Get Starting and Stopping the Engine -> Starting a Gasoline Engine-Manual Transmission Guide for Ford Fiesta 4 Door 2023

Starting and Stopping the Engine

Starting System Information Messages

Message

Action

Full accessory power

active

Displays if you switch the ignition on and do not start the

engine.

Cranking time exceeded Displays if you exceed the starting time limit. You cannot

attempt to start the engine for 15 minutes. If you cannot start

the engine after 15 minutes passes, have your vehicle imme-

diately checked.

Starting system

malfunction

Displays if you are unable to start your vehicle with a correctly

coded key. The system has detected a fault that requires

service. Have your vehicle checked as soon as possible.

Note: The engine may continue cranking

for up to 15 seconds or until it starts.

STARTING A GASOLINE

ENGINE - MANUAL

TRANSMISSION

Note: The engine takes longer to start at

lower temperatures. It may crank for several

seconds when very cold.

Vehicles with a Push Button

The speed at which the engine idles

immediately after starting is optimized to

minimize vehicle emissions and maximize

cabin comfort and fuel economy.

Note: You can only attempt to start the

engine for a limited amount of time before

the starting system temporarily disables. If

you exceed the starting time limit, a

message may appear and you cannot

attempt to start the engine for at least 15

minutes.

Ignition Switch

See Push Button Ignition Switch (page

124).

Failure to Start

If you cannot start the engine after 3

attempts, wait 10 seconds and do the

following:

Vehicles with an Ignition Key

Before starting your vehicle, check the

1. Fully press the clutch pedal.

2. Apply the parking brake.

3. Shift into neutral.

following:

•

Make sure the headlamps and

electrical accessories are off.

•

Make sure the parking brake is on.

4. Fully press the accelerator pedal and

hold it there.

Make sure the transmission is in

neutral.

5. Turn the key to position III and wait

until the engine stops.

Vehicles with an Ignition Key

1. Fully press the clutch pedal.

Note: Do not touch the accelerator pedal.

2. Turn the key to position III.

6. Release the accelerator pedal.

7. Start the engine.

130

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Starting and Stopping the Engine

Vehicles with a Push Button Ignition

a timer counting down. If you do not

intervene within 30 seconds, your vehicle

shuts down. Another message appears in

the information display to inform you that

your vehicle has shut down to save fuel.

Start your vehicle as normal.

Switch

See Push Button Ignition Switch (page

124).

Automatic Engine Shutdown

Automatic Engine Shutdown Override

For vehicles with a push button ignition

switch, the engine shuts down if it has been

idling for an extended period. The ignition

also turns off to save battery power.

You can stop the shutdown, or reset the

timer, at any point before the 30-second

countdown has expired by doing any of the

following:

Before your vehicle shuts down, a message

appears in the information display showing

•

Pressing the brake or accelerator pedal.

Switching off the automatic engine

shutdown in the information display.

•

Pressing the OK or RESET button

during the 30-second countdown.

Switching the Automatic Engine Shutdown On or Off

To switch the automatic engine shutdown on or off, use the information display

controls on the steering wheel to select the following:

Menu Item

Settings

Action

Press the menu button.

Press the OK button.

Vehicle settings

30min max idle

Note: You cannot permanently switch off

the automatic shutdown. If you switch it

off, it turns on each time you switch the

ignition on.

Vehicles with a Push Button Ignition

Switch

See Push Button Ignition Switch (page

124).

Stopping the Engine When Your

Vehicle is Stationary

Stopping the Engine When Your

Vehicle is Moving

Vehicles with an Ignition Key

1. Shift into neutral.

2. Turn the key to position 0.

3. Apply the parking brake.

WARNING: Switching off the

engine when your vehicle is still moving

results in a significant decrease in

braking assistance. Higher effort is

required to apply the brakes and to stop

your vehicle. A significant decrease in

131

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Starting and Stopping the Engine

Engine Warning Lamps

steering assistance could also occur. The

steering does not lock, but higher effort

could be required to steer your vehicle.

