Starting and Stopping the Engine -> Starting a Gasoline Engine for Your Ford Ecosport SUV 2020

Starting and Stopping the Engine  
Move the transmission selector lever  
Vehicles with Automatic Transmission  
to the neutral position (vehicles with a  
manual transmission) or position N  
(vehicles with an automatic  
Note: Do not touch the accelerator pedal.  
1. Fully depress the brake pedal.  
2. Shift into park (P) or neutral (N).  
3. Start the engine.  
transmission) and use the brakes to  
bring your vehicle to a safe stop.  
When your vehicle has stopped, move  
the transmission selector lever to the  
neutral position (vehicles with a  
manual transmission) or position N  
(vehicles with an automatic  
transmission) and switch the ignition  
off.  
All Vehicles  
If the engine does not start within 10  
seconds, wait for a short period and try  
again.  
If the engine does not start after three  
attempts, wait ten seconds and follow the  
flooded engine procedure.  
If you have difficulty starting the engine  
when the temperature is below -13.0°F  
(-25°C), press the accelerator pedal to the  
mid-way point of its travel and try again.  
STARTING A GASOLINE  
ENGINE  
Before starting the engine, check the  
following:  
Make sure all occupants have fastened  
their seatbelts.  
Fuel Flooded Engine  
Vehicles with Manual Transmission  
Make sure the headlamps and  
electrical accessories are off.  
1. Fully depress the clutch pedal.  
Make sure the parking brake is on.  
Shift into park (P) or neutral.  
2. Fully depress the accelerator pedal and  
hold it there.  
Note: You can only attempt to start the  
engine for a limited amount of time before  
the starting system temporarily disables. If  
you exceed the starting time limit, a  
message may appear and you cannot  
attempt to start the engine for at least 15  
minutes.  
3. Start the engine.  
Vehicles with Automatic Transmission  
1. Fully depress the brake pedal.  
2. Shift into park (P) or neutral (N).  
3. Fully depress the accelerator pedal and  
hold it there.  
Cold or Hot Engine  
Vehicles with Manual Transmission  
Note: Do not touch the accelerator pedal.  
Note: Releasing the clutch pedal during  
engine starting stops the engine from  
cranking.  
4. Start the engine.  
All Vehicles  
If the engine does not start, repeat the cold  
or hot engine procedure.  
1. Fully depress the clutch pedal.  
2. Start the engine.  
133  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing  
Starting and Stopping the Engine  
Note: The heater is most effective when  
Engine Idle Speed after Starting  
outdoor temperatures are below 0°F  
(-18°C).  
The speed at which the engine idles  
immediately after starting minimizes  
vehicle emissions and maximizes cabin  
comfort and fuel economy.  
The idle speed varies depending on certain  
factors. These include vehicle component  
and ambient temperatures as well as  
electrical and climate system demands.  
The heater acts as a starting aid by  
warming the engine coolant. This allows  
the climate control system to respond  
quickly. The equipment includes a heater  
element (installed in the engine block) and  
a wire harness. You can connect the  
system to a grounded 120-volt AC  
electrical source.  
Failure to Start  
Vehicles with Manual Transmission  
We recommend that you do the following  
for a safe and correct operation:  
Use a 16-gauge outdoor extension cord  
that is product certified by  
If the engine does not crank when you fully  
depress the clutch pedal with the ignition  
key in position III, follow this procedure:  
Underwriters Laboratory (UL) or  
Canadian Standards Association  
(CSA). This extension cord must be  
suitable for use outdoors, in cold  
temperatures, and be clearly marked  
Suitable for Use with Outdoor  
Appliances. Do not use an indoor  
extension cord outdoors. This could  
result in an electric shock or become a  
fire hazard.  
1. Fully depress both the clutch and brake  
pedals.  
2. Turn the key to position III until the  
engine has started.  
ENGINE BLOCK HEATER(IF  
EQUIPPED)  
Use as short an extension cord as  
possible.  
Do not use multiple extension cords.  
WARNING: Failure to follow  
engine block heater instructions could  
result in property damage or serious  
personal injury.  
Make sure that when in operation, the  
extension cord plug and heater cord  
plug connections are free and clear of  
water. This could cause an electric  
shock or fire.  
WARNING:Do not use your heater  
with ungrounded electrical systems or  
two-pronged adapters. There is a risk of  
electrical shock.  
Make sure your vehicle is parked in a  
clean area, clear of combustibles.  
Make sure the heater, heater cord and  
extension cord are firmly connected.  
Check for heat anywhere in the  
electrical hookup once the system has  
been operating for approximately 30  
minutes.  
WARNING: Do not fully close the  
hood, or allow it to drop under its own  
weight when using the engine block  
heater. This could damage the power  
cable and may cause an electrical short  
resulting in fire, injury and property  
damage.  
134  
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing