 kilometres), at reduced speed (between
12 and 37 mph (20 and 60 km/h)), to plug
the puncture.
F Replace the cap on the valve.
201
