Lighting
INSTRUMENT LIGHTING
DIMMER
The instrument lighting dimmer buttons
are on the lighting control.
Repeatedly press one of the
buttons to adjust the brightness.
E291299
E291298
HEADLAMP EXIT DELAY
E253316
After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You
will hear a short tone. The headlamps will
switch off automatically after three
minutes with any door open or 30 seconds
after the last door has been closed. You
can cancel this feature by pulling the
direction indicator lever toward you again
or switching the ignition on.
Note: When you switch the autolamps on,
the headlamps turn on within 10 seconds of
switching the wipers on.
Note: If you switch the autolamps and the
autowipers on, the headlamps turn on when
the windshield wipers continuously operate.
Note: The headlamps turn off
approximately 60 seconds after you switch
the wipers off.
AUTOMATIC HIGH BEAM
CONTROL - VEHICLES WITH:
4.2 INCH INSTRUMENT
The headlamps remain on for a period of
time after you switch the ignition off. Use
the information display controls to adjust
the period of time that the headlamps
remain on.
CLUSTER DISPLAY SCREEN
Adjusting the Period of Time That
the Headlamps Remain On
WARNING: The system does not
relieve you of your responsibility to drive
with due care and attention. You may
need to override the system if it does not
turn the high beams on or off.
1. Press the menu button on the steering
wheel to enter the information display
main menu.
2. Select Settings.
3. Select Vehicle.
WARNING: You may need to
override the system when approaching
other road users.
4. Select Lighting.
5. Select Headlamp delay.
6. Select a setting and press the OK
WARNING: You may need to
override the system during inclement
weather.
button.
109
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing
