Instruments and controls -> ThermaClear Heated Windscreen button for Your Nissan Juke SUV 2020

THERMACLEAR HEATED  
WINDSCREEN BUTTON  
If damage occurs to the windscreen have the  
ThermaClear system checked by a NISSAN  
dealer or qualified workshop.  
Wiper operation  
Turn the switch clockwise to the intermittent (  
THERMACLEAR HEATED  
WINDSCREEN (where fitted)  
,
) position or continuous (  
wiper operation.  
,
) position for  
Reduced performance or deactivation of the  
ThermaClear Heated Windscreen may be no-  
ticed to preserve the battery. This is not a mal-  
function.  
To stop the wiper operation, turn the switch back to  
the OFF position.  
Washer operation:  
NISSAN recommends using the ThermaClear  
system to support defogging of the wind-  
screen. For more information, see “Heater and  
air conditioner” in the “4. Display screen,  
heater and air conditioner, and audio system”  
section.  
To operate the washer, push the lever towards the  
front of the vehicle  
until the desired amount of  
washer fluid is spread on the rear window.The wiper  
will automatically operate several times.  
NAA2014  
Wiper drip wipe system (where fitted):  
Models with ThermaClear Heated Windscreen (where  
fitted)  
ThermaClear Heated Windscreen On/Off  
During use of the ThermaClear system the  
Stop/Start System is unavailable.  
The wiper will also operate once about 3 seconds  
after using the washer. This operation is to wipe  
washer fluid that has dripped on the windscreen.  
j
A
To defog/defrost the windscreen glass, start the en-  
gine and push the ThermaClear button A . The indi-  
cator light will come on. Push the button again to  
turn the ThermaClear system off.  
The mode can be turned off. For details, see “Vehicle  
information display” earlier in this section.  
j
Reverse synchronisation function  
(where fitted)  
When the windscreen wiper switch is in either the  
intermittent or <AUTO> (where fitted), low or high  
speed position, placing the shift lever in the R (Re-  
verse) position will operate the rear window wiper.  
The ThermaClear system will turn off automatically  
after approximately 6 minutes — if the windscreen  
clears before this time, push the button again to  
turn the ThermaClear system off.  
NOTE  
The mode can be turned off. For details, see “Vehicle  
information display” earlier in this section.  
The ThermaClear system can only be  
activated while the engine is running.  
Before activating the ThermaClear system  
make sure to remove excess snow/ice from  
the windscreen  
NOTE  
In the <AUTO> position (where fitted), the rear  
wiper will not begin to sweep when the shift lever  
is placed in the R position. It waits until the front  
wipers have made the first sweep.  
Electrical conductors embedded in the wind-  
screen provide the heating of the windscreen.  
92 Instruments and controls