Get MyKey Guide for Ford Fiesta 4 Door 2023

MyKey™

Speed Limit

PRINCIPLE OF OPERATION

The system is designed to promote good

driving behaviors using keys that you have

programmed with some restricted settings.

WARNING: Do not set MyKey

maximum speed limit to a limit that will

prevent the driver from maintaining a

safe speed considering posted speed

limits and prevailing road conditions. The

driver is always responsible to drive in

accordance with local laws and

MYKEY SETTINGS -

EXCLUDING: ST

Non-Configurable Settings

Seatbelt Reminder

The audio system mutes when the seatbelt

reminder turns on. The seatbelt reminder

cannot be switched off with a MyKey.

prevailing conditions. Failure to do so

could result in accident or injury.

You can set a speed limit for your vehicle.

Warning messages appear in the

information display and a tone sounds if

your vehicle reaches the set speed. You

cannot override the set speed when using

a MyKey.

Early Low Fuel

The low fuel level warning lamp turns on

Speed Reminder

earlier.

You can set a speed reminder for your

vehicle. Warning messages appear in the

information display and a tone sounds if

your vehicle exceeds the set speed.

Driving and Parking Aids

Parking aids, blind spot information system

and cross traffic alert turn on when you

start the engine and cannot be switched

off with a MyKey.

Audio System Volume Limit

The audio system maximum volume is

reduced. A message appears in the

information display if you attempt to

exceed the volume limit. Automatic

volume control turns off.

Pre-collision assist and lane keeping alert

turn on when you start the engine, but can

be switched off with a MyKey.

A new destination in the navigation system

can only be set using voice commands,

when using a MyKey and your vehicle is

moving.

Emergency Assistance

If you set emergency assistance to be

always on, it cannot be switched off with

a MyKey.

Configurable Settings

You can configure the following settings

after creating a MyKey. See Creating a

MyKey (page 47).

Do Not Disturb

If you set do not disturb to be always on,

it cannot be switched off with a MyKey.

Traction Control

If you set traction control to be always on,

it cannot be switched off with a MyKey.

45

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

Speed Limit

MYKEY SETTINGS - ST

Non-Configurable Settings

Seatbelt Reminder

The audio system mutes when the seatbelt

reminder turns on. The seatbelt reminder

cannot be switched off with a MyKey.

WARNING: Do not set MyKey

maximum speed limit to a limit that will

prevent the driver from maintaining a

safe speed considering posted speed

limits and prevailing road conditions. The

driver is always responsible to drive in

accordance with local laws and

Early Low Fuel

The low fuel level indicator turns on earlier.

prevailing conditions. Failure to do so

could result in accident or injury.

Driving and Parking Aids

You can set a speed limit for your vehicle.

Warning messages appear in the

information display and a tone sounds if

your vehicle reaches the set speed. You

cannot override the set speed when using

a MyKey.

Parking aids, blind spot information system

and cross traffic alert turn on when you

start the engine and cannot be switched

off with a MyKey.

Pre-collision assist and lane keeping alert

turn on when you start the engine, but can

be switched off with a MyKey.

A new destination in the navigation system

can only be set using voice commands,

when using a MyKey and your vehicle is

moving.

Speed Reminder

You can set a speed reminder for your

vehicle. Warning messages appear in the

information display and a tone sounds if

your vehicle exceeds the set speed.

Audio System Volume Limit

Selectable Drive Modes

The audio system maximum volume is

reduced. A message appears in the

information display if you attempt to

exceed the volume limit. Automatic

volume control turns off.

You cannot select some drive modes when

using a MyKey.

Stability Control

You cannot switch stability control off

Emergency Assistance

If you set emergency assistance to be

always on, it cannot be switched off with

a MyKey.

when using a MyKey.

Configurable Settings

You can configure the following settings

after creating a MyKey. See Creating a

MyKey (page 47).

Do Not Disturb

If you set do not disturb to be always on,

it cannot be switched off with a MyKey.

46

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

Stability Control

CREATING A MYKEY -

VEHICLES WITHOUT: PUSH

If you set stability control to be always on,

the reduced stability control mode cannot

be selected when using a MyKey. See

Using Stability Control (page 161).

BUTTON START

Switch the ignition on using an admin key.

To create a MyKey, use the information display controls on the steering wheel to

select the following:

Menu Item

Action

Settings

Press the menu button.

MyKey

Press the OK button.

Create MyKey

Press and hold the OK button until a confirmation message

appears in the information display.

Switch the ignition off.

