Driving Aids -> Pre-Collision Assist for Your Ford Fiesta 4 Door 2023

Driving Aids  
Trip Summary  
deceleration, speed and gear shifting  
during the total distance traveled by your  
vehicle for the current trip.  
The calculated trip summary is shown as  
four colored bars. The bars travel from left  
to right as the calculated efficiency levels  
increase. The bars indicate the average  
efficiency level for acceleration,  
Note: Vehicles with an automatic  
transmission do not have a bar for gear  
shifting.  
To view the trip summary, use the information display controls on the steering  
wheel to select the following:  
Menu Item  
MyView  
Eco coach  
Action  
Press the menu button.  
Press the OK button. Press it again to view the trip summary.  
WARNING: The system may not  
PRE-COLLISION ASSIST  
operate properly if your vehicle has a  
non-Ford windshield. Do not carry out  
windshield repairs in the area around the  
sensor.  
WARNING: You are responsible for  
controlling your vehicle at all times. The  
system is designed to be an aid and does  
not relieve you of your responsibility to  
drive with due care and attention. Failure  
to follow this instruction could result in  
the loss of control of your vehicle,  
personal injury or death.  
WARNING: In situations where the  
vehicle camera has limited detection  
capability, this may reduce system  
performance. These situations include  
but are not limited to direct or low  
sunlight, vehicles at night without tail  
lights, unconventional vehicle types,  
pedestrians with complex backgrounds,  
running pedestrians, partly obscured  
pedestrians, or pedestrians that the  
system cannot distinguish from a group.  
Failure to take care may result in the loss  
of control of your vehicle, serious  
personal injury or death.  
WARNING: The system does not  
operate during hard acceleration or  
steering. Failure to take care may lead  
to a crash or personal injury.  
WARNING: The system may fail or  
operate with reduced function during  
cold and severe weather conditions.  
Snow, ice, rain, spray and fog can  
adversely affect the system. Keep the  
front camera and radar free of snow and  
ice. Failure to take care may result in the  
loss of control of your vehicle, serious  
personal injury or death.  
WARNING:The Pre-Collision Assist  
system with brake support cannot help  
prevent all collisions. Do not rely on this  
system to replace your judgment and the  
need to maintain correct distance and  
speed.  
202  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing  
Driving Aids  
The pre-collision assist system is active  
when your vehicle reaches a speed greater  
than approximately 5 km/h (3 mph).  
Pedestrian detection is active at speeds  
up to 80 km/h (50 mph).  
E156130  
If your vehicle is rapidly approaching  
another stationary vehicle, a vehicle or  
cyclist traveling in the same direction as  
yours, or a pedestrian within your driving  
path, the system is designed to provide  
three levels of functionality.  
Note: The system is not designed to detect  
animals.  
Note: The system is not designed to detect  
vehicles or cyclists that are traveling in a  
different direction.  
Level of Functionality  
Description  
Alert  
When activated, a warning lamp flashes and an audible  
warning sounds.  
Brake support  
The system is designed to help reduce the impact speed by  
preparing the brakes for rapid braking. The system does not  
automatically apply the brakes. If you press the brake pedal,  
the system could apply additional braking up to maximum  
braking force, even if you lightly press the brake pedal.  
Active braking - vehicles The system is designed to apply the brakes if it detects a  
without adaptive cruise crash is imminent. This may help reduce impact or avoid the  
control  
crash.  
The system is active at speeds up to 130 km/h (80 mph).  
Active braking - vehicles The system is designed to apply the brakes if it detects a  
with adaptive cruise  
control  
crash is imminent. This may help reduce impact or avoid the  
crash.  
To switch active braking on or off, use the information display controls on the  
steering wheel to select the following:  
Menu Item  
Action  
Driver assist.  
Press the menu button.  
Press the OK button.  
Press the OK button.  
Pre-collision Assist  
Active braking  
Note: The warning lamp does not  
illuminate if cruise control or adaptive cruise  
control is active.  
Distance Alert (If Equipped)  
A warning lamp illuminates if the distance  
to the vehicle ahead is small.  
