Pre-driving checks and adjustments -> Remote keyless entry system for Your Nissan X Trail SUV 2020

REMOTE KEYLESS ENTRY SYSTEM  
(if equipped)  
The remote keyless entry system can operate  
all door locks (including the back door) using  
the remote controller. The remote controller  
can operate at a distance of approximately 1 m  
(3.3 ft) away from the vehicle. The operating  
distance depends upon the conditions around  
the vehicle.  
As many as 4 remote controllers can be used  
with one vehicle. For information about the  
purchase and use of additional remote con-  
trollers, contact a NISSAN dealer.  
AUTO DOOR LOCK RELEASING ME-  
CHANISM (if equipped)  
CHILD SAFETY REAR DOOR LOCK  
All doors will be unlocked automatically when  
the following conditions:  
.
.
When the ignition switch is moved from  
“ON” to “OFF” position (Model with Intelli-  
gent Key system).  
When the key is removed from the ignition  
switch (Model without Intelligent Key sys-  
tem).  
The remote controller will not function under  
To activate or deactivate auto door  
lock releasing mechanism  
the following conditions:  
JVP0279X  
.
When the distance between the remote  
controller and vehicle is more than approxi-  
mately 1 m (3.3 ft).  
To activate or deactivate the auto door lock  
releasing mechanism, perform the following  
procedures.  
The child safety rear door locks help prevent  
rear doors from being opened accidentally,  
especially when small children are in the  
vehicle.  
When the levers are in the lock position , the  
child safety rear door locks engage and the  
rear doors can only be opened by the outside  
door handles.  
.
.
When the remote controller battery is  
1. Place the ignition switch in the “ON” posi-  
discharged.  
When the key is in the ignition switch.  
tion.  
2. Within 20 seconds, push and hold the  
power door lock switch to the “UNLOCK”  
position for 5 seconds.  
3. The hazard indicator light will flash as  
follows if the switching operation is suc-  
cessful:  
CAUTION:  
.
.
When locking the doors using the remote  
controller, be sure not to leave the key in  
the vehicle.  
Do not allow the remote controller, which  
contains electrical components, to come  
into contact with water or salt water. This  
could affect the system function.  
To disengage, move the levers to the unlock  
position  
.
.
.
Twice - activated  
Once - deactivated  
IMPACT SENSING DOOR LOCK RELEAS-  
ING MECHANISM (if equipped)  
All doors will be unlocked automatically when  
the impact sensors sense an impact while the  
ignition switch is in the “ON” position.  
.
.
Do not drop the remote controller.  
Do not strike the remote controller shar-  
ply against another object.  
.
Do not place the remote controller for an  
extended period in an area where tem-  
peratures exceed 60°C (140°F).  
If a remote controller is lost or stolen, NISSAN  
recommends erasing the ID code of that  
remote controller from the vehicle. This may  
3-8 Pre-driving checks and adjustments  
prevent the unauthorized use of the remote  
controller to unlock the vehicle. For information  
Unlocking doors  
1. Push the “UNLOCK”  
button  
on the  
regarding the erasing procedure, contact  
a
remote controller.  
2. All doors will be unlocked.  
NISSAN dealer.  
For information regarding the replacement of a  
battery, see “Battery” (P.8-29).  
All doors will be locked automatically unless  
one of the following operations is performed  
within 30 seconds or 1 minute after pushing the  
USING REMOTE KEYLESS ENTRY SYS-  
TEM  
“UNLOCK”  
button  
Opening any doors.  
Inserting the key into the ignition switch.  
.
.
.
JVP0308X  
Type B (with panic alarm)  
Jackknife type key release button  
Selective door unlock mode (if equipped)  
(Type A):  
LOCK button  
UNLOCK button  
PANIC button  
1. Push the “UNLOCK”  
button  
on the  
remote controller.  
Battery indicator light  
2. The driver’s door unlock.  
3. Push the “UNLOCK”  
button  
on the  
Locking doors  
remote controller again.  
