If Trouble Arises -> Battery Runs Out for Your Mazda Cx-5 SUV 2023

If Trouble Arises  
Battery Runs Out  
Jump-Starting  
Jump-starting is dangerous if done incorrectly. So follow the procedure carefully. If you feel  
unsure about jump-starting, we strongly recommend that you have a competent service  
technician do the work.  
WARNING  
Follow These Precautions Carefully:  
To ensure safe and correct handling of the battery, read the following precautions carefully  
before using the battery or inspecting it.  
Keep flames and sparks away from open battery cells and do not allow metal tools to  
contact the positive ( ) or negative ( ) terminal of the battery when working near a battery.  
Do not allow the positive ( ) terminal to contact the vehicle body:  
Flames and sparks near open battery cells are dangerous. Hydrogen gas, produced during  
normal battery operation, could ignite and cause the battery to explode. An exploding battery  
can cause serious burns and injuries. Keep all flames including cigarettes and sparks away  
from open battery cells.  
Keep all flames and sparks away from open battery cells because hydrogen gas is  
produced from open battery cells while charging the battery or adding battery fluid:  
Flames and sparks near open battery cells are dangerous. Hydrogen gas, produced during  
normal battery operation, could ignite and cause the battery to explode. An exploding battery  
can cause serious burns and injuries. Keep all flames including cigarettes and sparks away  
from open battery cells.  
Do not jump-start a frozen battery or one with a low fluid level:  
Jump-starting a frozen battery or one with a low fluid level is dangerous. It may rupture or  
explode, causing serious injury.  
Connect the negative cable to a good ground point away from the battery:  
Connecting the end of the second jumper cable to the negative ( ) terminal of the discharged  
battery is dangerous.  
A spark could cause the gas around the battery to explode and injure someone.  
7-13  
If Trouble Arises  
Battery Runs Out  
Route the jumper cables away from parts that will be moving:  
Connecting a jumper cable near or to moving parts (cooling fans, belts) is dangerous. The  
cable could get caught when the engine starts and cause serious injury.  
CAUTION  
Use only a 12 V booster system. You can damage a 12 V starter, ignition system, and other  
electrical parts beyond repair with a 24 V power supply (two 12 V batteries in series or a 24 V  
motor generator set).  
1. Move the booster vehicle so that its battery is as close as possible to your vehicle's  
battery.  
2. Make sure that the power such as for the headlights and air conditioner is turned off.  
3. Remove the battery cover.  
4. Turn off the booster vehicle's engine and connect the jumper cables in the following  
order.  
Make sure that the jumper cables are securely connected so that they do not disconnect  
due to engine vibrations.  
1st lead  
Positive (+) terminal on the discharged battery  
Positive (+) terminal on booster vehicle's battery  
2nd lead  
Negative (-) terminal on booster vehicle's battery  
7-14  
If Trouble Arises  
Battery Runs Out  
Location shown in the figure (do not connect to the negative (-) terminal of the  
battery)  
Connect cables in numerical order  
and disconnect in reverse order.  
Jumper cables  
Discharged battery  
Booster battery  
5. Start the booster vehicle's engine and rev the engine.  
6. Start the engine of your vehicle. Run the engines for about 3 minutes to temporarily  
charge the battery of your vehicle.  
7. Disconnect the jumper cables in the reverse order of their connection.  
8. Install the battery cover.  
9. Have your vehicle inspected by an Authorized Mazda Dealer as soon as possible.  
NOTE  
Verify that the covers are securely installed.  
7-15