203  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing  
Driving Aids  
Distance Alert Sensitivity Settings  
To adjust the distance alert sensitivity settings, use the information display  
controls on the steering wheel to select the following:  
Menu Item  
Driver assist.  
Action  
Press the menu button.  
Pre-collision Assist  
Alert sensitivity  
Press the OK button.  
Press the OK button. Press the toggle button upward or  
downward to choose your required setting. Press the OK  
button.  
Note: The graphic does not display if you  
Distance Indication(If Equipped)  
A graphical indication displays the time  
gap to vehicles ahead of you traveling in  
the same direction.  
switch on cruise control or adaptive cruise  
control.  
Vehicle Speed System Sensit- Distance Indic-  
Distance Gap  
Time Gap  
ivity  
ator Color  
Gray.  
100 km/h  
(62 mph)  
Normal.  
Greater than  
Greater than 0.9  
seconds.  
25 m (82.0 ft) .  
Yellow.  
Red.  
1725 m  
0.6-0.9  
(55.882.0 ft).  
seconds.  
Less than 17 m  
(55.8 ft).  
Less than 0.6  
seconds.  
Switching Distance Indication On or Off  
To switch distance indication on or off, use the information display controls on  
the steering wheel to select the following:  
Menu Item  
Driver assist.  
Action  
Press the menu button.  
Press the OK button.  
Press the OK button.  
Pre-collision Assist  
Distance indication  
204  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing  
Driving Aids  
The camera is mounted behind the interior  
Pre-Collision Assist System  
Sensors  
mirror.  
Vehicles without Adaptive Cruise  
Control  
E243054  
E244279  
The camera is mounted behind the interior  
mirror.  
The radar sensor is behind the front grille  
below the license plate.  
Note: Keep the sensors free from snow, ice  
Note: Keep the sensors free from snow, ice  
and large accumulations of dirt.  
and large accumulations of dirt.  
Note: Do not clean the sensors with sharp  
Note: Do not clean the sensors with sharp  
objects.  
objects.  
Note: If your vehicle sustains damage  
leaving the sensors misaligned, this may  
cause inaccurate measurements or false  
alerts.  
Blocked sensors could affect system  
accuracy. A message may appear in the  
information display.  
Note: If your vehicle sustains damage  
leaving the sensors misaligned, this may  
cause inaccurate measurements or false  
alerts.  
Blocked sensors could affect system  
accuracy. A message may appear in the  
information display.  
Vehicles with Adaptive Cruise Control  
Pre-CollisionAssistWarningLamp  
It illuminates if your vehicle  
rapidly approaches another  
vehicle, to warn you of the risk of  
a crash with the vehicle in front of you.  
It could illuminate red if the distance to the  
vehicle ahead is small.  
It illuminates when the system is not  
available.  
E243054  
205  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing  
Driving Aids  
Pre-Collision Assist Information Messages  
Message  
Action  
Pre-collision assist not  
available  
The system has malfunctioned. Have your vehicle checked  
as soon as possible.  
Pre-collision assist not  
The sensors are dirty. Clean the sensors. If the message  
available Sensor blocked continues to appear, have your vehicle checked as soon as  
possible.  
The following table lists possible causes and actions for when a blocked sensor  
message may display.  
Cause  
Action  
The surface of the radar in the radiator grille Clean the radiator grille in front of the radar  
is dirty or obstructed.  
or remove any obstruction.  
The surface of the radar is clean but the  
message remains in the display.  
Wait for a short period of time. It may take  
several minutes for the system to detect  
that there is no obstruction.  
Heavy rain, spray, snow, or fog is interfering The system is temporarily disabled. The  
with the radar signals.  
system should reactivate after a short  
period of time when the weather conditions  
improve.  
The radar is misaligned.  
Have your vehicle checked as soon as  
possible.  
The windshield in front of the camera is  
dirty or obstructed.  
Clean the outside of the windshield in front  
of the camera.  
The windshield in front of the camera is  
clean but the message remains in the  
display.  
Wait for a short period of time. It may take  
several minutes for the camera to detect  
that there is no obstruction.  
Excessive heat around the camera.  
Wait for a short period of time. The  
message should clear when the temper-  
ature around the camera decreases.  
206  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing