engine starts:
.
The remote engine start
pushed and held within
pushing the “LOCK” button.
button is not
seconds of
CANCELING A REMOTE ENGINE START
5
.
.
.
The front clearance lights will turn on and
To cancel a remote engine start, perform one
remain on as long as the engine is running.
of the following:
.
.
.
.
The brake pedal is depressed.
The doors will be locked and the air
.
Aim the Intelligent Key at the vehicle and
push and hold the remote engine start
button until the front clearance lights turn
off.
The doors are not closed and locked.
The back door is open.
conditioner system may turn on.
The engine will continue to run for about 10
minutes. Repeat the steps to extend the
time for an additional 10 minutes. See
“Extending engine run time” (P.3-26).
The Intelligent Key warning message is
displayed in the vehicle information display.
.
.
Turn on the hazard indicator flashers.
.
.
An Intelligent Key is left inside the vehicle.
Cycle the ignition switch “ON” and then
Depress and hold the brake pedal, then place
the ignition switch in the “ON” position before
driving. For further instructions, see “Driving
vehicle” (P.5-18).
The theft alarm sounds due to illegal entry
“OFF”.
into the vehicle.
.
.
.
.
.
The extended engine run time has expired.
The first 10 minute timer has expired.
The engine hood has been opened.
The vehicle is shifted out of “P” (Park).
.
Two remote engine starts, or a single
remote engine start with an extension,
have already been used.
EXTENDING ENGINE RUN TIME
.
The vehicle is not in the “P” (Park) position.
The remote engine start function can be
extended one time by performing the steps
listed in “Remote starting the engine” (P.3-25).
Run time will be calculated as follows:
The theft alarm sounds due to illegal entry
The remote engine start may display a warning
or indicator in the vehicle information display.
For an explanation of the warning or indicator,
see “Vehicle information display warnings and
indicators” (P.2-31).
into the vehicle.
.
.
The ignition switch is pushed without an
Intelligent Key in the vehicle.
The ignition switch is pushed with an
Intelligent Key in the vehicle but the brake
pedal is not depressed.
.
The first 10 minute run time will start when
the remote engine start function is per-
formed.
HOW TO ENABLE/DISABLE THE REMOTE
ENGINE START FUNCTION
The remote engine start function can be
enabled or disabled in the vehicle information
display. See “Vehicle Settings” (P.2-25) for addi-
tional information.
.
The second 10 minutes will start immedi-
ately when the remote engine start func-
tion is performed. For example, if the engine
has been running for 5 minutes, and 10
minutes are added, the engine will run for a
total of 15 minutes.
CONDITIONS THE REMOTE ENGINE
START WILL NOT WORK
The remote engine start will not operate if any
of the following conditions are present:
.
The ignition switch is placed in the “ON”
position.
.
Extending engine run time will count to-
wards the two remote engine start limit.
.
.
.
The hood is not securely closed.
A maximum of two remote engine starts, or a
single start with an extension, are allowed
between ignition cycles.
The ignition switch must be cycled to the “ON”
position and then back to the “OFF” position
before the remote engine start procedure can
be used again.
The hazard indicator flashers are on.
The engine is still running. The engine must
be completely stopped. Wait at least
6
seconds if the engine goes from running
to off. This is not applicable when extend-
ing engine run time.
.
The remote engine start
button is not
pushed and held for at least 2 seconds.
3-26 Pre-driving checks and adjustments
