Parking Aids for Your Ford Focus 4 Door 2023

Parking Aids  
Note: If your vehicle sustains damage  
PARKING AID PRECAUTIONS  
leaving the sensors misaligned, this will  
cause inaccurate measurements or false  
alerts.  
WARNING: To help avoid personal  
injury, always use caution when in  
reverse (R) and when using the sensing  
system.  
When you connect a trailer to your vehicle,  
the rear parking aid detects the trailer and  
provides an alert. Disable the parking aid  
when you connect a trailer to prevent the  
alert.  
Note: Certain add-on devices installed  
around the bumper or fascia may create  
false alerts, for example, large trailer  
hitches, bike or surfboard racks, license plate  
brackets, bumper covers or any other device  
that could block the normal detection zone  
of the parking aid system. Aftermarket spare  
tires or spare tire covers mounted to the rear  
tailgate could cause false alerts from the  
park aid system. Remove the add-on device  
to prevent false alerts.  
WARNING: The system may not  
detect objects with surfaces that absorb  
reflection. Always drive with due care  
and attention. Failure to take care may  
result in a crash.  
WARNING: Traffic control systems,  
fluorescent lamps, inclement weather,  
air brakes, external motors and fans may  
affect the correct operation of the  
sensing system. This may cause reduced  
performance or false alerts.  
Note: Keep the sensors free from snow, ice  
and large accumulations of dirt. If the  
sensors are covered, the system's accuracy  
can be affected.  
WARNING: The system may not  
detect small or moving objects,  
particularly those close to the ground.  
WARNING:Theparkingaidsystem  
can only assist you to detect objects  
when your vehicle is moving at parking  
speeds. To help avoid personal injury you  
must take care when using the parking  
aid system.  
Do not clean the sensors with sharp  
objects.  
Note: When using a programmed MyKey  
you cannot switch this off. See MyKey  
(page 68).  
WARNING: The system may not  
SWITCHING PARKING AID ON  
AND OFF  
function if the sensor is blocked.  
WARNING: In cold and severe  
weather conditions the system may not  
function. Rain, snow and spray can all  
limit sensor performance.  
You can turn the system on or  
off by pressing the parking aid  
E139213  
button. If your vehicle does not  
have a parking aid button, the system can  
be switched off through the information  
display menu or from the pop-up message  
that appears once you shift the  
WARNING:Ifdamageoccursinthe  
immediate area surrounding the sensor,  
have your vehicle checked as soon as  
possible.  
transmission into reverse (R).  
257  
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing  
Parking Aids  
Locating the Rear Parking Aid  
REAR PARKING AID  
Sensors  
What is the Rear Parking Aid  
Rear parking sensors detect objects behind  
your vehicle when in reverse (R).  
Rear Parking Aid Limitations  
There is a decreased coverage area at the  
outer corners.  
When using a programmed MyKey, you  
cannot switch the rear parking aid off.  
The rear parking aid sensors are active  
when your vehicle is in reverse (R) and the  
vehicle speed is less than 8 km/h (5 mph).  
E130178  
The sensor coverage area is up to 180 cm  
The rear parking aid sensors are in the rear  
bumper.  
(71 in) from the rear bumper.  
The rear parking aid detects large objects  
when you shift into reverse (R) and any of  
the following occur:  
Rear Parking Aid Audible Warnings  
Your vehicle is moving backward at a  
A warning tone sounds when your vehicle  
approaches an object. As your vehicle  
moves closer to an object, the rate of the  
tone increases. The warning tone  
low speed.  
Your vehicle is stationary but an object  
is approaching the rear of your vehicle  
at a low speed.  
continuously sounds when an object is  
30 cm (12 in) or less from the rear bumper.  
Your vehicle is moving backward at a  
low speed and an object is moving  
towards your vehicle, for example  
another vehicle at a low speed.  
If your vehicle remains stationary for a few  
seconds, the audible warning turns off. If  
your vehicle moves backward the tone  
sounds again.  
Note: When the parking aid system sounds  
a tone, the audio system could reduce the  
set volume.  
FRONT PARKING AID  
What is the Front Parking Aid  
Front parking sensors detect objects in  
front of your vehicle.  
258  
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing  
Parking Aids  
Front Parking Aid Limitations  
Locating the Front Parking Aid  
Sensors  
The front parking aid sensors are active  
when your vehicle is in any position other  
than park (P) and the vehicle speed is less  
than 8 km/h (5 mph).  
The sensor coverage area is up to 70 cm  
(28 in) from the bumper.  
If your vehicle is in reverse (R), the front  
parking aid detects objects when your  
vehicle is moving at a low speed or an  
object is moving toward your vehicle and  
provides an audio warning, for example  
another vehicle at a low speed. Once your  
vehicle reaches a stop, the audio warning  
stops after a few seconds. Visual indication  
is always active in reverse (R).  
E187330  
The front parking aid sensors are in the  
front bumper.  
