Driving -> Full Park Assist for Your Peugeot 208 4 Door 2020

Driving  
– The system may indicate that a space has  
been found but will not offer it because of a fixed  
obstacle on the opposite side of the manoeuvre,  
which would not allow the vehicle to follow a  
trajectory required for parking.  
– The system may indicate that a space has  
been found but the manoeuvre will not be  
triggered, because the width of the lane is  
insufficient.  
– The system is not designed for performing the  
parking manoeuvre on a sharp bend.  
– The system does not detect spaces that  
are much larger than the vehicle itself or that  
are delimited by obstacles that are too low  
(pavements, studs, etc.) or too thin (trees, posts,  
wire fences, etc.).  
– If the boot is heavily loaded, the tilt of the  
vehicle towards the rear may interfere with the  
distance measurements.  
If the vehicle has undergone any of the  
following modifications, do not use the  
function:  
In the event of a power steering  
malfunction, this warning lamp is  
displayed on the instrument panel, accompanied  
by a warning message.  
You must stop as soon as it is safe to do so.  
Contact a PEUGEOT dealer or a qualified  
workshop.  
– When carrying an object extending beyond  
the dimensions of the vehicle (ladder on the  
roof bars, bicycle carrier on the tailgate, etc.).  
– With a non-approved towball in place.  
– With snow chains fitted.  
– When driving on a small-diameter or  
"space-saver" type spare wheel.  
– When the wheels fitted are a different size  
from the original ones.  
– After modifying one or both bumpers  
(added protection).  
– If the sensors have been repainted other  
than by the PEUGEOT dealer network.  
– With sensors not approved for the vehicle.  
Full Park Assist  
Refer to the General recommendations on the  
use of driving and manoeuvring aids.  
This system provides active parking assistance  
for vehicles fitted with the EAT8 automatic  
gearbox or a gear selector: it detects a free  
"parallel" or "bay" parking space and then  
operates the vehicle, parking it with no need for  
driver intervention. It also allows you to drive out  
of a "parallel parking" space automatically.  
The system controls the steering, direction,  
acceleration and braking. The system measures  
the available parking spaces and calculates  
the distances to obstacles using 12 ultrasonic  
sensors built into the front and rear bumpers of  
the vehicle.  
Malfunctions  
Do not use the function under the  
following exterior conditions:  
– Alongside a soft shoulder (e.g. ditch) or  
quay or on the edge of a drop.  
When the function is not activated, the  
temporary flashing of this indicator lamp  
and an audible signal indicate a system  
malfunction.  
– When the road surface is slippery (e.g. ice).  
If the malfunction occurs while the system is in  
use, the indicator lamp goes off.  
If the parking sensor malfunction  
occurs during use, indicated by  
one of these warning lamps coming on, it causes  
the function to deactivate.  
In the event of a malfunction, have the system  
checked by a PEUGEOT dealer or a qualified  
workshop.  
To help the driver monitor the successful  
completion of the manoeuvre, the system  
automatically displays the Visiopark 1 and  
activates the parking sensors.  
If any of the following malfunctions  
occurs, do not use the system:  
– If a tyre is under-inflated.  
– If one of the bumpers is damaged.  
– If one of the cameras is faulty.  
134  
Driving  
Sequence  
the function proposes the entry to or exit from a  
parking space on the touch screen.  
► Select the type and side of the manoeuvre to  
activate the parking space search.  
Illumination of this lamp confirms  
6
Once the system is activated, the following steps  
will be performed successively:  
– Select the type of manoeuvre via the touch  
screen.  
– Search for an available space.  
– Prepare for the manoeuvre.  
– Perform the manoeuvre.  
activation.  
It is possible to change the type of manoeuvre  
at any time, including during the available space  
search phase.  
– Finalise the manoeuvre.  
► Drive at a distance of 0.50 to 1.50 m from the  
row of parked vehicles, not exceeding 19 mph  
(30 km/h), until the system finds an available  
space (indicated by OK on the display and an  
audible signal).  
It is possible to deactivate the system at  
any time until the start of the manoeuvre,  
by pressing the red arrow in the upper left  
corner of the screen.  
To initiate parking assistance when  
approaching a parking area:  
► Reduce the speed of the vehicle to a  
maximum of 19 mph (30 km/h).  
