MyKey -> Settings-ST for Your Ford Fiesta 4 Door 2023

MyKey  
Speed Limit  
MYKEY SETTINGS - ST  
Non-Configurable Settings  
Seatbelt Reminder  
The audio system mutes when the seatbelt  
reminder turns on. The seatbelt reminder  
cannot be switched off with a MyKey.  
WARNING: Do not set MyKey  
maximum speed limit to a limit that will  
prevent the driver from maintaining a  
safe speed considering posted speed  
limits and prevailing road conditions. The  
driver is always responsible to drive in  
accordance with local laws and  
Early Low Fuel  
The low fuel level indicator turns on earlier.  
prevailing conditions. Failure to do so  
could result in accident or injury.  
Driving and Parking Aids  
You can set a speed limit for your vehicle.  
Warning messages appear in the  
information display and a tone sounds if  
your vehicle reaches the set speed. You  
cannot override the set speed when using  
a MyKey.  
Parking aids, blind spot information system  
and cross traffic alert turn on when you  
start the engine and cannot be switched  
off with a MyKey.  
Pre-collision assist and lane keeping alert  
turn on when you start the engine, but can  
be switched off with a MyKey.  
A new destination in the navigation system  
can only be set using voice commands,  
when using a MyKey and your vehicle is  
moving.  
Speed Reminder  
You can set a speed reminder for your  
vehicle. Warning messages appear in the  
information display and a tone sounds if  
your vehicle exceeds the set speed.  
Audio System Volume Limit  
Selectable Drive Modes  
The audio system maximum volume is  
reduced. A message appears in the  
information display if you attempt to  
exceed the volume limit. Automatic  
volume control turns off.  
You cannot select some drive modes when  
using a MyKey.  
Stability Control  
You cannot switch stability control off  
Emergency Assistance  
If you set emergency assistance to be  
always on, it cannot be switched off with  
a MyKey.  
when using a MyKey.  
Configurable Settings  
You can configure the following settings  
after creating a MyKey. See Creating a  
MyKey (page 47).  
Do Not Disturb  
If you set do not disturb to be always on,  
it cannot be switched off with a MyKey.  
46  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing  
MyKey™  
Stability Control  
CREATING A MYKEY -  
VEHICLES WITHOUT: PUSH  
If you set stability control to be always on,  
the reduced stability control mode cannot  
be selected when using a MyKey. See  
Using Stability Control (page 161).  
BUTTON START  
Switch the ignition on using an admin key.  
To create a MyKey, use the information display controls on the steering wheel to  
select the following:  
Menu Item  
Action  
Settings  
Press the menu button.  
MyKey  
Press the OK button.  
Create MyKey  
Press and hold the OK button until a confirmation message  
appears in the information display.  
Switch the ignition off.  
Note: We recommend that you label this  
key.  
MyKey Information Messages  
Message  
Description  
Key is already a MyKey  
Displays when trying to create a MyKey with a key already  
designated as a MyKey.  
Key restricted at next  
start. Label this key  
Displays to confirm that the key is restricted after you switch  
the ignition off.  
2. Switch the ignition on.  
CREATING A MYKEY -  
VEHICLES WITH: PUSH  
BUTTON START  
1. Place an admin key in the backup  
position. See Passive Key Backup  
Position (page 44).  
47  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing