Gearbox -> GEAR SHIFT INDICATOR for Your Land Rover Evoque SUV 2020

Gearbox  
If the engine is switched off with N selected, the  
system will wait for 10 minutes before  
selecting P. This time delay allows the vehicle  
enough time to be conveyed through a car  
wash. Do not use for vehicle recovery  
purposes.  
MANUAL TRANSMISSION  
If your vehicles requires recovery by towing,  
the recovery must be undertaken by qualified  
personnel. See 216, RECOVERY.  
DRIVE SELECTOR FAILS TO ELEVATE  
If the drive selector is obstructed, remove the  
obstruction and then start the engine. The  
selector should elevate as normal.  
Selection of reverse gear is prevented  
when the vehicle is travelling in excess  
of 24km/h (15mph). Never attempt to  
engage reverse gear while the vehicle is  
in forward motion. This may result in  
serious transmission damage and  
costly repairs.  
If the selector still fails to elevate, even if there  
is no obstruction, a fault in the system is  
indicated. The selector can still be used in the  
lowered position. Ensure that P is selected  
before engine switch off. Have the fault  
rectified at the earliest opportunity.  
GEAR SHIFT INDICATOR  
TRANSMISSION FAULT  
The gear shift indicator illuminates  
briefly at the recommended gear  
change point (upshift).  
In the event that the transmission develops a  
fault, a warning message may be displayed in  
the message centre and only limited gears may  
become available. You should seek qualified  
assistance immediately.  
The shift indicator will not illuminate while  
Cruise control is active and is not being  
overridden by pressing the throttle pedal.  
Note: This warning indicator is only a guide. It  
remains the responsibility of the driver to  
operate the vehicle in an appropriate manner  
for the prevailing conditions.  
84