If your vehicle is in any forward gear, the  
front parking aid provides audible warnings  
and visual indication when your vehicle is  
moving at a speed of 8 km/h (5 mph) or  
below and the system detects an object  
within the detection zone. Once your  
vehicle reaches a stop, the visual indication  
and audio warning stops after a few  
seconds.  
If your vehicle is in neutral (N), the front  
and rear sensors provide visual indication  
only when your vehicle is moving below a  
speed of 8 km/h (5 mph) and obstacles  
are detected inside the detection areas.  
Once your vehicle stops, the visual  
indication and audio warning stops after  
a few seconds.  
Front Parking Aid Audible  
Warnings  
A warning tone sounds when there is an  
object within 70 cm (28 in) from the front  
bumper. As your vehicle moves closer to  
an object, the rate of the tone increases.  
The warning tone continuously sounds  
when an object is 30 cm (12 in) or less from  
the front bumper.  
Note: If the detected object is 30 cm (12 in)  
or less from your vehicle, visual indication  
remains on.  
SIDE PARKING AID  
What is the Side Parking Aid  
The front and rear outermost parking aid  
sensors map objects that are near to the  
sides of your vehicle.  
Side Parking Aid Limitations  
The sensor coverage is up to 60 cm (24 in)  
from the sides of your vehicle.  
259  
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing  
Parking Aids  
The side parking aid may not function if:  
If the transmission is in drive (D) or any  
other forward gear, the side sensing system  
provides audible and visual warnings.  
When your vehicle is moving slowly,  
obstacles are detected within 60 cm  
(24 in) and are inside the driving path of  
your vehicle. Once your vehicle reaches a  
standstill condition, the audible warning  
and visual indication stops after a few  
seconds.  
You switch your vehicle on, off and  
back on within a few seconds.  
Your vehicle remains stationary for over  
two minutes.  
The anti-lock brake system activates.  
The traction control system activates.  
Your vehicle is in park (P).  
The steering wheel angle information  
is not available. You must drive at least  
150 m (492 ft) above 30 km/h  
(19 mph) to reset the steering wheel  
angle information.  
Locating the Side Parking Aid  
Sensors  
Note: If you switch traction control off, the  
side sensing system also turns off.  
To reinitialize the system, drive the length  
of your vehicle.  
The side parking aid does not detect an  
object that is moving toward the side of  
your vehicle, for example another vehicle  
moving at a low speed, if it does not pass  
a front or rear parking aid sensor.  
If the transmission is in reverse (R), the side  
sensing system provides audible warnings.  
When your vehicle is moving slowly,  
obstacles are detected within 60 cm  
(24 in) and are inside the driving path of  
your vehicle. Once your vehicle reaches a  
standstill condition, the audible warning  
stops after a few seconds. Visual indication  
is always present in reverse (R).  
E190458  
The side parking sensors are in the front  
and rear bumpers.  
Side Parking Aid Audible Warnings  
If your vehicle is in neutral (N), the side  
sensing system provides visual indication  
only when your vehicle is moving slowly  
and there is a front or rear park aid  
obstacle detected, and the side obstacle  
is within 60 cm (24 in) from the side of  
your vehicle. Once your vehicle reaches a  
stop, the visual indication stops after a few  
seconds.  
When the side parking aid detects an  
object within the coverage area and the  
driving path of your vehicle, an audible  
warning sounds. As your vehicle moves  
closer to the object, the rate of the tone  
increases.  
260  
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing  
Parking Aids  
As the distance to the object  
PARKING AID INDICATORS  
decreases, the indicator blocks  
illuminate and move toward the vehicle  
icon.  
If there is no object detected, the  
distance indicator blocks are grey.  
Visual indication remains on when the  
transmission is in reverse (R). When you  
stop your vehicle, visual indication turns  
off after four seconds.  
If the parking aids are not available, the  
side distance indicator blocks do not  
display.  
PARKING AIDS  
TROUBLESHOOTING  
Parking Aids Information  
E190459  
Messages  
The system provides object distance  
If a fault is present in the parking aids, a  
warning message appears in the  
instrument cluster or the information  
display.  
indication through the information display.  
Message  
Action  
Park Pilot malfunction  
The system has malfunctioned. Have your  
vehicle checked as soon as possible.  
Check Park Pilot  
The system has malfunctioned. Have your  
vehicle checked as soon as possible.  
Front Park Pilot not available sensor  
blocked See Manual  
A sensor is blocked or the system has  
malfunctioned. Clean the bumper or  
remove any obstruction. If the message  
continues to appear, have your vehicle  
checked as soon as possible.  
Check front Park Pilot  
The system detects a condition that  
requires service. Have your vehicle checked  
as soon as possible.  
261  
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing  
Parking Aids  
Message  
Action  
Check rear Park Pilot  
The system detects a condition that  
requires service. Have your vehicle checked  
as soon as possible.  
Front Park Pilot On Off  
Rear Park Pilot On Off  
Displays the park aid status.  
Displays the park aid status.  
262  
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing