Roadside Emergencies -> Jump Starting the Vehicle for Your Ford Fiesta 4 Door 2023

Roadside Emergencies  
Note: When you try to restart your vehicle  
To Connect the Booster Cables  
after a fuel shutoff, the vehicle makes sure  
that various systems are safe to restart.  
Once your vehicle determines that the  
systems are safe, then the vehicle will allow  
you to restart.  
Note: In the event that your vehicle does  
not restart after your third attempt, contact  
an authorized dealer.  
A
JUMPSTARTINGTHEVEHICLE  
C
D
WARNING: Do not use fuel lines,  
engine valve covers, windshield wiper  
arms, the intake manifold, or hood latch  
as ground points.  
WARNING: Connect batteries with  
only the same nominal voltage.  
B
WARNING: Use only adequately  
sized cables with insulated clamps.  
Note: Do not disconnect the battery from  
your vehicles electrical system.  
E102925  
A
B
C
D
Vehicle with low charge battery  
Booster battery vehicle  
Positive connection cable  
Negative connection cable  
1. Position the vehicles so that they do  
not touch one another.  
2. Switch off the engine and any electrical  
equipment.  
3. Connect the positive (+) terminal of  
vehicle B with the positive (+) terminal  
of vehicle A (cable C).  
223  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing  
Roadside Emergencies  
TOWING POINTS -  
EXCLUDING: ST  
Front Towing Point  
WARNING: Make sure that the  
towing eye is fully tightened. Failure to  
follow this instruction could result in  
personal injury.  
E270780  
WARNING: You must switch the  
ignition on when your vehicle is being  
towed.  
4. Connect the negative (-) terminal of  
vehicle B to the ground connection of  
vehicle A (cable D).  
WARNING: Do not connect the  
negative (-) cable to the negative (-)  
terminal of the discharged battery.  
WARNING: Make sure that the  
cables are clear of any moving parts and  
fuel delivery system parts.  
1
To Start the Engine  
1. Run the engine of vehicle B at a  
moderately high speed.  
2. Start the engine of vehicle A.  
E292787  
3. Run both vehicles for a minimum of  
three minutes before disconnecting the  
cables. Do not switch on the  
1. Push the cover.  
2. Carefully remove the cover.  
headlamps when disconnecting the  
cables. The peak voltage could blow  
the bulbs.  
Disconnect the cables in the reverse order.  
224  
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing