Maintenance and do-it-yourself -> Battery for Your Nissan Patrol SUV Sixth Generation (2010-2023)

BATTERY  
SDI1573  
VEHICLE BATTERY  
WARNING:  
Do not operate the vehicle if the fluid in the  
battery is low. Low battery fluid can cause a  
higher load on the battery which can gen-  
erate heat, reduce battery life, and in some  
cases lead to an explosion.  
8-18 Maintenance and do-it-yourself  
above the cell; the condition indicates OK  
.
Do not expose the battery to excessive  
heat such as sunshine, fire, etc.  
Checking battery fluid level  
and the condition  
added.  
needs more to be  
3. Replace and tighten the cell plugs.  
.
Vehicles operated in high temperatures or  
under severe conditions require frequent  
checks of the battery fluid level.  
.
Keep the battery surface clean and dry. Any  
corrosion should be cleared with a firmly  
wrung out moist cloth.  
.
.
Make certain the terminal connections are  
clean and securely tightened.  
DI0137MD  
If the vehicle is not to be used for more  
than 30 days, disconnect the negative ()  
battery terminal cable to prevent battery  
discharge.  
Jump starting  
If jump starting is necessary, see “Jump start-  
ing” (P.6-8). If the engine does not start by jump  
starting or the battery does not charge, the  
battery may have to be replaced. Contact a  
NISSAN dealer for replacing the battery.  
INTELLIGENT KEY BATTERY  
Battery replacement  
SDI1480D  
Check the fluid level in each cell. The battery  
fluid level should be between the UPPER LEVEL  
SDI2451  
CAUTION:  
and LOWER LEVEL  
lines.  
To replace the battery:  
.
.
Be careful not to allow children to swal-  
low the battery and removed parts.  
An improperly disposed battery can harm  
the environment. Always confirm local  
regulations for battery disposal.  
If it is necessary to add fluid, add only deminer-  
alized/distilled water to bring the level to the  
indicator in each filler opening. Do not overfill.  
1. Release the lock knob at the back of the  
Intelligent Key and remove the mechanical  
key.  
2. Insert a small screwdriver into the slit of the  
corner and twist it to separate the upper  
part from the lower part. Use a cloth to  
protect the casing.  
1. Remove the cell plugs  
using a suitable  
tool.  
.
.
When changing batteries, do not let dust  
2. Add demineralized/distilled water up to the  
UPPER LEVEL line.  
or oil get on the components.  
There is danger of explosion if lithium  
battery is incorrectly replaced. Replace  
only with the same or equivalent type.  
If the side of the battery is not clear, check  
the distilled water level by looking directly  
Maintenance and do-it-yourself 8-19  
VARIABLE VOLTAGE CONTROL SYSTEM FUSES  
The variable voltage control system measures  
3. Replace the battery with a new one.  
TYPES OF FUSE  
the amount of electrical discharge from the  
battery and controls voltage generated by the  
alternator.  
.
Recommended battery: CR2025 or  
equivalent  
.
Do not touch the internal circuit and  
electric terminals as doing so could  
CAUTION:  
cause a malfunction.  
.
Make sure that the + side faces the  
.
.
Do not ground accessories directly to the  
battery terminal. Doing so will bypass the  
variable voltage control system and the  
vehicle battery may not charge comple-  
tely.  
Use electrical accessories with the engine  
running to avoid discharging the vehicle  
battery.  
bottom of the case.  
SDI1751  
The fuses (type  
and/or type ) are stored in  
the engine compartment and passenger com-  
partment fuse boxes.  
Type  
fuses can be installed both in the  
engine compartment and passenger compart-  
ment fuse boxes.  
SDI2452  
4. Align the tips of the upper and lower parts  
, and then push them together until it is  
securely closed  
.
5. Operate the buttons to check its operation.  
See a NISSAN dealer if you need assistance for  
replacement.  
SDI1752  
If a type fuse is used to replace a type fuse,  
the type  
fuse will not be level with the fuse  
pocket as shown in the illustration. This will not  
affect the performance of the fuse. Make sure  
the fuse is installed in the fuse box securely.  
Type  
fuses cannot be installed in the under-  
8-20 Maintenance and do-it-yourself