Lighting and visibility -> Toolkit for Your Citroen C5 SUV 2020

In the event of a breakdown  
Versions with a spare wheel  
HDi engines  
Access to the tool kit  
F Fill the fuel tank with at least 5 litres of  
Diesel.  
F Open the bonnet.  
F If necessary, unclip the cover to access the  
priming pump.  
F Loosen the degassing bolt.  
F Operate the priming pump until fuel appears  
in the transparent tube.  
F Retighten the degassing bolt.  
F Operate the starter until the engine starts (if  
the engine does not start at the first attempt,  
wait around 15 seconds before trying  
again).  
F If the engine does not start after a few  
attempts, operate the priming pump again  
then start the engine.  
The main tools are stowed in the boot, under  
the floor.  
For access to them:  
F Open the boot.  
F Place the adjustable boot floor in the high  
position.  
F unclip the storage box by pulling it up,  
F unclip the two fixings to open its cover.  
F Put the cover back in place, clip it and  
ensure it is clipped in.  
F Close the bonnet.  
All of these tools are specific to your  
vehicle and may vary depending on  
equipment.  
Versions with a temporary  
puncture repair kit  
Do not use them for any other purposes.  
Tool kit  
This is a set of tools provided with the vehicle.  
Its content depends on your vehicle's  
equipment:  
-
-
temporary puncture repair kit,  
spare wheel.  
F Unclip the two fixings to open its cover.  
198  
In the event of a breakdown  
For more information on Towing the vehicle  
and using the removable towing eye, refer to  
the corresponding section.  
With spare wheel  
The jack must only be used to change  
a wheel with a damaged or punctured tyre.  
Do not use any jack other than the one  
supplied with this vehicle.  
If the vehicle does not have its original  
jack, contact a CITROËN dealer or  
a qualified workshop to obtain the correct  
jack for it.  
With temporary puncture repair  
kit  
The jack meets European standards,  
as defined in the Machinery Directive  
2006/42/CE.  
The jack does not require any  
maintenance.  
5. Wheelbrace.  
For removing the wheel trim and removing  
the wheel fixing bolts.  
6. Jack with integrated handle.  
List of tools  
Used to raise the vehicle.  
7.  
Wheel bolt cover remover (depending on  
equipment).  
4. 12 V compressor with a cartridge of  
sealant and a speed limit sticker.  
For temporary repair of a tyre and to  
adjust the tyre pressure.  
For removing the wheel bolt head finishers  
on alloy wheels.  
For more information on the Spare wheel, refer  
to the corresponding section.  
For further information about the Temporary  
puncture repair kit, refer to the corresponding  
section.  
1. Chocks to immobilise the vehicle  
(depending on equipment).  
2. Socket for the security bolts (located in  
the glove box) (depending on equipment).  
For adapting the wheelbrace to the special  
"security" bolts.  
Temporary puncture  
repair kit  
8
3. Towing eye and tool to open the protective  
Scan the QR Code on page 3 to view  
explanatory videos.  
covers of the front and rear screw threads.  
199