Maintenance and do-it-yourself -> Engine oil for Your Nissan Juke SUV 2020

ENGINE OIL  
MAX level  
j
A
CHECKING ENGINE OIL LEVEL  
CHANGING ENGINE OIL AND OIL  
FILTER  
HR10DDT engine  
CAUTION  
1. Park the vehicle on a level surface and apply the  
parking brake.  
The oil level should be checked regularly. Operat-  
ing with an insufficient amount of oil can damage  
the engine, and such damage is not covered by  
warranty.  
WARNING  
NISSAN Blue Citizenship  
2. Start the engine. If the engine is cold, start and  
let the engine idle until it reaches the operational  
temperature (approximately 5 minutes).  
Used oil must not be poured into the ground,  
canals, rivers, etc. It should be disposed of at a  
rubbish tip having proper facilities.  
3. Turn the engine off.  
4. Wait at least 15 minutes for the engine oil to drain  
back into the oil pan.  
NISSAN recommends contacting  
dealerorqualifiedworkshopforengineoilser-  
vicing.  
a NISSAN  
5. Remove the dipstick and wipe it clean.  
6. Re-insert it all the way.  
Be careful not to burn yourself, as the engine  
oil is hot.  
7. Remove the dipstick again and check the oil level.  
Prolongedandrepeatedcontactwithuseden-  
gine oil may cause skin cancer.  
It should be in the normal range  
.
8. If the oil level is below the minimum mark , re-  
Avoid direct skin contact with used oil. If skin  
contact is made, wash thoroughly with soap  
or hand cleaner and plenty of water as soon  
as possible.  
move the engine oil filler cap and pour the rec-  
NDI1760  
ommended oil through the opening. Do not  
overfill  
.
9. Recheck the oil level with the dipstick.  
Store used engine oil in marked containers out  
of the reach of children.  
It is normal to add some engine oil between oil  
maintenance intervals depending on the severity  
of operating conditions or depending on the  
property of the engine oil used. More engine oil is  
consumed by frequent acceleration/deceleration  
especially when the engine rpm is high.  
Consumption is likely to be higher when the en-  
gine is new. If the rate of oil consumption, after  
having driven for 5,000 km (3,000 miles), is more  
than 0.5 litre per 1,000 km (621 miles), consult a  
NISSAN dealer or qualified workshop.  
CAUTION  
Waste oil must be disposed of properly.  
Check your local regulations.  
NDI1728  
Normal range  
MIN level  
Maintenance and do-it-yourself 355  
2. Start the engine. If the engine is cold, start and  
let the engine idle until the engine temperature  
reaches the operational temperature (approxi-  
mately 5 minutes).  
14. Check the oil level with the dipstick. For details,  
see “Checking engine oil level” earlier in this sec-  
tion.  
Engine oil replacement  
Changing engine oil filter  
3. Turn the engine off.  
4. Wait at least 15 minutes to let the engine oil drain  
back into the oil pan.  
5. Remove the underbody cover (where fitted).  
6. Place a large drain pan under the drain plug.  
7. Remove the drain plug with a wrench.  
8. Remove the oil filler cap and completely drain  
the oil.  
If the engine oil filter needs to be changed, re-  
move and replace it at this time. See “Changing  
engine oil filter” later in this section.  
9. Clean and re-install the drain plug along with a  
new washer. Securely tighten the drain plug with  
a wrench. Do not use excessive force.  
Drain plug tightening torques:  
HR10DDT  
25 Nm (18 ft-lb)  
10. Refill the engine with recommended engine oil  
and quantity. (See “Capacities and recom-  
mended fluids/lubricants” in the “9. Technical  
information” section.)  
NDI1761  
HR10DDT engine model  
Oil filler cap  
Oil drain plug  
Oil filter  
When filling the engine oil, do not remove the  
dipstick.  
NDI1761  
HR10DDT engine model  
11. Install the engine oil filler cap securely.  
12. Start the engine.  
Oil filler cap  
Oil drain plug  
Oil filter  
1. Park the vehicle on a level surface and apply the  
parking brake.  
13. Check for any leakage around the drain plug.  
Correct as required.  
356 Maintenance and do-it-yourself