3. Within 5 seconds push and hold the
tion is performed.
.
The extended engine run time has
expired.
remote engine start
button until
.
.
The second 10 minutes will start im-
mediately when the remote engine
start function is performed. For exam-
ple, if the engine has been running for
5 minutes, and 10 minutes are added,
the engine will run for a total of 15
minutes.
the turn signal lights flash and the tail
lights illuminate. If the vehicle is not
within view, push and hold the remote
.
.
.
The first 10 minute timer has expired.
The engine hood has been opened.
The shift lever is moved out of the P
engine start
button for at least 2
(Park) position.
seconds.
.
.
.
The theft alarm sounds due to illegal
entry into the vehicle.
The following events will occur when the
engine starts:
Extending engine run time will count
towards the two remote engine start
limit.
The ignition switch is pushed without
.
The front parking lights will turn on
and remain on as long as the engine is
running.
an Intelligent Key in the vehicle.
The ignition switch is pushed with an
Intelligent Key in the vehicle but the
brake pedal is not depressed.
A maximum of two remote engine starts,
or a single start with an extension, are
allowed between ignition cycles.
The ignition switch must be cycled to the
ON position and then back to the OFF
position before the remote engine start
procedure can be used again.
.
.
The doors will be locked and the air
conditioner system may turn on.
CONDITIONS THE REMOTE ENGINE
The engine will continue to run for
about 10 minutes. Repeat the steps to
extend the time for an additional 10
minutes. See “Extending engine run
time” (P.3-24).
START WILL NOT WORK
The remote engine start will not operate
if any of the following conditions are
present:
CANCELING A REMOTE ENGINE
START
.
The ignition switch is placed in the ON
Depress and hold the brake pedal, then
place the ignition switch in the ON posi-
tion before driving. For further instruc-
tions, see “Driving the vehicle” (P.5-20).
position.
To cancel a remote engine start, perform
.
.
.
The hood is not securely closed.
one of the following:
The hazard indicator flashers are on.
.
Aim the Intelligent Key at the vehicle
and push and hold the remote engine
The engine is still running. The engine
must be completely stopped. Wait at
least 6 seconds if the engine goes
from running to off. This is not applic-
able when extending engine run time.
EXTENDING ENGINE RUN TIME
The remote engine start function can be
extended one time by performing the
steps listed in “Remote starting the en-
gine” (P.3-23). Run time will be calculated
as follows:
start
button until the front park-
ing lights turn off.
.
.
Turn on the hazard indicator flashers.
Cycle the ignition switch ON and then
.
The remote engine start
button is
OFF.
not pushed and held for at least 2
seconds.
.
The first 10 minute run time will start
when the remote engine start func-
3-24 Pre-driving checks and adjustments
