Maintenance
If you disconnect or replace the vehicle
CHANGINGTHEFRONTWIPER
BLADES
1. Fully lift the wiper arm.
battery, you must reset the following
features:
•
Window bounce-back. See Resetting
Window Bounce-Back (page 127).
Note: Do not hold the wiper blade to lift the
•
•
Clock Settings.
wiper arm.
Pre-set radio stations.
Battery Disposal
Make sure that you dispose of
old batteries in an
E107998
environmentally friendly way.
Seek advice from your local authority
about recycling old batteries.
E264374
2. Press the wiper blade locking button.
WASHER FLUID CHECK
When adding fluid, use a mixture of washer
fluid and water to help prevent freezing
and improve the cleaning capability. For
information on fluid dilution follow the
manufacturer's instructions.
Note: The reservoir supplies the front and
rear washer systems.
E264375
CHECKING THE WIPER
BLADES
3. Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
4. To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.
CHANGING THE REAR WIPER
BLADES
1. Lift the wiper arm.
E142463
Run the tip of your fingers over the edge of
the blade to check for roughness.
Note: Do not hold the wiper blade to lift the
Clean the wiper blades with washer fluid
or water applied with a soft sponge or
cloth.
wiper arm.
430
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing
