Get Starting and driving -> Parking Guide for Mitsubishi Outlander SUV 2020

Parking

If there is a malfunction in the system, the

warning lamp will come on. In addition, the

warning display appears on the information

screen in the multi information display.

Under normal conditions, the warning lamp

only comes on when the operation mode is

put in ON and goes off a few seconds later.

Parking on a hill

NOTE

If you start driving without releasing the

Electric parking brake, the warning display

will appear.

To prevent the vehicle from rolling, follow

these procedures:

Parking on a downhill slope

Turn the front wheels towards the kerb and

move the vehicle forward until the kerb side

wheel gently touches the kerb.

Apply the parking brake and press the electri-

cal parking switch.

CAUTION

When the Electric parking brake warning

If the driver’s foot contacts the accelerator

pedal in the condition that the Electric park-

ing brake can be released by an automatic

operation, the Electric parking brake may be

released automatically.

lamp does not illuminate or remains illumi-

nated when the operation mode of the power

switch is put in ON, or comes on while driv-

ing, the Electric parking brake may not be

applied or released. Immediately contact the

nearest MITSUBISHI MOTORS Authorized

Service Point. For details, refer to “Electric

parking brake warning lamp” on page 6-56.

When parking your vehicle while the Elec-

tric parking brake warning lamp is illumina-

ted, park the vehicle on level and stable

ground, put the select position to “P”

(PARK) and place chocks, blocks, or stones

behind and in front of the tyres to prevent

the vehicle from moving.

If necessary, apply chocks to wheels.

Parking on an uphill slope

Turn the front wheels away from the kerb and

move the vehicle back until the kerb side

wheel gently touches the kerb.

Apply the parking brake and press the electri-

cal parking switch.

Warning display

Warning lamp

If necessary, apply chocks to wheels.

Parking with the engine run-

ning

Warning display

Never leave the engine running while you

take a short sleep/rest. Also, never leave the

engine running in a closed or poorly ventila-

ted place.

Parking

To park the vehicle, firmly apply the parking

brake, and then press the electrical parking

switch to lock the wheels.

7-06

Starting and driving

OGGE20E1

Steering wheel height and reach adjustment

Steering wheel height and

reach adjustment

WARNING

Inside rear-view mirror

Leaving the engine running risks injury

or death from accidentally moving the se-

lector lever or the accumulation of toxic

exhaust fumes on the passenger compart-

ment.

Adjust the rear-view mirror only after making

any seat adjustments so you have a clear

view to the rear of the vehicle.

1. Release the lever while holding the

steering wheel up.

2. Adjust the steering wheel to the desired

position.

3. Securely lock the steering wheel by pull-

ing the lever fully upward.

Type 1

Where you park

WARNING

Do not park your vehicle in areas where

combustible materials such as dry grass

or leaves can come in contact with a hot

exhaust, since a fire could occur.

Type 2

When leaving the vehicle

Always carry the key and lock all doors and

the tailgate when leaving the vehicle unatten-

ded.

Always try to park your vehicle in a well lit

area.

A- Locked

B- Release

WARNING

Do not attempt to adjust the rear-view

mirror while driving. This can be danger-

ous.

CAUTION

When you leave the vehicle, be sure that you

have stopped the Plug-in Hybrid EV System.

The engine may start suddenly by a remain-

ing amount decline of the drive battery.

WARNING

Do not attempt to adjust the steering

Always adjust the mirror before driving.

wheel while you are driving the vehicle.

Adjust the rear-view mirror to maximize the

view through the rear window.

Starting and driving

7-07

OGGE20E1

Outside rear-view mirrors

When the headlamps of the vehicles behind

you are very bright, the reflection factor of

the rear-view mirror is automatically changed

to reduce the glare.

To adjust the vertical mirror

position

To reduce the glare

Type 1

The lever (A) at the bottom of the mirror can

be used to adjust the mirror to reduce the

glare from the headlamps of vehicles behind

you during night driving.

It is possible to move the mirror up and down

to adjust its position.

When the operation mode of the power

switch is put in ON, the reflection factor of

the mirror is automatically changed.

To adjust the mirror position

1- Normal

2- Anti-glare

It is possible to move the mirror up/down and

left/right to adjust its position.

Type 2

NOTE

Do not hang items on, or spray glass cleaner

on the sensor (1), as reduced sensitivity

could result.

Outside rear-view mirrors

To adjust the mirror position

The outside rear-view mirrors can be operat-

ed when the operation mode is put in ON or

ACC.

7-08

Starting and driving

OGGE20E1

Outside rear-view mirrors

2. Press the switch (B) to the left, right, up

or down to adjust the mirror position.

After placing the operation mode in OFF, it is

possible to retract and extend the mirrors us-

ing the mirror retractor switch for approxi-

mately 30 seconds.

WARNING

Do not attempt to adjust the rear-view

mirrors while driving. This can be dan-

gerous.

Always adjust the mirrors before driving.

Your vehicle is equipped with convex type

mirrors.

Please take into consideration, that ob-

jects you see in the mirror will look small-

er and farther away compared to a nor-

mal flat mirror.

1- Up

2- Down

3- Right

4- Left

3. Return the lever (A) back to the middle

position (•).