JVP0278X  
1. Remove the ignition key.  
2. Close all doors.  
4. All doors will be unlocked.  
Type A (without panic alarm)  
Jackknife type key release button  
LOCK button  
UNLOCK button  
Battery indicator light  
Selective door unlock mode (if equipped)  
(Type B):  
3. Push the “LOCK”  
button  
on the  
remote controller.  
When you first receive the vehicle, the door  
4. All doors will be locked. The door lock  
unlock mode is set to unlock all the doors with  
indicator light  
(located on the instru-  
one push of the “UNLOCK”  
button . The  
ment panel) will illuminate for 1 minutes (if  
door unlock mode can be switched to the  
selective door unlock mode, which unlocks the  
passenger’s doors at the second push of the  
equipped).  
5. Operate door handles to confirm that the  
doors have been securely locked.  
“UNLOCK”  
button  
.
Selective door unlock mode:  
CAUTION:  
1. Push the “UNLOCK”  
button  
button  
on the  
on the  
After locking the doors using the remote  
controller, be sure that the doors have been  
securely locked by operating the door han-  
dles.  
remote controller.  
2. The driver’s door unlock.  
3. Push the “UNLOCK”  
remote controller again.  
Pre-driving checks and adjustments 3-9  
4. All doors will be unlocked.  
Battery indicator light  
The battery indicator light  
To switch to the selective door unlock mode,  
(Type A) or  
perform the following procedure.  
(Type B) illuminates when you push any button.  
If the light does not illuminate, the battery is  
weak or needs replacement. For information  
regarding replacement of a battery, see “Re-  
mote controller battery” (P.8-30).  
Push the “LOCK”  
and “UNLOCK”  
buttons  
simultaneously for more than  
5
seconds.  
Perform the same procedure to deactivate the  
selective door unlock mode.  
HAZARD INDICATOR OPERATION  
Interior light timer (if equipped):  
When you lock or unlock the doors, the hazard  
indicator will flash as a confirmation.  
The interior light timer activates and the  
interior lights illuminate for 15 seconds when  
a door is unlocked and the interior light switch  
is in the “DOOR” position.  
The interior lights can be turned off without  
waiting for 15 seconds by performing one of the  
following operations.  
.
.
“LOCK”: The hazard indicator flashes once.  
“UNLOCK”: The hazard indicator flashes  
twice.  
Hazard indicator mode (for South Africa and Europe)  
DOOR UNLOCK  
DOOR UNLOCK  
DOOR LOCK  
.
.
.
Turning the ignition switch to the “ON”  
position.  
HAZARD - once  
HAZARD - twice  
Remote keyless entry system  
Locking the doors with the remote con-  
troller.  
Hazard indicator mode (except for South Africa and Europe)  
Switching the interior light switch to the  
“OFF” position.  
DOOR LOCK  
HAZARD - twice  
HAZARD - none  
Using panic alarm (if equipped)  
If you are near your vehicle and feel threatened,  
you may activate the alarm to call attention as  
follows:  
Remote keyless entry system  
1. Push the “PANIC”  
button  
on the  
remote controller for more than 0.5 sec-  
ond.  
2. The theft warning alarm will stay on for 25  
seconds.  
3. The panic alarm stops when:  
.
.
It has run for 25 seconds, or  
Any of the buttons on the remote controller  
are pushed. (Note: Panic button should be  
pushed for more than 0.5 second.)  
3-10 Pre-driving checks and adjustments  
INTELLIGENT KEY SYSTEM (if equipped)  
Hazard indicator and horn mode (except for South Africa and Europe)  
DOOR UNLOCK  
DOOR LOCK  
HAZARD - twice  
HAZARD - once  
Remote keyless entry system  
HORN - none  
HORN - once  
Switching procedure (if equipped)  
You can switch the hazard indicator and horn  
operation with the following procedures.  
Push the “LOCK”  
and “UNLOCK”  
buttons simultaneously for more than 2.5  
seconds to switch the mode from one to the  
other.  
SPA2502  
Type A  
When pushing the buttons to set the hazard  
indicator mode, the hazard indicator flashes 3  
times.  
When pushing the buttons to set the hazard  
indicator and horn mode, the hazard indicator  
flashes once and the horn chirps once.  
SPA2543  
Type B (example)  
Pre-driving checks and adjustments 3-11