Keys and Remote Controls -> Remote Control for Your Ford Ecosport SUV 2020

Keys and Remote Controls  
Note: Changes or modifications not  
PRINCIPLE OF OPERATION  
The remote control allows you to:  
expressively approved by the party  
responsible for compliance could void the  
user's authority to operate the equipment.  
The term IC before the radio certification  
number only signifies that Industry Canada  
technical specifications were met.  
Remotely lock or unlock the vehicle  
doors.  
Unlock the doors without actively using  
a key or remote control (intelligent  
access only).  
The typical operating range for your  
transmitter is approximately 32.8 ft (10 m).  
Activate the panic alarm.  
A decrease in operating range could be  
caused by:  
Car Finder  
weather conditions  
nearby radio towers  
structures around your vehicle  
Press the button twice within  
three seconds. The horn sounds  
and the direction indicators  
flash. We recommend you use this method  
to locate your vehicle, rather than using  
the panic alarm.  
other vehicles parked next to your  
vehicle.  
The radio frequency used by your remote  
control can also be used by other radio  
transmitters, for example amateur radios,  
medical equipment, wireless headphones,  
wireless remote controls, cell phones,  
battery chargers and alarm systems. If the  
frequencies are jammed, you will not be  
able to use your remote control. You can  
lock and unlock the doors with the key.  
Sounding the Panic Alarm  
Note: The panic alarm only operates when  
the ignition is off.  
Press the button to sound the  
panic alarm. Press the button  
again or switch the ignition on to  
turn it off.  
Note: Make sure your vehicle is locked  
before leaving it unattended.  
GENERAL INFORMATION ON  
RADIO FREQUENCIES  
Note: If you are in range, the remote control  
will operate if you press any button  
unintentionally.  
This device complies with Part 15 of the  
FCC Rules and with Industry Canada  
license-exempt RSS standard(s).  
Operation is subject to the following two  
conditions: (1) This device may not cause  
harmful interference, and (2) This device  
must accept any interference received,  
including interference that may cause  
undesired operation.  
Note: The remote control contains  
sensitive electrical components. Exposure  
to moisture or impact may cause permanent  
damage.  
REMOTE CONTROL  
Remote Control With a Folding Key  
Blade  
Use the key blade to start your vehicle and  
unlock or lock the driver door from outside  
your vehicle. The transmitter portion  
functions as the remote control.  
51  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing  
Keys and Remote Controls  
Replacing the Battery  
Note: Refer to local regulations when  
disposing of transmitter batteries. Note: Do  
not wipe off any grease on the battery  
terminals or on the back surface of the  
circuit board.  
Note: Replacing the battery does not erase  
the program med key from your vehicle. The  
transmitter should operate normally.  
4. Turn the remote control over to remove  
the battery.  
1. Insert a screwdriver as far as possible  
into the slot on the side of the remote  
control, gently push the clip.  
2. Press the clip down to release the  
battery cover.  
Note: Do not touch the battery contacts or  
the printed circuit board with the  
screwdriver.  
5. Install a new battery (3V CR 2032) with  
the + facing upwards.  
6. Replace the battery cover.  
3. Carefully remove the cover.  
52  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing  
Keys and Remote Controls  
Remote Control  
Intelligent Access Key (If Equipped)  
Push the release button and pull the key  
blade out.  
The intelligent access keys operate the  
power locks. The key must be in your  
vehicle to use the push button start.  
Replacing the Battery  
Note: Refer to local regulations when  
disposing of transmitter batteries.  
Remove Key Blade  
Note: Do not wipe off any grease on the  
battery terminals or on the back surface of  
the circuit board.  
The intelligent access key also contains a  
removable key blade that you can use to  
unlock your vehicle.  
Note: Replacing the battery does not erase  
the program med key from your vehicle. The  
transmitter should operate normally.  
A message appears in the information  
display when the remote control battery  
is low. See Information Messages (page  
96). See Information Messages (page ?).  
The remote control uses one coin-type  
three-volt lithium battery CR2450 or  
equivalent.  
53  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing  
Keys and Remote Controls  
1. Push the release button and pull the  
key blade out.  
2. Twist a thin coin under the tab hidden  
behind the key blade head to remove  
the battery cover.  
54  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing  
Keys and Remote Controls  
3. Insert a suitable tool, for example a  
screwdriver, in the position shown and  
carefully remove the battery.  
4. Install a new battery with the + facing  
upward.  
5. Reinstall the battery cover and the key  
blade.  
REPLACING A LOST KEY OR  
REMOTE CONTROL  
Replacement keys or remote controls can  
be purchased from an authorized dealer.  
Authorized dealers can program remote  
controls for your vehicle. See Passive  
Anti-Theft System (page 67).  
55  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing