Maintenance and do-it-yourself -> Windscreen washer nozzle for Your Nissan Juke SUV 2020

3. Install the new wiper blade in the reverse order  
of removal.  
TAILGATE WINDOW WIPER  
REPLACEMENT  
WINDSCREEN WASHER NOZZLE  
4. Return the wiper arm to its original position.  
NDI892Z  
If you wax the surface of the engine bonnet, be care-  
j
ful not to let wax get into the washer nozzle A . This  
may cause clogging or improper windscreen  
washer operation. If wax gets into the nozzle, re-  
j
move it with a needle or small pin B .  
NDI1757  
1. Lift the wiper arm  
.
2. Hold and carefully rotate the wiper blade clock-  
wise until the blade becomes free  
.
3. Insert the new wiper blade onto the wiper arm  
and snap it into place.  
4. Return the wiper arm to its original position.  
Maintenance and do-it-yourself 367  
FUSES  
PASSENGER COMPARTMENT  
CAUTION  
Never use a fuse of higher or lower amperage  
rating than that specified on the fuse box  
cover.  
Never pull the wiring loom or wires when dis-  
connecting the connector.  
Be careful not to damage the connector sup-  
port bracket when disconnecting the  
connector.  
If any electrical equipment does not operate, check  
for an open fuse.  
The fuse box is located in the lower part of the in-  
strument panel at the driver's side on left hand drive  
vehicles. On right hand drive vehicles, it is located at  
the back of the glove box.  
The affected circuits  
the fuse box lid.  
are shown on the inside of  
1. Make sure the ignition switch and the headlight  
switch are in the “OFF” position.  
2. Open the fuse box lid.  
3. Locate and remove the fuse with the fuse puller  
(where fitted). The fuse puller (where fitted) is  
located in the fuse box.  
NOTE  
The fuse puller is stored in the fuse box.  
j
4. If the fuse is open A , replace it with a new fuse  
j
B .  
NDI1778  
Right hand drive  
NDI1829  
Left hand drive  
368 Maintenance and do-it-yourself