Pre-driving checks and adjustments -> Steering wheel for Your Nissan Patrol SUV Sixth Generation (2010-2023)

STEERING WHEEL  
FUEL-FILLER CAP  
WARNING:  
Never adjust the steering wheel while driving  
so that full attention may be given to vehicle  
operation.  
MANUAL STEERING WHEEL ADJUST-  
MENT  
Tilt or telescopic operation  
WAD0273X  
SPA2753  
To open the fuel-filler lid, unlock it using one of  
the following operations, then push the upper  
right side of the lid.  
Except for Mexico:  
The fuel-filler cap is a ratcheting type. Turn the  
cap counterclockwise to remove. Tighten the  
cap clockwise until ratchet clicks, more than  
twice, after refueling.  
.
.
.
Push the door handle request switch with  
the Intelligent Key carried with you.  
Push the “UNLOCK”  
Intelligent Key.  
button on the  
Put the fuel-filler cap on the cap holder while  
Insert the mechanical key into the door key  
cylinder and turn it to the rear of the vehicle  
(except for Australia, New Zealand and  
South Africa).  
refueling.  
For Mexico:  
SPA2443  
Turn the fuel-filler cap counterclockwise to  
remove. To tighten, turn the cap clockwise until  
a single click is heard.  
Pull the lock lever  
down and adjust the  
.
Push the power door lock switch to the  
steering wheel forward or rearward to the  
“UNLOCK” position.  
desired position.  
To lock the fuel-filler lid, close the lid until it  
securely locks.  
Put the fuel-filler cap on the cap holder while  
Push the lock lever up securely to lock the  
steering wheel in place.  
refueling.  
Pull the lock lever  
and adjust the steering  
CAUTION:  
wheel up or down to the desired position.  
Release the lock lever to lock the steering  
If fuel is spilled on the vehicle body, flush it  
away with water to avoid paint damage.  
wheel in place.  
3-24 Pre-driving checks and adjustments  
MIRRORS  
the headlights of the vehicle behind you  
obstructs your vision at night.  
ELECTRIC STEERING WHEEL ADJUST-  
MENT  
WARNING:  
Push the adjusting lever  
during the day for  
Adjust the position of all mirrors before  
driving. Do not adjust the mirror positions  
while driving so that full attention may be  
given to vehicle operation.  
Tilt or telescopic operation  
the best rearward visibility.  
Automatic anti-glare type  
INSIDE REARVIEW MIRROR  
While holding the inside rearview mirror, adjust  
the mirror angles until the desired position is  
achieved.  
SPA2754  
Move the lever  
to adjust the steering wheel  
SPA2162  
up or down, forward or rearward until the  
desired position is achieved.  
The inside rearview mirror is designed so that it  
automatically changes reflection according to  
the intensity of the headlights of the vehicle  
following you.  
The anti-glare system will be automatically  
turned on when you push the ignition switch  
to the “ON” position.  
Entry/Exit function (if equipped)  
The automatic drive positioner system will  
make the steering wheel move up automati-  
cally when the driver’s door is opened with the  
ignition switch in the “LOCK” position. This  
function allows the driver get into and out of  
the seat more easily.  
SPA2447  
Manual anti-glare type  
When the system is turned on, the indicator  
light  
will illuminate and excessive glare from  
For more information, see “Automatic drive  
the headlights of the vehicle behind you will be  
positioner” (P.3-34).  
reduced.  
Push the  
switch  
for 3 seconds to make  
the inside rearview mirror operate normally  
and the indicator light will turn off. Push the  
switch again for 3 seconds to turn the  
system on.  
Do not hang any objects on the mirror or  
apply glass cleaner. Doing so will reduce the  
SPA2143  
sensitivity of the sensor  
improper operation.  
, resulting in  
Pull the adjusting lever  
when the glare from  
Pre-driving checks and adjustments 3-25