Note: We recommend that you label this

key.

MyKey Information Messages

Message

Description

Key is already a MyKey

Displays when trying to create a MyKey with a key already

designated as a MyKey.

Key restricted at next

start. Label this key

Displays to confirm that the key is restricted after you switch

the ignition off.

2. Switch the ignition on.

CREATING A MYKEY -

VEHICLES WITH: PUSH

BUTTON START

1. Place an admin key in the backup

position. See Passive Key Backup

Position (page 44).

47

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

To create a MyKey, use the information display controls on the steering wheel to

select the following:

Menu Item

Action

Settings

Press the menu button.

MyKey

Press the OK button.

Create MyKey

Press and hold the OK button until a confirmation message

appears in the information display.

Switch the ignition off.

Note: We recommend that you label this

key.

MyKey Information Messages

Message

Description

Place key in backup loca- Displays when trying to create a MyKey and the key is not

tion

placed in the backup position. See Passive Key Backup

Position (page 44).

Key is already a MyKey

Displays when trying to create a MyKey with a key already

designated as a MyKey.

Key restricted at next

start. Label this key

Displays to confirm that the key is restricted after you switch

the ignition off.

Switch the ignition on using an admin key.

PROGRAMMING A MYKEY

You can only program MyKeys to the same

settings.

48

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

To program a MyKey, use the information display controls on the steering wheel

to select the following:

Menu Item

Settings

MyKey

Action

Press the menu button.

Press the OK button.

Select a setting and press the OK button.

Configure the setting.

Switch the ignition off.

49

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

restrictions and return all MyKeys to their

CLEARING ALL MYKEYS

original admin key status.

When you clear all MyKeys, you remove all

Switch the ignition on using an admin key.

To clear all MyKeys, use the information display controls on the steering wheel

to select the following:

Menu Item

Action

Settings

Press the menu button.

MyKey

Press the OK button.

Clear MyKeys

Press and hold the OK button until a confirmation message

appears in the information display.

50

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

Switch the ignition on.

CHECKING MYKEY SYSTEM

STATUS

To find information about the distance traveled using a MyKey and also the number

of admin keys and MyKeys created for your vehicle, use the information display

controls on the steering wheel to select the following:

Menu Item

Action

Settings

Press the menu button.

Press the OK button.

MyKey

MyKey info

51

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

MYKEY–TROUBLESHOOTING

- VEHICLES WITH: PUSH

BUTTON START

- VEHICLES WITHOUT: PUSH

BUTTON START

What is an admin key?

•

An admin key is a key that has not been

created as a MyKey. See Creating a

MyKey (page 47).

•

An admin key is a key that has not been

created as a MyKey. See Creating a

MyKey (page 47).

Why can I not create a MyKey?

•

The key used to switch the ignition on

•

The admin key is not placed in the

backup position. See Passive Key

Backup Position (page 44).

is not an admin key.

•

The key used to switch the ignition on

is the only admin key. There always has

to be at least one admin key.

•

The key used to switch the ignition on

is not an admin key.

The key used to switch the ignition on

is the only admin key. There always has

to be at least one admin key.

Why can I not program a MyKey?

•

The key used to switch the ignition on

is not an admin key.

•

The last MyKey was created without

switching the ignition off.

•

No MyKeys are created. See Creating

a MyKey (page 47).

Why can I not program a MyKey?

Why can I not clear the MyKeys?

•

The admin key is not inside your

vehicle.

•

The key used to switch the ignition on

is not an admin key.

The key used to switch the ignition on

is not an admin key.

•

No MyKeys are created. See Creating

a MyKey (page 47).

No MyKeys are created. See Creating

a MyKey (page 47).

Why does the MyKey distance not

accumulate?

Why can I not clear the MyKeys?

•

The key used to start the engine is an

admin key.

•

The admin key is not inside your

vehicle.

No MyKeys are created. See Creating

The key used to switch the ignition on

is not an admin key.

a MyKey (page 47).

The MyKeys have been cleared.

No MyKeys are created. See Creating

a MyKey (page 47).

52

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey™

Why does the MyKey distance not

accumulate?

•

The key used to start the engine is an

admin key.

An admin key and a MyKey are inside

your vehicle.

No MyKeys are created. See Creating

a MyKey (page 47).

The MyKeys have been cleared.

Why can I not start the engine with

a MyKey?

•

An admin key and a MyKey are inside

your vehicle.

53

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

MyKey for Your Ford Fiesta 4 Door 2023

Popular Manuals