Heating and ventilation
A current heating cycle will be cancelled if the
engine is started. Any programmed heating
cycle may be cancelled by touching the
relevant power soft key on the timer set up
menu or the Power soft key on the Timed
Climate information home menu.
The system may not operate, or will switch off
automatically, if:
ꢀ
ꢀ
ꢀ
Fuel level is low.
The vehicle’s battery charge is low.
Engine coolant temperature is at or above
its required temperature.
ꢀ
The engine has not been started since the
last programme cycle.
TIMED CLIMATE REMOTE CONTROL
The dedicated remote control has a range of
approximately 100m (328ft). Press and hold
the ON button for two seconds.
The remote control LED indicator signals other
states and conditions for the timed climate as
follows:
Note: Avoid touching the antenna when
operating the ON or OFF button.
ꢀ
Illuminates red for 2 seconds when the
OFF button is pressed, to indicate that the
program has stopped.
ꢀ
Flashes green or red for 2 seconds then
stops when the ON or OFF buttons are
pressed, to indicate that no action has been
taken.
ꢀ
ꢀ
Illuminates orange for 2 seconds before
showing green or red, to indicate that the
remote battery is low.
Flashes orange for 5 seconds to indicate
that no action has been taken and the
remote battery should be replaced.
1. On button.
REPLACING REMOTE CONTROL
BATTERIES
2. Off button.
3. LED (operation indicator).
4. Antenna.
Press and hold the ON button for
approximately two seconds. The green LED will
illuminate for 2 seconds to confirm that a
program has been initiated. The LED flashes
once every 2 seconds to indicate that the
program is active.
The timed climate program will continue for 30
minutes and then switch off automatically to
prevent the vehicle battery from discharging. It
also turns off automatically if the engine is
started.
67
