Maintenance and do-it-yourself -> Battery for Your Nissan Juke SUV 2020

BATTERY  
VEHICLE BATTERY  
WARNING  
Do not operate the vehicle if the fluid in the bat-  
tery is low. Low battery fluid can cause a higher  
load on the battery which can generate heat, re-  
duce battery life, and in some cases lead to an  
explosion.  
Caution symbols for battery  
m
WARNING  
No smoking  
No exposed  
flames  
Never smoke around the battery. Never expose the battery to open flames  
or electrical sparks.  
m
m
m
No sparks  
Handle the battery cautiously. Always wear eye protection glasses to  
protect against explosion or battery acid.  
Shield eyes  
Keep the battery surface clean and dry. Any cor-  
rosion should be washed off with a solution of  
baking soda and water.  
Keep away from Never allow children to handle the battery. Keep the battery out of reach of  
children  
children.  
Make certain the terminal connections are clean  
and securely tightened.  
Do not allow battery fluid to contact your skin, eyes, fabrics, or painted  
surfaces. After handling the battery or battery cap, immediately wash your  
hands thoroughly. If the battery fluid gets into your eyes, or onto your skin  
or clothing, flush with water immediately for at least 15 minutes and seek  
medical attention. Battery fluid is acid. If the battery fluid gets into your eyes  
or onto your skin, it could cause eyesight loss or burns.  
If the vehicle is not used for 30 days or longer,  
disconnect the “–” negative battery terminal  
cable to prevent discharge.  
Battery acid  
m
If battery replacement or check is required, con-  
tact a NISSAN dealer or qualified workshop.  
Note operating  
instructions  
Before handling the battery, read this instruction carefully to ensure correct  
and safe handling.  
m
m
Explosive gas  
Hydrogen gas, generated by battery fluid, is explosive.  
360 Maintenance and do-it-yourself  
2. Add distilled water up to the UPPER level line  
.
Battery (Type A)  
Reinitialisation procedure after battery  
reconnection  
If the battery has been reconnected, check the fol-  
lowing items:  
If the side of the battery is not clear, check the  
electrolyte water level by looking directly above  
the cell, as illustrated.  
3. Tighten cell plugs.  
Clock setting (where fitted).  
Reset the desired radio stations to the preset  
station buttons.  
CAUTION  
Do not overfill battery cells. Excessive electrolyte  
may leak out of the battery during charging, and  
cause paint damage.  
For details, see “Vehicle information display” in the  
“2. Instruments and controls” section, or the sepa-  
rately provided NissanConnect Owner's Manual, or  
the audio device descriptions in “FM/AM radio (with  
DAB) (where fitted)” in the “4. Display screen, heater  
and air conditioner, and audio system” section.  
DI0137MAZ  
Check the fluid level in each cell. It should be be-  
tween the UPPER and LOWER level lines.  
Models with Stop/Start System  
If it is necessary to add fluid, add only distilled water  
to bring the level to the indicator in each filler open-  
ing. Do not overfill.  
Ensure that the battery fitted is the special bat-  
tery that is enhanced with regard to the charge-  
discharge capacity and life performance. Avoid  
using any other battery for the Stop/Start Sys-  
tem, as this may cause early deterioration of the  
battery or a malfunction of the Stop/Start Sys-  
tem. It is recommended that a Genuine NISSAN  
battery is fitted. For more information, contact a  
NISSAN dealer or qualified workshop.  
j
1. Remove the cell plugs A using a suitable tool.  
NDI920Z  
Maintenance free battery (Type B)  
For a maintenance free battery it is not required to  
If the battery terminal is disconnected (for bat-  
check the fluid level. However, NISSAN recommends  
tery replacement, etc.) and then reconnected,  
there may be some delay before the Stop/Start  
System reactivates.  
j
to visually check the green indicator A status peri-  
odically. If it is not visible, replace the battery as soon  
as possible.  
NDI688Z  
Indicator  
OK  
ADD  
Maintenance and do-it-yourself 361  
Be careful not to touch a circuit board or a bat-  
tery terminal.  
