For emergencies -> Tools and jack for Your Mitsubishi Outlander SUV 2020

Tools and jack  
4. Check the coolant level in the reserve  
tank (B and C).  
The storage location of the tools and jack  
should be remembered in case of an emer-  
gency.  
WARNING  
Make sure that the engine and the Plug-in  
Hybrid EV system have cooled down be-  
fore removing the radiator cap (D) and  
the reserve tank cap (E), because hot  
steam or boiling water will otherwise gush  
from the filler port and may scald you.  
l
l
CAUTION  
Do not add coolant while the engine is hot.  
Suddenly adding cold coolant could damage  
the engine. Wait for the engine to cool down,  
then add coolant a little at a time.  
9
6. Examine the radiator hoses for coolant  
leakage and the drive belt for looseness  
or damage.  
Full  
Full  
If there is anything wrong with the cool-  
ing system or drive belt, we recommend  
you to have it checked and repaired.  
Low  
Low  
Tools and jack  
Storage  
B: Reserve tank for engine cooling  
C: Reserve tank for EV cooling system  
1- Tools  
2- Jack  
5. Add coolant to the radiator and/or re-  
serve tank if necessary. (Refer to the  
“Maintenance” section.)  
The tools are stowed on the right side of the  
luggage area.  
The jack is stowed in the luggage floor box.  
9-06  
For emergencies  
OGGE20E1  
Tyre repair kit  
Tools  
NOTE  
Tyre repair kit  
The business name, full address of the  
manufacturer and of his authorized repre-  
sentative and the designation of the jack  
are described in the EC declaration of  
conformity.  
This kit enables emergency repair of a small  
puncture in the tread area of a tyre that has  
run over a nail, screw, or similar object.  
Storage  
To remove  
The tyre repair kit is stored beneath the lug-  
gage floor board of the luggage compartment.  
1. Raise the luggage floor board.  
Refer to “Luggage floor box” on page  
8-83.  
2. Remove the band (A) and take out the  
jack.  
1- Jack bar  
2- Wheel nut wrench  
9
Jack  
The jack is used only for the purpose of  
changing a tyre when a tyre is punctured.  
NOTE  
The jack is maintenance-free.  
l
l
The jack is in conformity with EC law as ap-  
proximated by the Machinery Directive  
2006/42/EC.  
The EC declaration of conformity is attached  
to the section “Declaration of Conformity”  
in the end of this owner’s manual.  
To store  
l
Perform the removal steps in reverse.  
For emergencies  
9-07  
OGGE20E1