Instruments and controls -> Power outlets for Your Nissan X Trail SUV 2020

POWER OUTLETS  
If sunroof does not operate  
CAUTION:  
If the sunroof and sunshade do not operate  
properly, perform the following procedure to  
initialize the operation system.  
.
.
.
The outlet and plug may be hot during or  
immediately after use.  
This power outlet is not designed for use  
1. If the sunroof and sunshade are open, close  
with a cigarette lighter unit.  
them fully by repeatedly pushing the sun-  
roof switch to the CLOSE  
position.  
Do not use with accessories that exceed a  
12 volt, 120W (10A) power draw. Do not  
use double adapters or more than one  
electrical accessory.  
Use this power outlet with the engine  
running to avoid discharging the vehicle  
battery.  
2. Push and hold the sunroof switch to the  
CLOSE position for 10 seconds.  
3. After the sunroof and sunshade move  
slightly to the closed position and then  
.
JVI1618X  
WAC0078X  
JVI0879X  
move back  
a
little, release the sunroof  
Instrument panel (if equipped)  
switch.  
.
.
Avoid using when the air conditioner,  
4. Push and hold the sunroof switch to the  
CLOSE position for over 6 seconds.  
5. Release the sunroof switch. The sunroof  
and sunshade will fully open and then fully  
close.  
headlights or rear window defogger is on.  
Push the plug in as far as it will go. If good  
contact is not made, the plug may over-  
heat or the internal temperature fuse  
may blow.  
Before inserting or disconnecting a plug,  
be sure that the electrical accessory  
being used is turned OFF.  
When not in use, be sure to close the cap.  
Do not allow water or any liquid to  
contact the outlet.  
6. Check if the sunroof switch operates nor-  
.
.
mally.  
If the sunroof does not operate properly after  
performing the procedure above, have your  
vehicle checked by a NISSAN dealer.  
Console box (if equipped)  
Cargo area  
To use the power outlet, pull the cover.  
2-68 Instruments and controls  
ASHTRAYS AND CIGARETTE  
LIGHTER (if equipped)  
connector.  
USB (Universal Serial Bus) CHARGING  
CONNECTOR (if equipped)  
ASHTRAY  
JVI0982X  
WAC0094X  
WARNING:  
The USB charging connector is located in the  
center console box.  
Do not use the ashtray in any other position  
than the front side of the front center cup  
holder.  
The USB charging connector can be used only  
for charging an external device.  
Connect  
a USB device into the connector.  
Charging will start automatically (maximum  
CAUTION:  
output up to 5 volt, 12W, 2.4A).  
When using the cooling function, close the  
cup holder ventilator or take care to prevent  
the ash from being dropped in the cup holder  
due to the airflow coming from the drink  
holder ventilator.  
The external device will be charged continu-  
ously while the ignition switch is in the “ACC” or  
“ON” position.  
Some mobile devices cannot be charged de-  
pending on their specifications.  
To open the ashtray, pull up the lid  
To take out the ashtray, pull out  
.
CAUTION:  
.
.
.
Do not force a USB device into the  
connector. Inserting the USB device tilted  
or up-side-down into the connector may  
damage the connector. Make sure that  
the USB device is connected correctly into  
the connector.  
Do not use a reversible USB cable. Using  
the reversible USB cable may damage the  
Instruments and controls 2-69