JUMP-STARTING  
If jump-starting is necessary, see “Jump starting” in  
the “6. In case of emergency” section. If the engine  
does not start by jump starting, the battery may  
have to be replaced. Contact a NISSAN dealer or  
qualified workshop.  
An improperly disposed battery can harm the  
environment. Always conform to local regula-  
tions for battery disposal.  
The Integrated key fob/Intelligent Key is wa-  
ter-resistant; however, if it does get wet, im-  
mediately wipe it until it gets completely dry.  
To replace the battery,open the Integrated key  
fob/Intelligent Key carefully in the sequence  
shown in the illustration.  
INTEGRATED KEY FOB/INTELLIGENT  
KEY BATTERY REPLACEMENT  
SPA0784Z  
CAUTION  
symbol noted on the Intelligent key is  
The  
intended to alert the user to the presence of  
important operating and maintenance (ser-  
vicing) instructions in the literature accompa-  
nying the appliance.  
When changing the battery, do not let dust or  
oil get on the Integrated key fob/Intelligent  
Key.  
CAUTION  
Always hold the battery by the edges, as shown.  
Holding the battery across the contact points will  
seriously deplete the storage capacity.  
Be careful not to allow children to swallow the  
battery and removed parts.  
WARNING  
There is danger of explosion if the lithium bat-  
tery is incorrectly replaced. Replace only with  
the same or equivalent type.  
Do not ingest the battery; Chemical Burn Haz-  
ard. The remote control supplied with your ve-  
hicle contains a coin button cell battery. If the  
coin/button cell battery is swallowed, it can  
cause severe internal burns in just 2 hours and  
can lead to death.  
Do not expose the battery to excessive heat  
such as concentrated sunshine, fire or the like.  
Do not crush or cut the battery.  
Keep new and used batteries away from chil-  
dren. If the battery compartment does not  
close securely, stop using the product and  
keep it away from children.  
Do not subject the battery to extremely low  
air pressure at high altitude.  
When changing batteries, do not let dust or oil  
get on the components.  
If you think batteries might have been swal-  
lowed or placed inside any part of the body,  
seek immediate medical attention.  
362 Maintenance and do-it-yourself  
NDI1429  
Integrated key fob  
Replacement  
1. Insert a flat blade screwdriver or a suitable tool  
into the slot and twist it to open the lid.  
j
A pointing downward as  
shown lift the rear B of the key.  
2. Keeping the front  
j
3. Replace the battery with a new one.  
For models equipped with Integrated key fob, use  
the following battery type:  
CR2032  
Do not touch the internal circuit and electric  
terminals as doing so could cause a malfunc-  
tion.  
Make sure that the + side faces the bottom of  
the case, as illustrated.  
4. Install the lid in the reverse order of removal and  
press firmly.  
5. Operate the buttons to check that the key works  
correctly.  
Contact a NISSAN dealer or qualified workshop if  
you need assistance for battery replacement.  
Maintenance and do-it-yourself 363  
DRIVE BELTS  
WARNING  
Be sure the ignition switch is in the “OFF” or LOCK  
position. Otherwise the cooling fan or the engine  
may start to operate suddenly.  
1. Visually inspect each belt for signs of unusual  
wear, cuts, fraying or looseness. If the belt is in  
poor condition or loose, have it replaced or ad-  
justed by a NISSAN dealer or qualified workshop.  
2. Have the belts checked regularly for condition  
and tension in accordance with the maintenance  
schedule as shown in a separately provided War-  
ranty Information and Maintenance booklet.  
NDI1825  
Intelligent Key  
5. Install the lid in the reverse order of removal.  
Replacement  
1. Slide the locking pin to the unlock position.  
6. Operate the buttons to check that the key works  
correctly.  
2. Remove the key.  
Contact a NISSAN dealer or qualified workshop if  
you need assistance for battery replacement.  
3. Insert a flat blade screwdriver or a suitable tool  
into the slot and twist it to open the lid.  
4. Replace the battery with a new one with the  
same specifications.  
For models equipped with Intelligent Key, use the  
following battery type:  
CR2032  
Do not touch the internal circuit and electric  
terminals as doing so could cause a malfunc-  
tion.  
Make sure that the + side faces the bottom of  
the case, as illustrated.  
364 Maintenance and do-it-yourself