Driving -> Manual parking brake for Your Peugeot 208 4 Door 2020

Driving  
appears in the instrument panel when closing a  
door or trying to switch off the engine.  
To confirm the instruction to switch off the  
engine, press the "START/STOP" button for  
approximately 5 seconds.  
In the event of a fault with the electronic key,  
contact a PEUGEOT dealer or a qualified  
workshop.  
When driving the vehicle, if this warning  
lamp and the STOP warning lamp come  
on, accompanied by an audible signal and the  
display of a message, this means that the  
parking brake is still applied or has not been fully  
released.  
Application  
► Pull the parking brake lever up to immobilise  
► Place and hold the remote control against the  
reader.  
Emergency switch-off  
In the event of an emergency only, the engine  
can be switched off without conditions (even  
when driving).  
► Press the "START/STOP" button for about  
5 seconds.  
In this case, the steering column locks as soon  
as the vehicle stops.  
the vehicle.  
With a manual gearbox, place the gear lever  
in neutral, then fully depress the clutch pedal.  
With an automatic gearbox or a drive  
selector, select mode P, then fully depress the  
brake pedal.  
When parking on a slope, turn the  
wheels against the kerb, apply the  
parking brake, engage a gear and switch off  
the ignition.  
► Press the "START/STOP" button.  
The engine starts.  
Electric parking brake  
In automatic mode, this system applies the  
parking brake when the engine is switched off  
and releases it when the vehicle moves off.  
Back-up switch-off  
Manual parking brake  
Release  
If the electronic key is not detected or is no  
longer in the recognition zone, a message  
► Pull the parking brake lever up slightly, press  
the release button, then lower the lever fully.  
At any time, with the engine running:  
► to apply the parking brake, briefly pull the  
control lever;  
90