Driving -> Starting / Switching off the engine with Keyless Entry and Starting for Your Peugeot 208 4 Door 2020

Driving  
To lock the steering column, turn the steering  
wheel until it locks.  
Key left in  
Starting  
When opening the driver's door, an alert  
message is displayed, accompanied by an  
audible signal, to remind you that the key is  
still in the ignition switch at position 1 (Stop).  
If the key has been left in the ignition switch  
at position 2 (Ignition on), the ignition will be  
switched off automatically after one hour.  
To switch the ignition back on, turn the key  
to position 1 (Stop), then back to position 2  
(Ignition on).  
To facilitate unlocking of the steering  
column, it is recommended that the  
wheels be returned to the straight ahead  
position before switching off the engine.  
Never switch off the ignition before the  
complete immobilisation of the vehicle.  
With the engine off, the braking and steering  
assistance systems are also cut off - risk of  
loss of control of the vehicle!  
► With a manual gearbox, place the gear lever  
in neutral and depress the clutch pedal fully.  
► With an automatic gearbox, select mode P  
or N and press the brake pedal.  
► Press the "START/STOP" button while  
maintaining pressure on the pedal until the  
engine starts.  
For Diesel engines, when the temperature is  
below zero and/or the engine is cold, starting  
will only occur once the preheater warning lamp  
is off.  
If this warning lamp comes on after  
pressing the "START/STOP" button:  
► Keep the pedal fully depressed and do not  
press the "START/STOP" button again until the  
engine is running.  
Starting / Switching off the  
engine with Keyless Entry  
and Starting  
Check that the parking brake is correctly  
applied, particularly on sloping ground.  
When leaving the vehicle, keep the key in  
your possession and lock the vehicle.  
The electronic key must be present in the  
passenger compartment.  
For versions equipped with Proximity Keyless  
Entry and Starting, the electronic key is also  
detected in the boot.  
If it is not detected, a message is displayed.  
Move the electronic key so that the engine  
can be started or switched off.  
If there is still a problem, refer to the "Key  
not detected - Back-up starting or Back-up  
switch-off" section.  
Energy economy mode  
After the engine has stopped (position 1. Stop),  
for a maximum combined duration of about thirty  
minutes, you can still use functions such as the  
audio and telematics system, courtesy lamps,  
windscreen wipers, dipped beam headlamps,  
etc.  
For more information on Energy  
economy mode, refer to the  
corresponding section.  
If one of the starting conditions is not met, a  
message is displayed.  
In some circumstances, a message indicates  
that it is necessary to turn the steering wheel  
88  
Driving  
while pressing the "START/STOP" button to  
assist unlocking of the steering column.  
Never leave your vehicle with the  
electronic key still inside.  
accompanied by the display of a warning  
message.  
6
With petrol engines, after a cold start,  
preheating the catalytic converter can  
cause noticeable engine vibrations for  
anything up to 2 minutes while stationary with  
the engine running (accelerated idle speed).  
Starting/Switching off the  
electric motor  
Starting  
Switching on the ignition  
without starting the engine  
The drive selector must be in mode P.  
► Fully depress the brake pedal and briefly  
press the "START/STOP" button.  
► Keep your foot on the brake pedal until the  
READY indicator lamp comes on and an audible  
signal is emitted, indicating that the vehicle is  
ready to drive.  
► With your foot on the brake, press the  
"Unlock" button and select mode D/B or R.  
► Release the brake pedal, then accelerate.  
On starting, the instrument panel lights up and  
the power indicator needle or cursor moves  
to the "neutral" position. The steering column  
automatically unlocks (you may hear a sound  
and feel the steering wheel move).  
If the engine stalls, release the clutch  
pedal and push it all the way down again,  
the engine will restart automatically.  
Switching off  
► Immobilise the vehicle, with the engine at  
idle.  
► With a manual gearbox, ideally put the gear  
lever into neutral.  
► With an automatic gearbox, ideally select  
mode P or N.  
► Press the "START/STOP" button..  
In some circumstances, it is necessary to turn  
the steering wheel to lock the steering column.  
With the electronic key in the passenger  
compartment, pressing the “START/STOP”  
button, without pressing any of the pedals,  
allows the ignition to be switched on without  
starting the engine.  
► Press this button again to switch off the  
ignition and allow the vehicle to be locked.  
Switching off  
If the vehicle is not immobilised, the  
engine will not switch off.  
► Press the "START/STOP" button.  
Before exiting the vehicle, check that:  
– The drive selector is in mode P.  
– The READY indicator lamp is off.  
Key not detected  
Back-up starting  
With the engine off, the braking and  
steering assistance systems are also cut  
off - risk of loss of control of the vehicle!  
A back-up reader is fitted to the steering column,  
to enable the engine to be started if the system  
fails to detect the key in the recognition zone, or  
if the battery in the electronic key is discharged.  
If the driver's door is opened while the  
required conditions for stopping are not  
satisfied, an audible signal is emitted,  
89  
Driving  
appears in the instrument panel when closing a  
door or trying to switch off the engine.  
To confirm the instruction to switch off the  
engine, press the "START/STOP" button for  
approximately 5 seconds.  
In the event of a fault with the electronic key,  
contact a PEUGEOT dealer or a qualified  
workshop.  
When driving the vehicle, if this warning  
lamp and the STOP warning lamp come  
on, accompanied by an audible signal and the  
display of a message, this means that the  
parking brake is still applied or has not been fully  
released.  
Application  
► Pull the parking brake lever up to immobilise  
► Place and hold the remote control against the  
reader.  
Emergency switch-off  
In the event of an emergency only, the engine  
can be switched off without conditions (even  
when driving).  
► Press the "START/STOP" button for about  
5 seconds.  
In this case, the steering column locks as soon  
as the vehicle stops.  
the vehicle.  
With a manual gearbox, place the gear lever  
in neutral, then fully depress the clutch pedal.  
With an automatic gearbox or a drive  
selector, select mode P, then fully depress the  
brake pedal.  
When parking on a slope, turn the  
wheels against the kerb, apply the  
parking brake, engage a gear and switch off  
the ignition.  
► Press the "START/STOP" button.  
The engine starts.  
Electric parking brake  
In automatic mode, this system applies the  
parking brake when the engine is switched off  
and releases it when the vehicle moves off.  
Back-up switch-off  
Manual parking brake  
Release  
If the electronic key is not detected or is no  
longer in the recognition zone, a message  
► Pull the parking brake lever up slightly, press  
the release button, then lower the lever fully.  
At any time, with the engine running:  
► to apply the parking brake, briefly pull the  
control lever;  
90