Get PARKING AIDS Guide for Land Rover Evoque SUV 2020

Parking aids

PARKING AIDS

1. Parking aid on/off switch. The switch

indicator will illuminate.

Systems using the same frequency

band as the front parking sensors, may

cause irregular tones to be emitted.

When reverse gear is selected, the front

and rear parking sensors are activated

automatically.

Front sensors will remain active as long as the

vehicle's speed does not exceed 16km/h

(10mph).

To turn off, press the button. The indicator

will extinguish.

With automatic transmission, selecting N from

R will keep front and rear sensors active.

2. Approximate sensor range -600mm (24in).

When objects are detected, the parking aid

emits a warning tone which increases in

frequency as the vehicle gets closer to the

object and then becomes constant when the

obstacle is within 300mm (12in).

3. Approximate sensor range -1500mm

(60in).

It remains the driver’s responsibility

to detect obstacles and estimate the

vehicle’s distance from them. Some

overhanging objects, barriers, chain

link fences, small children, animals,

thin obstructions or painted surfaces

may not be detected by the system.

Note: The front parking aid provides an audible

proximity warning when driving forwards and

when reversing.

Parking aids

TOWING

REAR VIEW CAMERA

The rear sensors are automatically disabled

when a trailer with an approved electrical

connector is connected.

It remains the driver's responsibility

to detect obstacles and estimate the

vehicle's distance from them when

reversing.

Note: Trailers fitted with LED lights will not

disable the rear parking aids sensors. When

reverse gear is selected, the attached trailer will

be detected as an obstacle.

When Reverse (R) is selected the camera

provides a wide-angle rear view colour image

on the touch screen.

The camera display has priority over the

parking aid display. To view the parking aid

display instead or to cancel camera display at

any time, briefly touch the display.

CLEANING THE SENSORS

When washing the vehicle do not aim

high pressure water jets directly at the

sensors. Do not use abrasive materials

or hard/sharp objects to clean the

sensors. Only use approved vehicle

shampoo.

To adjust the camera settings, touch and hold

anywhere on the touch screen to access the

user options screen.

The display also incorporates graphic overlays,

indicating vehicle direction, width and

proximity to surrounding objects.

The sensors should be kept clean to maintain

accuracy and performance.

SYSTEM FAULT

If a system fault is detected, a long

high-pitched tone will sound and the switch

indicator will flash. A message will be displayed

in the message centre. Contact your Dealer/

Authorised Repairer as soon as possible.

Parking aids

A. Solid line: The projected path based on

current steering wheel position.

B. Dotted line: The safe working width of the

vehicle (including exterior mirrors).

C. Tailgate access guideline: Do not reverse

beyond this point if tailgate access is

required.

D. Parking sensor activation: A coloured area

appears, to indicate which rear sensor(s)

has been activated.

E. User option. Touch to enable/disable A, B

& C.

F. User option. Touch to enable/disable D.

G. User option. Touch to enable/disable Hitch

Assist guidance lines.

Some overhanging objects or barriers

which could cause damage to the

vehicle, may not be detected by the

camera.

100

Park assist

Park assist sensors may not detect

some obstructions (e.g. narrow posts,

small objects close to the ground and

some objects with dark non-reflective

surfaces).

PARK ASSIST

Park assist is a driving aid only. It

remains the driver's responsibility to

drive with due care and attention

during parking manoeuvres.

Park assist may not detect moving

objects such as children and animals,

until they are dangerously close.

Always use extreme caution when

manoeuvring.

1. To activate, press the Park Assist button

while driving forwards at less than 30km/h

(19mph). The indicator lamp in the button

illuminates.

Note: If vehicle speed exceeds 30km/h

(19mph), SLOW DOWN! is displayed until

speed decreases to less than 30km/h

(19mph) again. If vehicle speed is not

reduced, Park Assist is de-activated and

the indicator light in the button is

extinguished.

Note: For the system to operate effectively,

maintain a distance of 0.5 to 1.5 meters

(1.6 to 4.9 ft) between the vehicle and the

line of parked vehicles / obstacles in which

you want to park.

3. When first activated Park Assist searches

for a space on the front passenger side of

the vehicle. To search for a space on the

driver’s side, signal a turn in that direction.

2. The Park Assist display appears in the

message centre and shows the Searching

message and graphic.

101

PARKING AIDS for Your Land Rover Evoque SUV 2020

Popular Manuals