Exterior lights
Exterior lights
LIGHTING CONTROL
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
6. Rear fog lamps. Will operate only while
sidelights, headlamps or Auto lamps are
selected. Turn the collar towards the
steering wheel and release. The instrument
pack warning lamp will illuminate.
Note: Do not use high beam where it may
distract other road users.
7. Front fog lamps. Will operate only while
sidelights, headlamps or Auto lamps are
selected. Turn the collar away from the
steering wheel and release.The instrument
pack warning lamp will illuminate.
2. Pull the control towards the steering wheel
and release to flash the high beam on and
off. The high beam will remain on for as
long as the switch is held.
3. Sidelights.
4. Headlamps.
DAYTIME RUNNING LAMPS
Daytime running lamps are LED lamps.
5. AUTO. With Auto lamps selected, when
ambient light fades and the ignition is on,
the side lamps, tail lamps, low beam
headlamps and licence plate lamps will
switch on automatically. Headlamp
courtesy delay, High beam assist and
Windscreen wipers detection may also be
activated.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
ꢀ
ꢀ
The engine is running.
The gear selector is out of park (automatic
transmission).
Note: Low exterior light levels, caused by
adverse weather conditions, may also
cause the autolamp system to activate.
ꢀ
The parking brake is not applied - market
dependent.
38
