Windows
A further press will stop movement of the
blind.
2. Within ten seconds attempt to raise the
window again, anti-trap will prevent
closure and lower the window slightly.
Alternatively, push from the front of the
switch to the second position and hold
until the blind reaches the desired position,
then release.
3. Attempt to close the window for a third
time, this time hold the switch in the close
position. Hold until closed.
Note: If this procedure fails to remove the
blockage, the window operation may need to
be reset.
WINDOW RESET
If the battery is disconnected or the power
supply is interrupted, the windows must be
reset.
RESONANCE WITH LOWERED
WINDOWS
Once the power supply is restored, reset as
follows:
if a resonance or booming sound occurs when
a rear window is open, lowering an adjacent
front window by approximately 25mm (1 inch)
will eliminate the condition.
1. Close the window fully.
2. Release the switch, then lift it to the close
position and hold for 1 second.
3. Repeat the procedure on each window.
ANTI-TRAP PROTECTION
Closing a window or roof blind onto
any part of the body can result in
serious injury.
Before closing a window or the roof
blind, ensure that no occupants have
any part of their body in a position
where it could be trapped. Even with
an anti-trap system death or serious
injury could occur.
Anti-trap protection will stop window or roof
blind movement if an obstruction or resistance
is detected. Check the window or roof blind and
its aperture and remove any obstructions (e.g.
ice, etc.).
If it is still necessary to raise the window, the
override procedure is as follows:
1. Attempt to close the window, anti-trap will
prevent closure and lower the window
slightly.
47