When you switch the ignition off, some

electrical circuits, for example airbags,

also turn off. If you unintentionally switch

the ignition off, shift into neutral (N) and

restart the engine.

Malfunction Indicator Lamp

Check Engine

If it illuminates when the engine is running

this indicates a malfunction. The On Board

Diagnostics system has detected a

malfunction of the vehicle emission control

system.

If it flashes, engine misfire may be

occurring. Increased exhaust gas

temperatures could damage the catalytic

converter or other vehicle components.

Avoid heavy acceleration and deceleration

and have your vehicle immediately

serviced.

Vehicles with an Ignition Key

1. Shift into neutral and use the brakes to

bring your vehicle to a safe stop.

2. Turn the key to position 0.

3. Apply the parking brake.

Vehicles with a Push Button Ignition

Switch

Powertrain Warning Lamp

See Push Button Ignition Switch (page

124).

If it illuminates when the engine is running

this indicates a malfunction. If it flashes

when you are driving, immediately reduce

the vehicle speed. Avoid heavy

Guarding Against Exhaust Fumes

WARNING: Exhaust leaks may

result in entry of harmful and potentially

lethal fumes into the passenger

acceleration and deceleration and have

your vehicle immediately serviced.

If both lamps illuminate when the engine

is running, stop your vehicle as soon as it

is safe to do so. Continuing to drive your

vehicle may cause reduced power or the

engine to stop. Switch the ignition off and

attempt to restart the engine. Have your

vehicle immediately checked.

compartment. If you smell exhaust

fumes inside your vehicle, have your

vehicle inspected immediately. Do not

drive if you smell exhaust fumes.

Important Ventilating Information

If you stop your vehicle and then leave the

engine idling for long periods, we

recommend that you do one of the

following:

•

Open the windows at least 3 cm (1 in).

Set your climate control to outside air.

132

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Starting and Stopping the Engine

Starting System Information Messages

Message

Action

Full accessory power

active

Displays if you switch the ignition on and do not start the

engine.

Cranking time exceeded Displays if you exceed the starting time limit. You cannot

attempt to start the engine for 15 minutes. If you cannot start

the engine after 15 minutes passes, have your vehicle imme-

diately checked.

Starting system

malfunction

Displays if you are unable to start your vehicle with a correctly

coded key. The system has detected a fault that requires

service. Have your vehicle checked as soon as possible.

Note: You can only attempt to start the

engine for a limited amount of time before

STARTING A DIESEL ENGINE

the starting system temporarily disables. If

you exceed the starting time limit, a

message may appear and you cannot

attempt to start the engine for at least 15

minutes.

Before starting your vehicle, check the

following:

•

Make sure the headlamps and

electrical accessories are off.

Vehicles with a Push Button

•

Make sure the parking brake is on.

Ignition Switch

Make sure the transmission is in

See Push Button Ignition Switch (page

neutral.

124).

Vehicles with an Ignition Key

Failure to Start

Vehicles with an Ignition Key

1. Turn the key to position II.

2. Wait until the glow plug indicator turns

off.

If the engine does not start, do the

3. Fully press the clutch pedal.

Note: Do not touch the accelerator pedal.

4. Turn the key to position III.

Note: Releasing the clutch pedal when the

engine is starting stops the engine cranking

and the ignition returns to on.

Note: When the temperature is below -15°C

(5°F), you may need to crank the engine for

up to 10 seconds.

following:

1. Fully press the brake pedal.

2. Apply the parking brake.

3. Shift into neutral.

4. Turn the key to position III until the

engine starts.

Vehicles with a Push Button Ignition

Switch

See Push Button Ignition Switch (page

124).

133

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Starting and Stopping the Engine -> Starting a Gasoline Engine-Manual Transmission for Your Ford Fiesta 4 Door 2023

Popular Manuals