General notes -> Declarations of conformity and notes on driving in different countries for Your Mercedes C Class 4 Door 2023

General notes  
91  
Authorized Representative (UK-GB):  
Name:  
Address:  
Contact person:  
&
WARNING Risk of accident due to objects  
in the driver's footwell  
15-07-2022  
(Date)  
[B. Schuchhardt]  
Signature  
Objects in the driver's footwell may impede  
pedal travel or block a depressed pedal.  
This jeopardises the operating and road safety  
of the vehicle.  
Diagnostics connection  
This declaration is issued under the sole responsi-  
bility of the mentioned Representative. The sub-  
ject equipment under declaration is in conformity  
with the UK-GB Regulation(s) below:  
Statutory Instruments 2016 No. 1091  
The Electromagnetic Compatibility Regulations  
2016  
Below designated standards were taken confer-  
ring a presumption of conformity with the relevant  
UK-GB regulations:  
BS EN IEC 55014-1: 2021  
BS EN IEC 55014-2: 2021  
Authorized Representative responsible for making  
this declaration:  
Name: Dunlop Tech GmbH  
The diagnostics connection is a technical inter-  
face in the vehicle. It is used, for example, during  
repair and maintenance work or for reading out  
vehicle data in a specialist workshop. Diagnostic  
devices should therefore be connected only at a  
qualified specialist workshop.  
#
Stow all objects in the vehicle securely  
so that they cannot get into the driver's  
footwell.  
#
Always fit the floor mats securely and as  
prescribed in order to ensure that there  
is always sufficient room for the pedals.  
&
WARNING Risk of accident due to con-  
necting devices to the diagnostics con-  
nection  
#
Do not use loose floor mats and do not  
place floor mats on top of one another.  
If you connect devices to the diagnostics con-  
nection of the vehicle, the function of vehicle  
systems and operating safety may be  
impaired.  
*
NOTE Battery discharging from using devi-  
ces connected to the diagnostics connec-  
tion  
Using devices at the diagnostics connection  
drains the battery.  
#
For safety reasons, we recommend that  
you only use and connect products  
approved by a Mercedes-Benz service  
centre.  
Authorized Representative: Bernd Schuchhardt  
Address: Offenbacher Landstraße 8, 63456  
Hanau, Germany  
#
Check the charge level of the battery.  
F206 0105 02  
General notes  
92  
R
R
R
Connecting and using another device with the  
diagnostics connection can have the following  
effects:  
Service and maintenance work  
Repair work  
Modifications as well as installations and con-  
versions  
Work on electronic components  
Plug-in hybrid: work on the hybrid system  
Vehicles with 48 V on-board electrical system:  
work on the high-voltage component of the 48  
V on-board electrical system  
#
If the charge level is low, charge the bat-  
tery, e.g. by driving a considerable dis-  
tance.  
R
Malfunctions in the vehicle system  
Please also note the information about the 12 V  
battery and short-distance trips in the "Driving  
and Parking" chapter (/ page 268).  
R
Permanent damage to vehicle components  
R
R
R
Please refer to the warranty terms and conditions  
for this matter.  
Moreover, connecting equipment to the diagnos-  
tics connection can lead to emissions monitoring  
information being reset, for example. This may  
lead to the vehicle failing to meet the require-  
ments of the next emissions inspection during the  
main inspection.  
Mercedes‑Benz recommends a Mercedes‑Benz  
service centre.  
Vehicle registration  
Mercedes-Benz may ask its service centres to  
carry out technical inspections on certain vehi-  
cles. The quality or safety of the vehicle is  
improved as a result of the inspection.  
Mercedes-Benz can only inform you about vehicle  
checks if Mercedes-Benz has your registration  
data.  
Qualified specialist workshop  
A qualified specialist workshop has the necessary  
special skills, tools and qualifications to correctly  
carry out any necessary work on your vehicle.  
This particularly applies to safety-relevant work.  
Always have the following work carried out on  
your vehicle at a qualified specialist workshop:  
R
Safety-relevant work  
F206 0105 02