For "parallel" parking, the space must at  
least equal to the length of your vehicle  
plus 1 m.  
For "bay" parking, the space must at least  
equal to the width of your vehicle plus 0.70 m.  
Full Park Assist is not always able to  
react automatically and appropriately due  
to the performance limits inherent to the  
system.  
The manoeuvre remains the responsibility  
of the driver, who must not leave the driving  
position and must never try to lock the system  
control button.  
Preparing for the  
manoeuvre  
► Move very slowly until the request to stop  
the vehicle and the "STOP" sign are displayed,  
accompanied by an audible signal.  
The driver's seat belt must remain fastened  
during the manoeuvre.  
► Press the button on the gear selector or, on  
the touch screen, select Driving / Vehicle > Full  
Park Assist.  
Choice of the type of  
manoeuvre and search for  
space  
Depending on whether the vehicle has been  
driven or not since the ignition was switched on,  
Once the vehicle has stopped, an instructions  
page is displayed on the screen.  
To prepare for the manoeuvre, you must fulfil  
all of these instructions.  
Activating the system deactivates Blind  
Spot Monitoring System.  
135  
Driving  
This symbol will be displayed  
automatically when the instruction has  
been applied.  
When all instructions have been validated, a  
new screen is displayed, indicating that you can  
undertake the manoeuvre.  
To undertake the manoeuvre, press  
this button.  
► While holding down the button, gradually  
release the brake pedal.  
Manoeuvre interrupted.  
an obstacle is detected, or by driver action. If the  
driver notices a hazard, they may also interrupt  
the manoeuvre permanently.  
To suspend the manoeuvre, the driver can:  
– Release the function control button.  
– Depress the brake pedal.  
– Resume control of the steering.  
– Change the gearbox status (except changing  
to P).  
The vehicle is immediately immobilised if the  
manoeuvre is suspended.  
This is confirmed by the display of this  
symbol, accompanied by the message  
"Manoeuvre suspended".  
Resuming the manoeuvre after resolving the  
conditions for suspending it:  
► Release all controls (brake pedal, function  
control button, steering wheel, etc.).  
► Press the function control button again.  
Permanent interruption after suspending the  
manoeuvre:  
Manoeuvre completed or abandoned  
(white arrows indicate that the driver must  
take back control of their vehicle).  
The direction of the manoeuvre is indicated by  
these symbols:  
Forward gear.  
Reverse gear.  
The button must be held down  
throughout the manoeuvre.  
The central arrow is green whilst the vehicle  
is moving, or white to indicate the next  
manoeuvring direction.  
The start of the manoeuvre is indicated by  
the display of a screen with the message  
"Manoeuvre under way", accompanied by an  
audible signal.  
Visiopark 1 and the parking sensors are  
automatically activated to help you monitor the  
immediate area around your vehicle during the  
manoeuvre.  
Throughout the whole manoeuvre,  
indicated by the green "AUTO" symbol,  
the driver must hold the selector button down.  
During manoeuvring phases, the steering  
wheel performs rapid turns: do not hold  
the steering wheel or put your hands between  
the spokes of the steering wheel. Watch out  
for any objects that could interfere with the  
manoeuvre (loose clothing, scarf, tie, etc.).  
Risk of injury!  
► Depress the brake pedal and engage a gear.  
Performing the manoeuvre  
Abandoning the manoeuvre  
As soon as the driver releases the brake  
pedal, the system automatically takes control  
of choosing the travel direction, forwards or  
reverse, acceleration, braking and the steering  
direction.  
The manoeuvre is abandoned in the following  
situations:  
– No action by the driver within 30 seconds of  
the manoeuvre being suspended.  
– Intentional application of the parking brake.  
– Gearbox mode P engaged by the driver.  
– Driver's seat belt unfastened.  
If the vehicle slows down significantly,  
the brake lamps may come on.  
The manoeuvring status is indicated by these  
symbols:  
Pausing/resuming the manoeuvre  
Manoeuvre in progress.  
– Opening of a door or the boot.  
The manoeuvre can be interrupted temporarily  
at any time, either automatically by the system if  
136  
Driving  
– The system may indicate that a space has  
been found but the manoeuvre will not be  
triggered because the width of the lane is  
insufficient.  
