Get Instruments and controls -> Wiper and washer switch Guide for Nissan Juke SUV 2020

WIPER AND WASHER SWITCH

: High (

eration.

) – for continuous high speed op-

➂

•

WARNING

In freezing temperatures the washer fluid may

freeze on the windscreen and obscure your vi-

sion. Warm the windscreen with the defogger be-

fore you wash it.

: — for a single sweep operation of the wiper.

➃

Washer operation

Pull the lever towards you

to operate the washer.

➄

Wiper drip wipe system (where fitted):

CAUTION

The wiper will also operate once about 3 seconds

after using the washer. This operation is to wipe

washer fluid that has dripped on the windscreen.

Do not open/release the bonnet when the

•

front wiper arms are raised from their original

position.

NIC2979

Type B (with <AUTO> mode)

Pulling up the wiper arms:

The wiper arms should be in the service (up) posi-

tion when replacing the wiper blades.

Do not operate the washer continuously for

more than 15 seconds.

•

The windscreen wiper and washer can be operated

when the ignition switch is in the ON position.

Do not operate the washer if the reservoir tank

is empty or frozen.

•

To pull the wiper arms up to the service position:

within 1 minute of placing the ignition switch in the

Wiper operation

Move the lever up or down to operate the wiper at

OFF position, push the lever up

twice in quick

➃

the following speeds:

succession. The wiper operation stops in mid-op-

eration. The wiper arms can then be pulled up to

the service position.

WINDSCREEN

: Intermittent (

) — Type A or <AUTO> —

➀

•

Type B (where fitted) operates the rain-sensing

auto wiper system. (See “Rain sensor (where

fitted)” later in this section.).

To return the wiper arms to their normal position,

place the wiper arms in the down position and then

push the lever

up once.

➃

–

The intermittent operation speed can be ad-

justed by rotating the ring forward

For more information on replacing the windscreen

wiper blades, see “Wiper blades” in the “8. Mainte-

nance and do-it-yourself” section.

(slower) or backward B (faster).

–

The wiper operation speed will vary in accor-

dance with the vehicle speed in the <AUTO>

position. For example, when the vehicle

speed is high, the intermittent operation

speed will be faster.

NIC2125

Type A (without <AUTO> mode)

: Low (

eration.

) – for continuous low speed op-

➁

•

90 Instruments and controls

front of the rear view mirror, can automatically turn

on the wipers and adjust the wiper speed depend-

ing on the rainfall intensity and the vehicle speed

when the lever in the <AUTO> position.

REAR WINDOW

CAUTION

This function can be operated even if the igni-

tion switch is in the ON position. However, to

prevent an accident or damage when pulling

up the wiper arms, be sure to observe the fol-

lowing precautions.

•

The sensitivity can be adjusted by rotating the ring

of the wiper switch forward — less sensitive, or back-

ward — more sensitive.

–

Make sure the shift lever is in the P (Park)

position (Automatic (DCT) Transmission

models).

NOTE

Be sure to turn off the rain-sensing auto wiper

system when the car is in the car wash.

•

Make sure the shift lever is in the N (Neu-

tral) position, with the parking brake fully

applied (Manual Transmission models).

NIC2174

Leaving the lever in <AUTO> position will not

•

harm the rain sensor system, although occa-

sional unexpected activation of the wipers

may occur.

Never allow the passengers to operate the

windscreen wiper switch inadvertently.

WARNING

In freezing temperatures the washer solution

may freeze on the rear window and obscure your

vision. Warm the rear window with the rear win-

dow defogger before using the rear wipers.

Do not operate the windscreen wiper while the

wiper arms are pulled up. The wiper arms may

be damaged.

If the switch is left in the <AUTO> position, the

•

wipers may operate unexpectedly when dirt,

fingerprints, oil film or insects are covering the

windscreen of the rain sensor location. The

wipers may also operate when exhaust gas or

moisture affects the rain sensor.

Rain sensor (where fitted)

CAUTION

Do not touch or cover the windscreen where

•

Do not operate the washer continuously for

more than 15 seconds.

•

the rain sensor is located. The wipers may op-

erate unexpectedly when the wiper switch is

in the <AUTO> position and the ignition switch

is in the ON position. This can cause an injury

or may damage a wiper.

Do not operate the washer if the reservoir tank

is empty or frozen.

•

The rear window wiper and washer operates when

the ignition switch is in the ON position.

NIC3802

The sensor

of the rain-sensing auto wiper sys-

➀

tem located on the upper part of the windscreen, in

Instruments and controls 91

THERMACLEAR HEATED

WINDSCREEN BUTTON

If damage occurs to the windscreen have the

ThermaClear system checked by a NISSAN

dealer or qualified workshop.

Wiper operation

Turn the switch clockwise to the intermittent (

THERMACLEAR HEATED

WINDSCREEN (where fitted)

) position or continuous (

wiper operation.

) position for

➁

➀

Reduced performance or deactivation of the

ThermaClear Heated Windscreen may be no-

ticed to preserve the battery. This is not a mal-

function.

•

To stop the wiper operation, turn the switch back to

the OFF position.

Washer operation:

NISSAN recommends using the ThermaClear

system to support defogging of the wind-

screen. For more information, see “Heater and

air conditioner” in the “4. Display screen,

heater and air conditioner, and audio system”

section.

To operate the washer, push the lever towards the

front of the vehicle

until the desired amount of

➂

washer fluid is spread on the rear window.The wiper

will automatically operate several times.

NAA2014

Wiper drip wipe system (where fitted):

Models with ThermaClear Heated Windscreen (where

fitted)

ThermaClear Heated Windscreen On/Off

During use of the ThermaClear system the

Stop/Start System is unavailable.

The wiper will also operate once about 3 seconds

after using the washer. This operation is to wipe

washer fluid that has dripped on the windscreen.

•

To defog/defrost the windscreen glass, start the en-

gine and push the ThermaClear button A . The indi-

cator light will come on. Push the button again to

turn the ThermaClear system off.

The mode can be turned off. For details, see “Vehicle

information display” earlier in this section.

Reverse synchronisation function

(where fitted)

When the windscreen wiper switch is in either the

intermittent or <AUTO> (where fitted), low or high

speed position, placing the shift lever in the R (Re-

verse) position will operate the rear window wiper.

The ThermaClear system will turn off automatically

after approximately 6 minutes — if the windscreen

clears before this time, push the button again to

turn the ThermaClear system off.

NOTE

The mode can be turned off. For details, see “Vehicle

information display” earlier in this section.

The ThermaClear system can only be

activated while the engine is running.

•

Before activating the ThermaClear system

make sure to remove excess snow/ice from

the windscreen

NOTE

•

In the <AUTO> position (where fitted), the rear

wiper will not begin to sweep when the shift lever

is placed in the R position. It waits until the front

wipers have made the first sweep.

Electrical conductors embedded in the wind-

screen provide the heating of the windscreen.

•

92 Instruments and controls

Instruments and controls -> Wiper and washer switch for Your Nissan Juke SUV 2020

Popular Manuals