Push the TRIP RESET switch
(located on the
Distance to empty (dte — km or mile):
SPEEDOMETER AND ODOMETER
Speedometer
instrument panel) to change the display as
The distance to empty (dte)
provides you
follows:
with an estimation of the distance that can be
driven before refueling. The dte is constantly
being calculated, based on the amount of fuel
in the fuel tank and the actual fuel consump-
tion.
ODO ? TRIP A ? TRIP B ? ODO
Resetting twin trip odometer:
Push the TRIP RESET switch
for more than 1
second to reset the trip odometer to zero.
The display is updated every 30 seconds.
TACHOMETER
The dte mode includes a low range warning
feature. If the fuel level is low, the warning is
displayed on the screen.
When the fuel level drops even lower, the dte
display will change to “———”.
.
.
If the amount of fuel added is small, the
display just before the ignition switch is
placed in the “OFF” position may continue
to be displayed.
When driving uphill or rounding curves, the
fuel in the tank shifts, which may momen-
tarily change the display.
JVI1006X
The speedometer indicates the vehicle speed
(km/h or MPH).
Distance to empty (dte — km or mile)/
Odometer
JVI0951X
Odometer/Twin trip odometer:
The tachometer indicates the engine speed in
After the ignition switch is placed in the “OFF”
or “LOCK” position from “ON” position, the
odometer/twin trip odometer stays on for 30
seconds. With the ignition switch in the “OFF”
position, when you open any door then close all
doors, the odometer/twin trip odometer stays
on for 30 seconds.
revolutions per minute (rpm). Do not rev the
engine into the red zone
The red zone varies with models.
.
The odometer/twin trip odometer is displayed
in the vehicle information display when the
ignition switch is in the “ON” position.
JVI1603X
The odometer displays the total distance the
vehicle has been driven.
The twin trip odometer displays the distance
of individual trips.
Changing odometer/twin trip odometer dis-
play:
2-10 Instruments and controls