– The system is not designed to perform parking  
manoeuvres on a steep slope or on a sharp  
curve.  
– The system does not detect spaces that  
are much larger than the vehicle itself or that  
are delimited by obstacles that are too low  
(pavements, studs, etc.) or too thin (trees, posts,  
wire fences, etc.).  
– Activation of the direction indicator lamps on  
the opposite side to that of the manoeuvre.  
– In certain cases, when a wheel of the vehicle  
hits a pavement or a low obstacle.  
– Triggering of anti-slip regulation on a slippery  
road.  
End of manoeuvre  
6
The vehicle stops as soon as the manoeuvre is  
completed.  
This symbol is displayed, accompanied by  
the message "Manoeuvre completed" on  
the touch screen.  
When the function is deactivated, this  
indicator lamp on the instrument panel  
goes off and the original display is restored.  
– If entering a parking space, the driver may  
be required to complete the manoeuvre.  
The gearbox changes to P 4 seconds after  
completion of the manoeuvre.  
– When exiting a parking space, the gearbox  
changes to N when the manoeuvre is complete.  
A message and symbols prompt the driver to  
take back control of the vehicle.  
The gearbox automatically changes to mode  
P if no action is taken by the driver within 30  
secondss.  
– Engine stalling.  
– Sudden appearance in the field of the  
manoeuvre of an obstacle not detected by the  
system before the manoeuvre was started,  
with the obstacle remaining for more than 30  
seconds.  
– After 10 manoeuvres to enter or exit a  
"parallel" parking space and after 7 manoeuvres  
to enter a "bay" parking space,  
– System malfunction during the manoeuvre.  
Abandoning the manoeuvre immediately  
triggers the vehicle’s brakes and automatically  
deactivates the function.  
This symbol is displayed, accompanied by  
the message "Manoeuvre abandoned"  
on the touch screen.  
– The system may be impaired by incorrect  
inflation of the vehicle’s tyres.  
– The tilting of the vehicle if the boot is heavily  
loaded can affect the distance measurements.  
Do not use the function under the  
following exterior conditions:  
– Alongside a soft shoulder (ditch) or quay or  
on the edge of a drop.  
– When the road surface is slippery (ice).  
Operating limits  
A message prompts the driver to take back  
control of the vehicle.  
The function is deactivated after a few  
seconds; this indicator lamp goes off on  
the instrument panel and the initial display is  
resumed.  
– The system may suggest an inappropriate  
parking space (parking prohibited, work in  
progress with damaged road surface, location  
alongside a ditch, etc.).  
Do not use the function in the presence  
of one of the following malfunctions:  
– If a tyre is under-inflated.  
– If one of the bumpers is damaged.  
– If one of the cameras is faulty.  
– If the brake lamps are not working.  
– The system may indicate that a space has  
been found but will not offer it because of a fixed  
obstacle on the opposite side of the manoeuvre,  
which does not allow the vehicle to follow the  
trajectory required for parking.  
The system automatically engages gearbox  
mode P after 4 seconds.  
137  
Driving  
Do not use the function if the vehicle has  
been subject to one of the following  
modifications:  
– When carrying an object extending beyond  
the dimensions of the vehicle (ladder on the  
roof bars, bicycle carrier on the tailgate, etc.).  
– With a non-approved towball in place.  
– With snow chains fitted.  
In the event of a power steering  
malfunction, this warning lamp is  
displayed on the instrument panel, accompanied  
by a message.  
You must stop as soon as it is safe to do so.  
Contact a PEUGEOT dealer or a qualified  
workshop.  
– When driving on a small-diameter or  
"space-saver" type spare wheel.  
– When the wheels fitted are a different size  
from the original ones.  
– After modifying one or both bumpers  
(added protection).  
– If the sensors have been repainted outside  
the PEUGEOT dealer network.  
– With sensors not approved for the vehicle.  
Malfunctions  
When the function is not activated, the  
temporary flashing of this warning lamp  
and an audible signal indicate a Full Park Assist  
malfunction.  
If the malfunction occurs while the system is in  
use, the warning lamp goes off.  
If a parking sensor malfunction,  
indicated by one of these warning  
lamps coming on, occurs during Full Park Assist  
use, the function is deactivated.  
Contact a PEUGEOT dealer or a qualified  
workshop.  
138