Get Front seats -> STALLED ADJUSTMENT Guide for Land Rover Evoque SUV 2020

Front seats

1. Lumbar support adjustment.

2. Backrest adjustment.

The seat, head restraint, seat belt and airbags,

all contribute to the protection of the user.

Correct use of these components will give you

greater protection. Therefore, you should

always observe the following points:

3. Head restraint adjustment.

4. Height adjustment.

5. Forward and back adjustment.

6. Cushion angle adjustment.

To adjust the seats, the Smart Key must be

inside the vehicle.

Do not adjust the seat while the

vehicle is moving. Doing so could

cause loss of vehicle control and

personal injury.

STALLED ADJUSTMENT

If seat movement stops unexpectedly

during adjustment check for any

obstructions and remove.

Once any obstructions have been removed the

seat adjustment mechanism can be reset as

follows.

1. Sit in an upright position with the base of

your spine as far back as possible and the

seatback reclined no more than 30

degrees.

Operate the button again to continue the stalled

adjustment. When seat movement resumes

hold the button until the end of travel in that

direction has been reached. The seat position

can now be carried out as normal.

2. Do not move the driver's seat too close to

the steering wheel. Ideally, a minimum

distance of 254mm (10in) is

recommended between the breastbone

and the steering wheel airbag cover. Hold

the steering wheel in the correct position,

with your arms slightly bent.

Note: If no obstructions can be seen, but

normal adjustment cannot be carried out

without stalling, contact your Land Rover

Dealer/Approved Repairer.

ꢀ

Adjust the head restraint so that the top of

the head restraint is above the centre line of

the head.

SITTING IN THE CORRECT POSITION

The driver and front seat passenger

must not ride with the seat fully

reclined.

Position the seat belt so that it is mid-way

between your neck and your shoulder. Fit

the strap tightly across your hips, not

across your stomach.

Do not adjust the seat while the

vehicle is moving.

ꢀ

Ensure that your driving position is

comfortable and enables you to maintain

full control of the vehicle.

Front seats

For the passenger seat of a Coupe model,

press the memory button to store the

current settings. If the seat adjustment is

subsequently changed, press the memory

button to restore the original settings.

MEMORY SEATS

Front seat positions can be saved to vehicle

memory.

Once you have adjusted the power operated

driver’s seat and the exterior mirrors, the

vehicle can memorise the settings for future

use. See 48, EXTERIOR MIRRORS.

EASY ENTRY/EXIT

When Easy entry/exit is configured, the driver’s

seat will automatically lower when the ignition

is switched off and the door release lever is

used. Upon returning to the vehicle, when the

driver’s door is closed and the seat belt is

fastened, the seat will return to it’s previously

set position.

Note: Some vehicle specifications require the

ignition to be turned on.

See 56, VEHICLE INFORMATION AND

SETTINGS MENU.

HEAD RESTRAINTS

1. On the driver’s seat, press the memory

store button to activate the memory

function. The switch indicator will

illuminate.

Adjust the head restraint so that the

top of the head restraint is above the

centre line of the head. An incorrectly

adjusted head restraint increases the

risk of death or serious injury in the

event of a collision.

2. Press one of the preset buttons within 5

seconds to memorise the current settings.

Memory (1, 2 or 3) Settings Saved will be

displayed on the message centre,

accompanied by an audible chime to

confirm the settings have been saved to

memory.

Do not drive, or carry passengers with

the head restraints removed from

occupied seats. The absence of a

correctly adjusted head restraint

increases the risk of neck injury in the

event of a collision.

Note: A seat position will be saved to

memory only during the 5 second active

period.

Never adjust the head restraints while

the vehicle is in motion.

Note: Any existing settings will be

over-written when a new position is saved

to memory.

Always store a removed head restraint

securely.

To recall a saved position, press the

relevant preset button (2). Memory (1, 2 or

3) Recalled will be displayed in the

message centre.

Front seats -> STALLED ADJUSTMENT for Your Land Rover Evoque SUV 2020

Popular Manuals