If the power window automatic function does
not operate properly after performing the
procedure above, have your vehicle checked
by a NISSAN dealer.
Auto-reverse function:
WARNING:
Automatic function
There is
a small distance just before the
closed position which cannot be detected.
Make sure that all passengers have their
hands, etc. inside the vehicle before closing
the windows.
The auto-reverse function enables a window to
automatically reverse when something is
caught in the window as it is closing by the
automatic function. When the control unit
detects an obstacle, the window will be low-
ered immediately.
Depending on the environment or driving
conditions, the auto-reverse function may
activate if an impact or load similar to some-
thing being caught in the window occurs.
JVI1446X
The automatic function is available for the
switch that has an mark on its surface.
The automatic function enables a window to
fully open or close without holding the switch
down or up.
To fully open the window, push the power
window switch down to the second detent and
release the switch. To fully close the window,
pull the power window switch up to the second
detent and release the switch. The switch does
not have to be held during window operation.
To stop the window open/close operation
during the automatic function, push down or
pull up the switch in opposite directions.
If the window does not close automa-
tically
If the power window automatic function (clos-
ing only) does not operate properly, perform
the following procedure to initialize the power
window system.
1. Start the engine.
2. Close the door.
Window timer (if equipped):
3. After starting the engine, open the window
completely by operating the power window
switch.
4. Pull the power window switch and hold it to
close the window, and then hold the switch
more than 3 seconds after the window is
closed completely.
The window timer allows the window switch to
be operated for approximately 45 seconds
even if the ignition switch is placed in the
“OFF” position. The window timer will be
canceled when the driver’s or front passenger’s
door is opened or the preset time has expired.
5. Release the power window switch. Operate
the window by the automatic function to
confirm the initialization is complete.
2-66 Instruments and controls
