Access
► Reinitialise the remote control.
For more information on Reinitialising the
remote control, refer to the corresponding
section.
► Switch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Doors
Opening
Do not throw remote control batteries
away, as they contain metals that are
harmful to the environment. Take them to an
approved disposal point.
From outside
With Keyless Entry and Starting
► After unlocking the vehicle or with the
Keyless Entry and Starting electronic key in the
recognition zone, pull the door handle.
From inside
► Pull the interior opening control of a door; this
unlocks the vehicle completely.
Reinitialising the remote
control
Following replacement of the battery or in
the event of a fault, it may be necessary to
reinitialise the remote control.
With selective unlocking activated:
– Opening the driver's door unlocks
the driver's door only (if the vehicle has not
already been completely unlocked).
– Opening one of the passenger doors
unlocks the rest of the vehicle.
Without Keyless Entry and Starting
► Insert the mechanical key (integral with the
remote control) in the lock to open the vehicle.
► Place the electronic key against the back-up
reader on the steering column and hold it there
until the ignition is switched on.
Closing
If a door is not properly closed, this
warning lamp comes on accompanied by
a message if the engine is running, and an
audible signal when the vehicle is travelling at
more than 6 mph (10 km/h).
► Switch on the ignition by pressing the
"START/STOP" button.
► With a manual gearbox, place the gear lever
in neutral then fully depress the clutch pedal.
► With an automatic gearbox or drive
selector, while in mode P, depress the brake
pedal.
► Switch off the ignition.
► Return the key to position 2 (Ignition on).
► Immediately press the closed padlock button
for a few seconds.
If the fault persists after reinitialisation, contact
a PEUGEOT dealer or a qualified workshop
without delay.
36
