The speed limiter set switches are located on
the steering wheel.
The speed limiter will not automatically
reduce the vehicle speed to the set speed
limit.
Canceling speed limit
To cancel the speed limiter, push the CANCEL
switch. The speed limiter indicator and the set
speed indicator on the vehicle information
display will turn off.
1.
RES/+ switch
CANCEL switch
SET/- switch
Speed limiter MAIN switch (When this
switch is pushed, the speed limiter enters
the standby mode. If the cruise control or
ICC system is on, the system will turn off
and the speed limiter enters the standby
mode.)
2.
3.
4.
Turning on speed limiter
Push the speed limiter MAIN switch. The speed
limiter and the set speed indicators illuminate
on the vehicle information display.
It is also possible to override the speed limiter
by fully depressing the accelerator pedal be-
yond the resistance point.
Setting speed limit
1. Push the SET/− switch.
WARNING:
.
When the vehicle is stopped, the speed
.
.
The vehicle may accelerate when the
speed limiter cancels.
5.
Cruise ON/OFF switch (For details, see
will be set at 30 km/h or 20 MPH.
“Cruise control” (P.5-61).)
.
While driving, the speed limit will be set
When additional floor mats are used, be
sure that they are correctly secured and
that they cannot interfere with the accel-
erator pedal. Mats not adapted to the
vehicle may prevent proper operation of
the speed limiter.
at the current speed.
2. When the speed limit is set, the speed
limiter indicator and the set speed indicator
illuminate on the vehicle information dis-
play.
Fully depress the accelerator pedal beyond the
resistance point. The speed limiter will be
suspended to allow driving above the set
speed. The set speed indicator will flash. The
speed limiter will automatically resume when
the vehicle speed drops below the set speed
limit.
Changing set speed limit:
Use either of the following operations to
change the speed limit.
.
.
Push and hold the RES/+ or SET/- switch.
The set speed will increase or decrease by
approximately 5 km/h or 5 MPH.
Push, then quickly release the RES/+ or
SET/- switch. Each time you do this, the set
speed will increase or decrease by approxi-
mately 1 km/h or 1 MPH.
JVS0284X
The speed limiter operating condition is shown
on the vehicle information display.
Resuming a previous set speed
If a set speed limit has been cancelled, the set
speed will be stored in the speed limiter
memory.
1.
2.
Speed limiter indicator
Set speed indicator
The new set speed limit value will be displayed
in the vehicle information display.
The speed unit can be converted between
“km/h” and “MPH”. (See “Vehicle information
display” (P.2-22).)
When the vehicle speed exceeds the set speed
limit, the set speed indicator blinks and the
accelerator pedal operation will not work until
the vehicle speed slows down to the set speed
limit.
This speed limit can be reactivated by pressing
When the actual vehicle speed exceeds the set
speed, an audible warning will be heard a short
time after the set speed is exceeded if driver
intervention is not detected.
the RES/+ switch upwards.
If the current vehicle speed is higher than the
previous set speed, the accelerator pedal will
not work and the set speed indicator will flash
until the vehicle speed drops below the set
speed limit.
When the actual vehicle speed exceeds the set
5-60 Starting and driving
