Bluetooth® HANDS-FREE PHONE
SYSTEM (for type A audio)
CAR PHONE OR CB RADIO (if equipped)
When installing a CB, ham radio or a car phone
in your vehicle, be sure to observe the following
cautions, otherwise the new equipment may
adversely affect the Engine Control System and
other electronic parts.
The Bluetooth® system may not be able to
connect with your cellular phone for the
following reasons:
WARNING:
.
.
Use a phone after stopping your vehicle
in a safe location. If you have to use a
phone while driving, exercise extreme
caution at all times so full attention may
be given to vehicle operation.
If you find yourself unable to devote full
attention to vehicle operation while using
the phone, pull off the road to a safe
location and stop your vehicle before
doing so.
.
.
.
The cellular phone is too far away from the
vehicle.
The Bluetooth® mode on your cellular
phone has not been activated.
CAUTION:
Your cellular phone has not been paired
with the Bluetooth® system of the audio
unit.
.
.
Keep the antenna as far away as possible
from the Electronic Control Module.
Keep the antenna wire at least 20 cm (8
in) away from the Engine Control har-
nesses. Do not route the antenna wire
next to any harnesses.
.
The mobile phone does not support Blue-
tooth® technology.
NOTE:
CAUTION:
.
.
.
Adjust the antenna standing wave ratio
.
For details, see your cellular phone’s
as recommended by the manufacturer.
owner’s manual.
To avoid draining the vehicle battery, use a
phone after starting the engine.
.
For assistance with your cellular phone
integration, please visit your local NISSAN
dealer.
Connect the ground wire from the radio
chassis to the body.
For details, consult a NISSAN dealer.
Bluetooth® is a wireless radio communication
standard. This system offers
a hands-free
facility for your cellular phone to enhance
driving comfort.
To use the Bluetooth® Hands-Free Phone
System, your cellular phone must first be setup.
For details, see “Bluetooth® settings” (P.4-76).
Once it has been setup, the hands-free mode is
automatically activated on the registered cel-
lular phone (via Bluetooth®) when it comes into
range.
A notification message appears on the audio
display when the phone is connected, when an
incoming call is being received, as well as when
a call is initiated.
When a call is active, the audio system, micro-
phone, and steering wheel mounted control
buttons enable hands-free communication.
If the audio system is in use at the time, the
radio, CD, iPod, USB audio, Bluetooth® audio or
AUX source mode will be muted and will stay
muted until the active call has ended.
Display screen, heater and air conditioner, and audio system 4-75
