Tyre pressure monitoring system
If a non TMP system temporary spare wheel is
fitted, the system will automatically recognise
the change in wheel positions. After
approximately 10 minutes of driving above
25km/h (18mph), the message FRONT (REAR)
RIGHT(LEFT) TYRE PRESSURE NOT
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The vehicle needs to be stationary for
15 minutes during the sensor fitment before
the system is ready to detect the new sensor.
The vehicle must be driven for a minimum of
fifteen minutes after the sensor change, and
then remain stationary for fifteen minutes to
activate full TPM system operation.
MONITORED will be displayed, accompanied
by illumination of the warning lamp.
The warning lamp will first flash and then
illuminate continuously. Extended use of the
temporary spare wheel will trigger the message
TYRE PRESSURE MONITORING SYSTEM
FAULT.
If the TPM system warning for any wheel does
not clear, even after ensuring correct inflation
and driving for more than ten minutes above
25 km/h (18 mph), you should seek qualified
assistance as soon as possible.
This TPM system display sequence will be
activated at every ignition cycle, until the
temporary spare wheel is replaced by a full size
TPM system road wheel.
Note: If in use, always replace the temporary
spare wheel before having a TPM system fault
investigated.
If any message fails to clear after rectifying the
fault, consult your Dealer/ Authorised Repairer.
TYRE CHANGE
Valve stem seal, washer, nut, valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle may result if these
precautions are not taken.
Any tyre changes must be carried out by a
qualified technician. Great care must be taken
during removal and refitting of tyres to avoid
damaging the sensor.
REPLACEMENT SENSOR
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
202
