Exterior lights -> HIGH BEAM ASSIST for Your Land Rover Evoque SUV 2020

Exterior lights  
Unless required or prohibited by law,  
daytime running lamps can be disabled  
or enabled by your Dealer/Authorised  
To manually override to low beam from high  
beam, pull the stalk to the flash position (2) and  
High beam assist will be cancelled. To return to  
High beam assist, push the stalk to the high  
beam position (1) and then return it to the  
central position.  
Repairer.  
HEADLAMP COURTESY DELAY  
A green lamp in the instrument  
pack illuminates when High beam  
assist is selected.  
This feature operates whenever the lamps  
master switch is in the AUTO (5) position and  
the ignition is turned off. The headlamps will  
remain illuminated for up to 240 seconds.  
To turn off High beam assist, turn the main  
lighting control from Auto to headlamps.  
Note: The time delay may be changed via the  
Vehicle settings menu. See 56, VEHICLE  
INFORMATION AND SETTINGS MENU.  
This feature can be disabled/enabled via the  
Vehicle settings menu. See 56, VEHICLE  
INFORMATION AND SETTINGS MENU.  
Courtesy lamps can be switched off at any time  
by pressing the headlamps button on the  
Smart Key.  
Note: The following may affect the operation of  
High beam assist:-  
Highly reflective road signs.  
Vehicles with dim headlamps.  
Adverse weather conditions.  
Dirty sensor.  
HIGH BEAM ASSIST  
This feature of the Xenon lighting automatically  
selects and deselects high beam, under  
specific conditions of road lighting and in the  
absence of other vehicle’s lights. The system is  
only active when the ambient light drops below  
a predetermined level.  
Dirty, damaged, or misted windscreen.  
Note: The system cannot be relied upon to  
activate or de-activate high beam in all possible  
circumstances. It remains the driver’s  
responsibility to ensure correct use of the  
headlamps at all times.  
Note: It is not recommended that high beam  
assist is used while driving off road.  
For High beam assist to become operational,  
the main lighting switch must be in the AUTO  
position (5), with low beam headlamps  
selected.  
Note: Ensure that the forward facing sensors  
on the back of the rear view mirror are not  
blocked or obstructed.  
High beam assist will activate only when the  
vehicle speed exceeds 40km/h (25mph). The  
system will deactivate when vehicle speed  
drops below 24km/h (15mph).  
AUTO LAMPS WINDSCREEN WIPER  
DETECTION  
If Auto lamps is selected and the windscreen  
wipers are switched on for 20 seconds or  
more, the side lamps, tail lamps and  
headlamps will switch on automatically. When  
the wipers are switched off, the lamps will  
automatically switch off 2 minutes later.  
To manually select high beam, move the stalk  
to the high beam position as normal. To return  
to High beam assist, move the stalk back to the  
central position.  
39