Get Starting and driving -> Stop/Start System Guide for Nissan Juke SUV 2020

STOP/START SYSTEM

(where fitted)

The Stop/Start System is designed to prevent un-

necessary fuel consumption, exhaust emissions,

and noise during a journey:

The Stop/Start System has stopped the engine and

will automatically restart the engine. The Stop/Start

symbol is shown in the vehicle information display.

CAUTION

At the end of the journey the engine must be

stopped and ignition turned OFF. Lock the vehicle

as normal.Turning the ignition OFF will shut down

all electrical systems. Failure to do this may result

in a flat battery.

To activate the Stop/Start system:

NOTE

On manual transmission models, bring the ve-

hicle to a complete stop, remain at idle in N (Neu-

tral) and release the clutch pedal.

•

The Stop/Start System will not activate under the

following conditions:

When the engine is kept idling without any driv-

ing after the engine is turned on.

•

On automatic (DCT) transmission models, bring

the vehicle to a complete stop and either push

the footbrake or shift into N (Neutral) or P (Park).

•

NORMAL OPERATION

When the engine coolant temperature is low.

•

When the battery capacity is low.

•

If you have Automatic Brake Hold (where fitted)

turned ON, you can remove your foot from the

brake pedal once the automatic brake hold indi-

cator (green) illuminates, and the engine will not

restart automatically.

When the battery temperature is low or

extremely high.

•

When the vehicle is moved.

•

When the vacuum in the brake servo decreases.

•

To restart the engine when the Stop/Start system

is active:

When the engine bonnet is opened with the en-

gine running.

•

On manual transmission models, the engine will

restart as soon as you depress the clutch pedal

to shift into a (forward or reverse) gear.

•

NIC3713

When the engine is turned on with the engine

bonnet open.

•

7 inch display

When the driver’s seat belt is not fastened.

•

On automatic (DCT) transmission models:

•

When the driver’s door is open.

•

–

If the automatic brake hold indicator (green)

(where fitted) is illuminated, shift into

When the steering wheel is operated.

•

(Drive) or R (Reverse), or press the accelerator

pedal to restart the engine.

When the Stop/Start System indicator blinks at

a low speed.

•

–

If automatic brake hold (where fitted) is

turned off or not fitted, or the indicator is not

illuminated, the engine will restart when you

take your foot off the brake pedal, or shift

into D (Drive) or R (Reverse).

When the accelerator pedal is depressed (Auto-

•

matic (DCT) transmission models).

When the shift lever is in the R (Reverse) position.

•

When the fan speed control dial is in any posi-

•

NSD491

tion other than OFF (0) while the air flow control

dial is in the front defogger position (manual air

conditioner).

4.2 inch display

Starting and driving 207

When the front defogger switch is on (automatic

air conditioner).

NOTE

When the front defogger switch is set to ON (au-

tomatic air conditioner).

•

The engine will not restart even if the brake pedal

is released (Automatic (DCT) transmission ) or

clutch pedal is pressed (MT) while the Stop/Start

System is activated under the following condi-

tion:

When the Stop/Start System OFF switch is

turned on.

When the accelerator pedal is depressed. (Auto-

matic (DCT) transmission models)

When the electric power steering warning light,

the Anti-lock Braking System (ABS) warning

light, or the Electronic Stability Programme (ESP)

warning light illuminates.

When the steering wheel is operated. (Automatic

(DCT) transmission models)

When the shift lever is in the P (Park) position

(Automatic (DCT) transmission models).

•

When the battery capacity is low.

•

When the power consumption is high.

When Intelligent Key is not detected for DCT or

MT.

When the engine bonnet is opened.

•

When the brake pedal is released on sloping

roads and the vehicle is moved.

When the driver seat belt is unfastened and the

driver's door is opened (MT models).

•

When the brake pedal is not fully depressed (Au-

tomatic (DCT) transmission models).

When the force to the brake pedal is reduced

while the shift lever is in the D (Drive) or N (Neu-

tral) position. (Automatic (DCT) transmission

models)

•

When the shift lever is not in the (N) Neutral posi-

tion (MT models).

•

When stopping the vehicle on steep sloping

roads (Automatic (DCT) transmission models).

When the shift lever is in the (N) Neutral position

and the parking brake is on (Automatic (DCT)

transmission models).

•

When the power consumption is high.

•

When the shift lever is placed in the R (Reverse)

position from the N (Neutral) or P (Park) position

(Automatic (DCT) transmission models). If D

(Drive) is selected from P (Park) or N (Neutral) dur-

ing a Stop/Start system stop in an Automatic

(DCT) vehicle, the engine will not restart until the

brake pedal is released.

•

When the vehicle is travelling at altitudes higher

than 2000 m (6562 ft) (MT models).

When the Automatic brake hold indicator (green)

(where fitted) is illuminated (Automatic (DCT)

transmission models)

•

NOTE

It may take some time until the Stop/Start Sys-

tem activates under the following conditions:

NOTE

The engine will restart without releasing the

brake pedal (Automatic (DCT) transmission mod-

els) or without depressing the clutch pedal (MT

models) while the Stop/Start System is activated

under the following conditions:

When the battery is discharged.

When the paddle shift is operated (if equipped)

(Automatic (DCT) transmission models)

•

When the outside temperature is low.

