Access -> Electric windows for Your Peugeot 208 4 Door 2020

Access  
Operating the switch again stops the movement  
of the window.  
Failure of the remote control  
To deactivate the monitoring functions:  
► Unlock the vehicle using the key in the  
driver's door lock.  
► Open the door; the alarm is triggered.  
► Switch on the ignition; this stops the alarm.  
The indicator lamp in the button goes off.  
Electric windows  
2
Window controls remain operational for  
approximately 45 seconds after switching  
off the ignition or after locking the vehicle.  
After that time, the controls are disabled.  
To reactivate them, switch on the ignition or  
unlock the vehicle.  
1. Left-hand front  
2. Right-hand front  
Locking the vehicle without  
activating the alarm  
► Lock or deadlock the vehicle using the key  
(integral to the remote control) in the driver's  
door lock.  
3. Right-hand rear (depending on version)  
4. Left-hand rear (depending on version)  
5. Deactivation of the electric window controls  
located by the rear seats (depending on  
version)  
Anti-pinch  
(Depending on version)  
If the window meets an obstacle while rising, it  
stops and immediately partially lowers again.  
Locking the rear doors - Electric child lock  
(depending on version)  
Deactivating the rear  
controls for the rear electric  
windows  
Malfunction  
When the ignition is switched on, fixed  
illumination of the red indicator lamp in the  
button indicates a malfunction of the system.  
Have it checked by a PEUGEOT dealer or a  
qualified workshop.  
For more information on the Electric child lock,  
refer to the corresponding section.  
Manual operation  
To open/close the window, press/pull the  
switch without passing the point of resistance;  
the window stops as soon as the switch is  
released.  
Automatic activation  
(Depending on country of sale)  
The system is activated automatically 2 minutes  
after the last door or the boot is closed.  
To avoid triggering the alarm on entering the  
vehicle, first press the unlocking button on the  
remote control or unlock the vehicle using the  
“Keyless Entry and Starting” system.  
For your children's safety, press control 5 to  
deactivate the controls for the rear electric  
windows, irrespective of their positions.  
The red indicator lamp in the button comes  
on and a confirmation message is displayed.  
The lamp will remain lit until the controls are  
reactivated.  
Automatic operation  
(Depending on version)  
To open/close the window, press/pull the  
switch past its resistance point: the window  
opens/closes completely when the switch is  
released.  
39  
Access  
The rear electric windows can still be controlled  
using the driver's controls.  
Be particularly aware of children when  
operating the windows.  
Be aware of passengers and/or other persons  
present when closing the windows using  
the electronic key or the "Keyless Entry and  
Starting" system.  
In the event of a serious impact, use of  
the rear electric window controls is  
re-enabled, if they had been deactivated.  
Reinitialising the electric  
windows  
Following reconnection of the battery, or if  
the windows move abnormally, the anti-pinch  
function must be reinitialised.  
The safety anti-pinch function is not active  
during these operations.  
For each of the windows:  
► Lower the window fully, then raise it; it will  
rise in steps of a few centimetres each time the  
control is pressed. Repeat the operation until the  
window is fully closed.  
► Continue to pull the switch for at least  
one second after reaching the window closed  
position.  
If an electric window meets an obstacle  
during operation, the movement of the  
window must be reversed. To do this, press  
the switch concerned.  
When the driver operates the passengers’  
electric window switches, it is important to  
ensure that nothing can prevent the window  
from closing properly.  
It is important to ensure that the passengers  
use the electric windows correctly.  
40