Driving your vehicle
Vehicle Auto Shut-off system
effectiveness. It also increases the
wear of the brake components.
Vehicle Auto Shut-off system
(if equipped)
The vehicle auto shut-off system is
designed to automatically shut off the
vehicle after a certain time the driver
sets to reduce fuel consumption and
energy consumption of the vehicle and
僅 If a tire goes flat while you are driving,
apply the brakes gently and keep the
vehicle pointed straight ahead while
you slow down. When you are moving
slowly enough for it to be safe to do
so, pull off the road and stop in a safe
place.
僅 Be cautious when parking on a hill.
Firmly engage the parking brake and
place the shift lever in P. If your vehi
cle is facing downhill, turn the front
to prevent carbon monoxide (CO) poi
-
soning.
-
wheels into the curb to help keep the
vehicle from rolling.
If your vehicle is facing uphill, turn the
front wheels away from the curb to
help keep the vehicle from rolling. If
there is no curb or if it is required by
other conditions to keep the vehicle
from rolling, block the wheels.
5
OMQ4A050356
僅 Under some conditions your parking
Requirement for activation
This system can be activated, when all of
the following requirements are satisfied.
僅 The ignition switch or ENGINE START/
STOP button is in ON position.
僅 The vehicle is in P (Park) position.
僅 The vehicle stops.
僅 The vehicle speed is under 3 km/h (2
mph).
僅 The driver's seat belt is unfastened.
僅 The door is opened.
brake can freeze in the engaged posi
tion. This is most likely to happen
when there is an accumulation of
snow or ice around or near the rear
brakes or if the brakes are wet. If
there is a risk that the parking brake
may freeze, apply it only temporarily
while you put the shift lever in P
(Parking) and block the rear wheels so
the vehicle cannot roll. Then release
the parking brake.
-
僅 Do not hold the vehicle on an incline
with the accelerator pedal. This can
cause the transmission to overheat.
Always use the brake pedal or parking
brake.
僅 The passenger's seat is not occupied.
Setting Shut-off Time
The driver can set the shut-off time on
the cluster LCD display.
The option can be found under the fol
-
lowing menu:
僅 Go to 'User Settings → Convenience
→ Vehicle Auto-Shut Off → 60 min./
5
53