•

When the Intelligent Key is not detected for DCT

or MT.

When the battery is replaced or the battery ter-

minal is disconnected for extended periods and

then reconnected.

•

When the vacuum of the brake servo is insuffi-

cient as a result of depressing the brake pedal

several times.

When the Stop/Start System OFF switch is

pushed.

•

When the fan speed control dial is in any posi-

•

When the driver's seat belt is released or the

driver's door is open. (Automatic (DCT) transmis-

sion models) (Manual transmission models if

gear is not engaged).

•

tion other than OFF (0) while the air flow control

dial is in the front defogger position (manual air

conditioner).

208 Starting and driving

Use this system while waiting at traffic lights, etc.

When the vehicle is stopped for long periods of time,

turn off the engine.

(estimate) of carbon dioxide exhaust emissions

(where fitted) prevented by the Stop/Start System.

PRECAUTIONS

The following message is displayed when there may

be something wrong with the Stop/Start System.

You are advised to have the system checked by a

NISSAN dealer or qualified workshop.

When the engine bonnet is opened with the Stop/

Start System on, the engine will be in the normal

stopped state with the buzzer sounding. In this

case, restart the engine with the ignition switch.

When the engine is stopped by the Stop/Start Sys-

tem, heating, cooling and dehumidifying functions

will be deactivated. To avoid the air conditioning

functions from being deactivated, turn off the Stop/

Start System by pressing the Stop/Start System

OFF switch.

The [CO2 Saved] can be

reset in the [Settings]

menu; see “Vehicle

information display” in

the “2. Instruments and

controls” section.

The message can be

cleared by pressing the

steering wheel <OK> but-

ton

NOTE

The Stop/Start System

symbol at the bottom of

the display flashes whilst

the fault condition

When automatic restart is not possible the follow-

ing information is displayed. The engine must be

started using the ignition switch.

The Stop/Start System is always engaged at the

start of

a journey (once the engine has been

started). The engine is automatically stopped and

restarted during the journey if conditions are suit-

able

remains.

The message can be

cleared by pressing the

steering wheel <OK> but-

ton, restarting the

engine, or placing the

ignition in the OFF posi-

tion.

NOTE

When the engine is stopped the following informa-

tion is displayed for a few seconds.

When the Stop/Start system is inhibited due

•

to Air Conditioning or Power Steering the sys-

tem will display a specific message for each

condition ([Stop/Start A/C Priority] or [Stop/

Start Steering Priority].

See “Vehicle information display” in the “2. Instru-

ments and controls” section for information about

the display.

Stop/Start message with driving tip ([Stop/

•

Start Release Clutch Pedal] or [Stop/Start

Press Brake Pedal]) will be displayed for these

conditions.

NOTE

Automatic engine restart

is possible whenever the

Stop/Start System

symbol is illuminated at

the bottom of the

display.

Whilst the engine remains stopped the vehicle in-

formation display shows the accumulated quantity

Starting and driving 209

NOTE

STOP/START SYSTEM OFF SWITCH

The following messages may be displayed for a

few seconds in the vehicle information display

when the Stop/Start System OFF switch is

pressed.

The [Trip CO2 Saving] value is the same infor-

mation that is displayed when the engine is

automatically stopped by the Stop/Start Sys-

tem.

Stop/Start System

disengaged

Stop/Start System

re-engaged

[Total CO2 Saving]

•

–

Estimated CO2 exhaust emissions pre-

vented.

–

Time that the engine has been stopped by

the Stop/Start System.

NIC4365

NOTE

The [Total CO2 Saving] values cannot be re-

set and show accumulated Stop/Start Sys-

teminformationsincethevehiclewasbuilt.

The system can be temporarily disengaged by

pressing the Stop/Start System OFF switch. Press-

ing the button a second time will re-engage the m m

Stop/Start System.

More information about the Stop/Start System can

When the Stop/Start System is disengaged

•

be checked using the [Settings] menu (see Instru-

whilst the engine is running, the engine is pre-

ments and Controls).

vented from automatically stopping.

ENVIRONMENTAL SAVINGS

The vehicle information display keeps a record of

the CO2 savings that can be viewed via the [Set-

tings] menu.

When the Stop/Start System is disengaged af-

•

ter the engine has been automatically stopped

by the Stop/Start System, the engine will imme-

diately restart if suitable conditions are present

as described under NORMAL OPERATION. The

engine will then be prevented from automati-

cally stopping during the same journey.

See “Vehicle information display” in the “2. Instru-

ments and controls” section for information about

the display.

Whenever the Stop/Start System is disengaged,

the system cannot prevent unnecessary fuel

consumption, exhaust emissions, or noise dur-

ing your journey.

•

Information that can be displayed includes:

[Trip CO2 Saving]

•

Estimated CO2 exhaust emissions prevented

since last reset.

210 Starting and driving

Download User Manual App

Starting and driving -> Stop/Start System for Your Nissan Juke SUV 2020

Related Topics

Illustrated table of contents

Safety ? Seats, Seat belts and Supplemental Restraint System

Instruments and controls

Pre-driving checks and adjustments

Display screen, heater and air conditioner, and audio system

Starting and driving

In case of emergency

Appearance and care

Maintenance and do-it-yourself

Technical information

Regulatory information

Popular Owner Manuals

Latest Owner Manuals