Get Wheels and Tires -> Tire Sealant and Inflator Kit-Vehicles With-Temporary Mobility Kit Guide for Ford Fiesta 4 Door 2023

Wheels and Tires

If your vehicle does not have a spare wheel

GENERAL INFORMATION

The recommended tire inflation pressures

are on the tire information label on the

driver side B-pillar.

Check and set the tire pressure at the

ambient temperature in which you are

intending to drive your vehicle and when

the tires are cold. See Tire Pressures

(page 285).

it has a tire sealant and inflator kit. The kit

is in the luggage compartment. Only use

the kit supplied with your vehicle.

Note: The kit can only temporarily repair

one tire puncture with a maximum puncture

size of up to 6 mm (0.24 in).

Note: Check your tire pressures regularly to

optimize fuel economy.

Only use approved wheel and tire sizes.

Using other sizes could damage your

vehicle and could make the National Type

Approval invalid.

Installation of any tires that are not the

original equipment tire size can cause the

speedometer to display incorrect vehicle

speed.

E258988

TIRESEALANTANDINFLATOR

KIT - VEHICLES WITH:

Pressure Gauge.

Power switch.

Sealant bottle tire inflation pipe.

Sealant bottle.

TEMPORARY MOBILITY KIT

WARNING: Do not use the inflator

kit on run flat tires. This could cause loss

of vehicle control.

12 volt DC power point

connector.

Pressure relief valve.

Compressor tire inflation pipe.

WARNING: Depending on the type

and extent of tire damage, some tires

can only be partially sealed or not sealed

at all. Loss of tire pressure can affect

vehicle handling, leading to loss of

vehicle control.

Note: A maximum speed warning label is

attached to the sealant bottle.

Note: Do not use the sealant bottle after

its expiry date. You can obtain a

replacement sealant bottle from an

authorized dealer.

WARNING: Do not use the kit on a

previously damaged tire, for example

when it has been driven under inflated.

This could cause loss of vehicle control,

personal injury or death.

If the low tire pressure warning

lamp illuminates do the

following:

268

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Wheels and Tires

1. Gradually reduce the vehicle speed and

stop your vehicle as soon as it is safe

to do so.

2. Apply the parking brake and switch the

ignition off.

3. Check for a punctured tire.

Note: Do not remove objects, for example

nails or screws from a punctured tire.

Using the Tire Sealant and Inflator

Kit

WARNING: Check the sidewall of

the tire prior to inflation. If there are any

cracks, bumps or similar damage, do not

attempt to inflate the tire. This could

cause personal injury.

E258994

1. Release the tire inflation pipe and the

12 volt DC power point connector from

the underside of the compressor.

WARNING: Watch the sidewall of

the tire when inflating. If any cracks,

bumps or similar damage appears,

switch the compressor off and let the air

out by means of the pressure relief valve.

Do not continue driving with this tire. This

could cause loss of vehicle control.

WARNING: Do not stand directly

beside the tire while the compressor is

operating. This could cause personal

injury if the tire bursts.

WARNING: Do not leave the kit

unattended when it is in use. Failure to

follow this instruction could result in

personal injury or death.

E259148

2. Uncoil the sealant bottle tire inflation

pipe.

WARNING: Do not keep the

compressor operating for more than 10

minutes. This could cause the

compressor to malfunction causing

serious personal injury.

269

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Wheels and Tires

E259014

E257022

3. Attach the sealant bottle to the

compressor.

6. Plug the 12 volt DC power point

connector into the 12 volt DC socket.

See Auxiliary Power Points (page

121).

4. Attach the compressor tire inflation

pipe to the valve on the sealant bottle.

7. Start the engine.

E257006

E259160

5. Remove the tire valve dust cap and

attach the sealant bottle tire inflation

pipe to the tire valve.

8. Switch the compressor on.

270

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Wheels and Tires

E257121

E257942

9. Inflate the tire to between 2–3 bar

(29–44 psi).

Note: If the tire pressure does not reach

1.8 bar (26 psi) within 10 minutes, the tire

could be damaged beyond a temporary

repair. Have your vehicle immediately

checked. Do not drive your vehicle.

14. Immediately drive your vehicle for

4–6 km (2–4 mi). Do not exceed

80 km/h (50 mph).

10. When the tire reaches the

recommended tire pressure of

between 2–3 bar (29–44 psi), switch

the compressor and the ignition off.

11.

Disconnect the sealant bottle tire

inflation pipe from the tire valve and

the 12 volt DC power point connector.

Note: Do not remove the sealant bottle

from the compressor.

12. Reinstall the tire valve dust cap.

E257121

13. Place the warning label on the

steering wheel and correctly stow the

kit in the luggage compartment.

15. After driving between 4–6 km

(2–4 mi), stop your vehicle and

recheck the tire pressure. See Tire

Pressures (page 285).

Note: If the tire pressure has dropped to

1.8 bar (26 psi) or below, the tire could be

damaged beyond a temporary repair. Have

your vehicle immediately checked. Do not

drive your vehicle.

271

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Wheels and Tires

After Using the Tire Sealant and

Inflator Kit

TIRE CARE

Note: Front tires shown on the left side of

the diagram.

WARNING: If you experience heavy

Non-directional tires

vibrations, unsteady steering behavior or

noises while driving, reduce your speed

gradually and stop your vehicle as soon

as it is safe to do so. Recheck the tire and

its pressure. If the tire pressure is less

than 1.3 bar (18.9 psi) or if there are any

cracks, bumps or similar damage visible,

do not continue driving with this tire. This

could cause loss of vehicle control.

The kit only provides temporary mobility.

Regulations concerning tire repair or

replacement after using the kit could differ

from country to country. We recommend

you consult a tire specialist.

E142547

Directional tires

After using the kit:

•

Do not drive your vehicle more than

200 km (124 mi) before repairing or

replacing the punctured tire.

•

Inform all other users of your vehicle

that a tire was sealed using the kit.

Make them aware of the special driving

conditions that must be adhered to.

•

Regularly check the tire pressure until

the sealed tire is repaired or replaced

by a tire specialist. Before the tire is

removed from the wheel rim, you must

inform the tire specialist that the tire

contains sealant.

Remove the sealant bottle and the

sealant bottle tire inflation pipe from

the compressor and discard it in your

household waste or return it to an

authorized dealer.

E70415

To make sure the front and rear tires of

your vehicle wear evenly and last longer,

we recommend that you swap the tires

from front to rear and vice versa at regular

intervals between 5,000 km (3,000 mi)

and 10,000 km (6,000 mi).

•

WARNING: Do not scrub the

sidewalls of the tires when you are

parking.

Purchase a replacement sealant bottle

and sealant bottle tire inflation pipe

from an authorized dealer.

If you have to mount a curb, do so slowly

and approach it with the wheels at

right-angles to the curb.

272

Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing

Download User Manual App

Wheels and Tires -> Tire Sealant and Inflator Kit-Vehicles With-Temporary Mobility Kit for Your Ford Fiesta 4 Door 2023

Related Topics

Popular Owner Manuals

Latest Owner Manuals