Retracting and extending the

outside mirrors

The outside mirror can be folded in towards

the side window to prevent damage when

parking in narrow areas.

Do not use this mirror to estimate dis-

tance of following vehicles when changing

lanes.

1. Place the lever (A) to the same side as

the mirror whose adjustment is desired.

CAUTION

Do not drive the vehicle with the mirror fol-

ded in.

It is possible to retract and extend the mir-

rors by hand. After retracting a mirror using

the mirror retractor switch, however, you

should extend it by using the switch again,

not by hand. If you extended the mirror by

hand after retracting it using the switch, it

would not properly lock in position. As a re-

sult, the mirror could move because of the

wind or vibration while you are driving, and

this may limit the driver’s rearward visibili-

ty.

The lack of rearward visibility normally pro-

vided by the mirror could lead to an acci-

dent.

Retracting and extending the

mirrors using the mirror retrac-

tor switch

With the operation mode in ON or ACC,

push the mirror retractor switch to retract the

mirrors. Push it again to extend the mirrors to

their original positions.

L- Left outside mirror adjustment

R- Right outside mirror adjustment

Starting and driving

7-09

OGGE20E1

Outside rear-view mirrors

The heater will be turned off automatically in

approximately 15 to 20 minutes depending

on the outside temperature.

NOTE

Be careful not to get your hands trapped

while a mirror is moving.

If you move a mirror by hand or it moves af-

ter hitting a person or object, you may not be

able to return it to its original position using

the mirror retractor switch. If this happens,

push the mirror retractor switch to place the

mirror in its retracted position and then push

the switch again to return the mirror to its

original position.

Functions can be modified as stated below.

Please consult a MITSUBISHI MOTORS

Authorized Service Point.

On vehicles equipped with the Smartphone-

link Display Audio (SDA) or the Smart-

phone-link Display Audio (SDA) navigation

system, screen operations can be used to

make the adjustment. Refer to the separate

owner’s manual for details.

Automatically extend when the operation

mode is put in ON, and automatically re-

tract when the driver’s door is opened af-

ter the operation mode is put in OFF.

Automatically extend when the vehicle

speed reaches 30 km/h (19 mph).

Deactivate the automatic extension func-

tion.

•

When freezing has occurred and mirrors fail

to operate as intended, please refrain from

repeated pushing of the retractor switch as

this action can result in burn-out of the mir-

ror motor circuits.

•

NOTE

Retracting and extending the

mirrors without using the mir-

ror retractor switch

The heated mirror can be set so that it can

turn on automatically only once if the ambi-

ent temperature becomes low, when the op-

eration mode is put in ON.

Heated mirror

To demist or defrost the outside rear-view

mirrors, press the rear window demister

switch.

The indication lamp (A) will illuminate while

the demister is on.

The mirrors automatically retract or extend

when the doors and tailgate are locked or un-

locked using the keyless entry system or the

keyless operation function.

Refer to “Keyless operation system: To oper-

ate using the key-less operation function,

Keyless entry system” on pages 4-09 and

4-03.

For further information, we recommend you

to consult a MITSUBISHI MOTORS Au-

thorized Service Point. On vehicles equipped

with the Smartphone-link Display Audio

(SDA) or the Smartphone-link Display Au-

dio (SDA) navigation system, screen opera-

tions can be used to make the adjustment.

Refer to the separate owner’s manual for de-

tails.

7-10

Starting and driving

OGGE20E1

Power switch

Operation mode of the power

switch and its function

CAUTION

If the power switch operation is not smooth

and feels like it is sticking, do not operate

the switch. Immediately contact

MITSUBISHI MOTORS Authorized Serv-

ice Point.

Power switch

In order to prevent theft, the Plug-in Hybrid

EV System will not start unless a preregis-

tered keyless operation key is used. (Immo-

bilizer function)

If you are carrying the keyless operation key,

you can start the Plug-in Hybrid EV System.

OFF

The indication lamp on the power switch

turns off.

The operation mode cannot be put in OFF

unless the electrical parking switch is press-

ed.

NOTE

When operating the power switch, press the

switch all the way in. If the switch is not

fully pressed, the Plug-in Hybrid EV System

may not start or the operation mode may not

change. If the power switch is pressed cor-

rectly, there is no need to hold the power

switch down.

When the battery in the keyless operation

key has worn out, or the keyless operation

key is out of the vehicle, a warning display

will appear.

ACC

Electrical devices such as the audio and ac-

cessory socket can be operated. Can be used

when the Ready indicator is off.

The indication lamp on the power switch illu-

minates orange.

All vehicle’s electrical devices can be operat-

ed.

CAUTION

The indication lamp on the power switch illu-

minates blue. The indication lamp goes off

when the Plug-in Hybrid EV System is oper-

ating.

The indication lamp (A) will flash orange

when there is a problem or malfunction in

the keyless operation system. Never drive if

the indication lamp on the power switch is

flashing orange. Immediately contact

MITSUBISHI MOTORS Authorized Serv-

ice Point.

Starting and driving

7-11

OGGE20E1

Starting and driving -> Parking for Your Mitsubishi Outlander SUV 2020

Related Topics

General information

Charging

Locking and unlocking

Seats and seat belts

Instruments and controls

Starting and driving

For pleasant driving

For emergencies

Vehicle care

Maintenance

Specifications